Performance of the CMS Cathode Strip Chambers with Cosmic Rays

The Cathode Strip Chambers (CSCs) constitute the primary muon tracking device in the CMS endcaps. Their performance has been evaluated using data taken during a cosmic ray run in fall 2008. Measured noise levels are low, with the number of noisy channels well below 1%. Coordinate resolution was measured for all types of chambers, and fall in the range 47 microns to 243 microns. The efficiencies for local charged track triggers, for hit and for segments reconstruction were measured, and are above 99%. The timing resolution per layer is approximately 5 ns

The effect of arm training on thermoregulatory responses and calf volume during upper body exercise

The final publication is available at Springer via https://doi.org/10.1007/s00421-014-2842-9.PURPOSE: The smaller muscle mass of the upper body compared to the lower body may elicit a smaller thermoregulatory stimulus during exercise and thus produce novel training-induced thermoregulatory adaptations. Therefore, the principal aim of the study was to examine the effect of arm training on thermoregulatory responses during submaximal exercise. METHODS: Thirteen healthy male participants (Mean ± SD age 27.8 ± 5.0 years, body mass 74.8 ± 9.5 kg) took part in 8 weeks of arm crank ergometry training. Thermoregulatory and calf blood flow responses were measured during 30 min of arm cranking at 60% peak power (W peak) pre-, and post-training and post-training at the same absolute intensity as pre-training. Core temperature and skin temperatures were measured, along with heat flow at the calf, thigh, upper arm and chest. Calf blood flow using venous occlusion plethysmography was performed pre- and post-exercise and calf volume was determined during exercise. RESULTS: The upper body training reduced aural temperature (0.1 ± 0.3 °C) and heat storage (0.3 ± 0.2 J g(-1)) at a given power output as a result of increased whole body sweating and heat flow. Arm crank training produced a smaller change in calf volume post-training at the same absolute exercise intensity (-1.2 ± 0.8% compared to -2.2 ± 0.9% pre-training; P < 0.05) suggesting reduced leg vasoconstriction. CONCLUSION: Training improved the main markers of aerobic fitness. However, the results of this study suggest arm crank training additionally elicits physiological responses specific to the lower body which may aid thermoregulation.Peer reviewedFinal Accepted Versio

Performance of CMS muon reconstruction in pp collision events at sqrt(s) = 7 TeV

The performance of muon reconstruction, identification, and triggering in CMS has been studied using 40 inverse picobarns of data collected in pp collisions at sqrt(s) = 7 TeV at the LHC in 2010. A few benchmark sets of selection criteria covering a wide range of physics analysis needs have been examined. For all considered selections, the efficiency to reconstruct and identify a muon with a transverse momentum pT larger than a few GeV is above 95% over the whole region of pseudorapidity covered by the CMS muon system, abs(eta) < 2.4, while the probability to misidentify a hadron as a muon is well below 1%. The efficiency to trigger on single muons with pT above a few GeV is higher than 90% over the full eta range, and typically substantially better. The overall momentum scale is measured to a precision of 0.2% with muons from Z decays. The transverse momentum resolution varies from 1% to 6% depending on pseudorapidity for muons with pT below 100 GeV and, using cosmic rays, it is shown to be better than 10% in the central region up to pT = 1 TeV. Observed distributions of all quantities are well reproduced by the Monte Carlo simulation.Comment: Replaced with published version. Added journal reference and DO

Performance of CMS muon reconstruction in pp collision events at sqrt(s) = 7 TeV

The performance of muon reconstruction, identification, and triggering in CMS has been studied using 40 inverse picobarns of data collected in pp collisions at sqrt(s) = 7 TeV at the LHC in 2010. A few benchmark sets of selection criteria covering a wide range of physics analysis needs have been examined. For all considered selections, the efficiency to reconstruct and identify a muon with a transverse momentum pT larger than a few GeV is above 95% over the whole region of pseudorapidity covered by the CMS muon system, abs(eta) < 2.4, while the probability to misidentify a hadron as a muon is well below 1%. The efficiency to trigger on single muons with pT above a few GeV is higher than 90% over the full eta range, and typically substantially better. The overall momentum scale is measured to a precision of 0.2% with muons from Z decays. The transverse momentum resolution varies from 1% to 6% depending on pseudorapidity for muons with pT below 100 GeV and, using cosmic rays, it is shown to be better than 10% in the central region up to pT = 1 TeV. Observed distributions of all quantities are well reproduced by the Monte Carlo simulation.Comment: Replaced with published version. Added journal reference and DO

Plastisol Foaming Process. Decomposition of the Foaming Agent, Polymer Behavior in the Corresponding Temperature Range and Resulting Foam Properties

The decomposition of azodicarbonamide, used as foaming agent in PVC - plasticizer (1/1) plastisols was studied by DSC. Nineteen different plasticizers, all belonging to the ester family, two being polymeric (polyadipates), were compared. The temperature of maximum decomposition rate (in anisothermal regime at 5 K min-1 scanning rate), ranges between 434 and 452 K. The heat of decomposition ranges between 8.7 and 12.5 J g -1. Some trends of variation of these parameters appear significant and are discussed in terms of solvent (matrix) and viscosity effects on the decomposition reactions. The shear modulus at 1 Hz frequency was determined at the temperature of maximum rate of foaming agent decomposition, and differs significantly from a sample to another. The foam density was determined at ambient temperature and the volume fraction of bubbles was used as criterion to judge the efficiency of the foaming process. The results reveal the existence of an optimal shear modulus of the order of 2 kPa that corresponds roughly to plasticizer molar masses of the order of 450 ± 50 g mol-1. Heavier plasticizers, especially polymeric ones are too difficult to deform. Lighter plasticizers such as diethyl phthalate (DEP) deform too easily and presumably facilitate bubble collapse

Study of hadronic event-shape variables in multijet final states in pp collisions at √s=7 TeV

Peer reviewe

Search for new physics in the multijet and missing transverse momentum final state in proton-proton collisions at √s=8 Tev

Peer reviewe

Measurement of Higgs boson production and properties in the WW decay channel with leptonic final states

Peer reviewe

Constraints on parton distribution functions and extraction of the strong coupling constant from the inclusive jet cross section in pp collisions at √s=7 TeV

Peer reviewe

Study of double parton scattering using W+2-jet events in proton-proton collisions at √s=7 TeV

Peer reviewe