Influence of fat content on quality of cow's milk

The aim of the study was to verify whether changes in the percentage of fat in highly selected cows produce variations in the physical structure of the fat and changes in milk composition. Individual milk was sampled from 50 cows. Fat was evaluated in each individual in order to create two groups of animals with lower and higher percentage. The group with higher fat content showed a significantly larger diameter of the fat globules, less C14:0 and more C16:1. In conclusion the diameter variations observed result in few changes in milk fatty acid composition, thus maintaining a consistent nutritional quality

Genetic predisposition to ductal carcinoma in situ of the breast

Background: Ductal carcinoma in situ (DCIS) is a non-invasive form of breast cancer. It is often associated with invasive ductal carcinoma (IDC), and is considered to be a non-obligate precursor of IDC. It is not clear to what extent these two forms of cancer share low-risk susceptibility loci, or whether there are differences in the strength of association for shared loci. Methods: To identify genetic polymorphisms that predispose to DCIS, we pooled data from 38 studies comprising 5,067 cases of DCIS, 24,584 cases of IDC and 37,467 controls, all genotyped using the iCOGS chip. Results: Most (67 %) of the 76 known breast cancer predisposition loci showed an association with DCIS in the same direction as previously reported for invasive breast cancer. Case-only analysis showed no evidence for differences between associations for IDC and DCIS after considering multiple testing. Analysis by estrogen receptor (ER) status confirmed that loci associated with ER positive IDC were also associated with ER positive DCIS. Analysis of DCIS by grade suggested that two independent SNPs at 11q13.3 near CCND1 were specific to low/intermediate grade DCIS (rs75915166, rs554219). These associations with grade remained after adjusting for ER status and were also found in IDC. We found no novel DCIS-specific loci at a genome wide significance level of P < 5.0x10-8. Conclusion: In conclusion, this study provides the strongest evidence to date of a shared genetic susceptibility for IDC and DCIS. Studies with larger numbers of DCIS are needed to determine if IDC or DCIS specific loci exist

Genetic predisposition to ductal carcinoma in situ of the breast.

BACKGROUND: Ductal carcinoma in situ (DCIS) is a non-invasive form of breast cancer. It is often associated with invasive ductal carcinoma (IDC), and is considered to be a non-obligate precursor of IDC. It is not clear to what extent these two forms of cancer share low-risk susceptibility loci, or whether there are differences in the strength of association for shared loci. METHODS: To identify genetic polymorphisms that predispose to DCIS, we pooled data from 38 studies comprising 5,067 cases of DCIS, 24,584 cases of IDC and 37,467 controls, all genotyped using the iCOGS chip. RESULTS: Most (67 %) of the 76 known breast cancer predisposition loci showed an association with DCIS in the same direction as previously reported for invasive breast cancer. Case-only analysis showed no evidence for differences between associations for IDC and DCIS after considering multiple testing. Analysis by estrogen receptor (ER) status confirmed that loci associated with ER positive IDC were also associated with ER positive DCIS. Analysis of DCIS by grade suggested that two independent SNPs at 11q13.3 near CCND1 were specific to low/intermediate grade DCIS (rs75915166, rs554219). These associations with grade remained after adjusting for ER status and were also found in IDC. We found no novel DCIS-specific loci at a genome wide significance level of P < 5.0x10(-8). CONCLUSION: In conclusion, this study provides the strongest evidence to date of a shared genetic susceptibility for IDC and DCIS. Studies with larger numbers of DCIS are needed to determine if IDC or DCIS specific loci exist

Influence of cavosurface angle on the stress concentration and gaps formation in class V resin composite restorations

The study aimed to evaluate the influence of cavosurface angle on stress concentration and gap formation in class V restorations. Cylindrical cavities 3 mm in diameter were prepared in forty-five bovine incisors, changing only the angle of the bur in relation to the flat surface of the tooth. The cavities maintained the same volume (17.67 mm³). The samples were divided according to the cavosurface angle, into three groups (n = 15): 90°, 120°, 135°. After adhesive application (Futurabond U, VOCO), the cavity was filled with bulk placement of a resin composite (GrandioSO, VOCO). The teeth were analyzed with stereomicroscopy. Data of marginal gap formation were statistically analyzed with a one-way analysis of variance (ANOVA) followed by Tukey tests (significance level: α = 0.05). Finite element analysis (FEA) was used to study residual stress in these geometries and to correlate those stresses with experimentally measured gap formation. The elastic modulus and polymerization shrinkage were determined for FEA. Residual shrinkage stresses were expressed in maximum principal stress (MPS). There was a significant difference in the gap formation among the groups (p = 0.001). A significantly lower marginal gap formation was found for 120° and 135° angles, with no significant difference between them. The cavosurface angle at 90° caused substantially higher stresses, in the restoration interface, with greater marginal gap. For the 120° and 135° angles, the stress concentrations were smaller and were located in the dental structure. The cavosurface angle influenced the marginal gap formation and stress concentration

Polymerization shrinkage stresses in different restorative techniques for non-carious cervical lesions

Objective This study evaluated the effect of different restorative techniques for non-carious cervical lesions (NCCL) on polymerization shrinkage stress of resins using three-dimensional (3D) finite element analysis (FEA). Methods 3D-models of a maxillary premolar with a NCCL restored with different filling techniques (bulk filling and incremental) were generated to be compared by nonlinear FEA. The bulk filling technique was used for groups B (NCCL restored with Filtek™ Bulk Fill) and C (Filtek™ Z350 XT). The incremental technique was subdivided according to mode of application: P (2 parallel increments of the Filtek™ Z350 XT), OI (2 oblique increments of the Filtek™ Z350 XT, with incisal first), OIV (2 oblique increments of the Filtek™ Z350 XT, with incisal first and increments with the same volume), OG (2 oblique increments of the Filtek™ Z350 XT, with gingival first) and OGV (2 oblique increments of the Filtek™ Z350 XT, with gingival first and increments with the same volume), resulting in 7 models. All materials were considered isotropic, elastic and linear. The results were expressed in maximum principal stress (MPS). Results The tension stress distribution was influenced by the restorative technique. The lowest stress concentration occurred in group B followed by OG, OGV, OI, OIV, P and C; the incisal interface was more affected than the gingival. Conclusion The restoration of NCCLs with bulk fill composite resulted in lower shrinkage stress in the gingival and incisal areas, followed by incremental techniques with the initial increment placed on the gingival wall. Clinical significance The non-carious cervical lesions (NCCLs) restored with bulk fill composite have a more favorable biomechanical behavior

Retroperitoneal Castleman's tumor and paraneoplastic pemphigus: report of a case and review of the literature

BACKGROUND: Castleman's disease is a rare lymphoproliferative syndrome. Its etiology and pathogenesis are unclear. The disease can be occasionally associated with a paraneoplastic pemphigus (PNP), an autoimmune mucocutaneous disorder commonly seen in neoplasms of lymphocytic origin. CASE PRESENTATION: We present a case of a 63-year old male patient who was referred for surgical treatment of a lately diagnosed retroperitoneal pelvic mass. The patient had been already treated for two years due to progressive diffuse cutaneous lesions histologically consistent with lichen ruber verucosus and pemphigus vulgaris. Intraoperatively a highly vascularized solid mass occupying the small pelvis was resected after meticulous vascular ligation and hemostasis. After surgery and following immunosuppressive treatment a clear remission of the skin lesions was observed. CONCLUSION: Castleman's tumor should be always suspected when a retroperitoneal mass is combined with PNP. In a review of the literature we found 37 additional cases. Complete surgical resection of the tumor can be curative in most of the cases

Fuzzy rule-based system for evaluation of uncertainty transaction in cassava chain

A fuzzy ruled-based system was developed in this study and resulted in an index indicating the level of uncertainty related to commercial transactions between cassava growers and their dealers. The fuzzy system was developed based on Transaction Cost Economics approach. The fuzzy system was developed from input variables regarding information sharing between grower and dealer on &#8220;Demand/purchase Forecasting&#8221;, &#8220;Production Forecasting&#8221; and &#8220;Production Innovation&#8221;. The output variable is the level of uncertainty regarding the transaction between seller and buyer agent, which may serve as a system for detecting inefficiencies. Evidences from 27 cassava growers registered in the Regional Development Offices of Tupa and Assis, São Paulo, Brazil, and 48 of their dealers supported the development of the system. The mathematical model indicated that 55% of the growers present a Very High level of uncertainty, 33% present Medium or High. The others present Low or Very Low level of uncertainty. From the model, simulations of external interferences can be implemented in order to improve the degree of uncertainty and, thus, lower transaction costs