Real-time monitoring of proton exchange membrane fuel cell stack failure

Uneven pressure drops in a 75-cell 9.5-kWe proton exchange membrane fuel cell stack with a U-shaped flow configuration have been shown to cause localised flooding. Condensed water then leads to localised cell heating, resulting in reduced membrane durability. Upon purging of the anode manifold, the resulting mechanical strain on the membrane can lead to the formation of a pin-hole/membrane crack and a rapid decrease in open circuit voltage due to gas crossover. This failure has the potential to cascade to neighbouring cells due to the bipolar plate coupling and the current density heterogeneities arising from the pin-hole/membrane crack. Reintroduction of hydrogen after failure results in cell voltage loss propagating from the pin-hole/membrane crack location due to reactant crossover from the anode to the cathode, given that the anode pressure is higher than the cathode pressure. Through these observations, it is recommended that purging is avoided when the onset of flooding is observed to prevent irreparable damage to the stack

The nature of the continuum limit in strongly coupled quenched QED

We review the results of large scale simulations of noncompact quenched $QED$ which use spectrum and Equation of State calculations to determine the theory's phase diagram, critical indices, and continuum limit. The resulting anomalous dimensions are in good agreement with Schwinger-Dyson solutions of the ladder graphs of conventional $QED$ and they satisfy the hyperscaling relations expected of a relativistic renormalizable field theory. The spectroscopy results satisfy the constraints of the Goldstone mechanism and PCAC, and may be indicative of Technicolor versions of the Standard Model which are strongly coupled at short distances.Comment: (talk given at the XXVI ICHEP, Dallas, TX, Aug 6-12 92), 6 pp., ILL-(TH)-92-#2

Electromechanical and Dynamic Characterization of In-House-Fabricated Amplified Piezo Actuator

A diamond-shaped amplified piezo actuator (APA) fabricated using six multilayered piezo stacks with maximum displacement of 173 μm at 175V and the amplification factor of 4.3. The dynamic characterization of the actuator was carried out at different frequencies (100 Hz–1 kHz) and at different AC voltages (20V–40V). The actuator response over this frequency range was found neat, without attenuation of the signal. Numerical modeling of multilayered stack actuator was carried out using empirical equations, and the electromechanical analysis was carried out using ABAQUS software. The block force of the APA was 81 N, calculated by electromechanical analysis. This is similar to that calculated by dynamic characterization method

In vivo precision of the GE Lunar iDXA for the measurement of visceral adipose tissue in adults: the influence of body mass index.

CoreScan is a new software for the GE Lunar iDXA, which provides a quantification of visceral adipose tissue (VAT). The objective of this study was to determine the in vivo precision of CoreScan for the measurement of VAT mass in a heterogeneous group of adults. Forty-five adults (aged 34.6 (8.6) years), ranging widely in body mass index (BMI 26.0 (5.2)  kg/m(2); 16.7-42.4 kg/m(2)), received two consecutive total body scans with repositioning. The sample was divided into two subgroups based on BMI, normal-weight and overweight/obese, for precision analyses. Subgroup analyses revealed that precision errors (RMSSD:%CV; root mean square standard deviation:% coefficient of variation) for VAT mass were 20.9 g:17.0% in the normal-weight group and 43.7 g:5.4% in overweight/obese groups. Our findings indicate that precision for DXA-VAT mass measurements increases with BMI, but caution should be used with %CV-derived precision error in normal BMI subjects.European Journal of Clinical Nutrition advance online publication, 15 October 2014; doi:10.1038/ejcn.2014.213

Changes over time in socioeconomic inequalities in breast and rectal cancer survival in England and Wales during a 32-year period (1973-2004): the potential role of health care.

BACKGROUND: Socioeconomic inequalities in cancer survival are well documented but they vary for different cancers and over time. Reasons for these differences are poorly understood. PATIENTS AND METHODS: For England and Wales, we examined trends in socioeconomic survival inequalities for breast cancer in women and rectal cancer in men during the 32-year period 1973-2004. We used a theoretical framework based on Victora's 'inverse equity' law, under which survival inequalities could change with the advent of successive new treatments, of varying effectiveness, which are disseminated with different speed among patients of different socioeconomic groups. We estimated 5-year relative survival for patients of different deprivation quintiles and examined trends in survival inequalities in light of major treatment innovations. RESULTS: Inequalities in breast cancer survival (921,611 cases) narrowed steadily during the study (from -10% to -6%). In contrast, inequalities in rectal cancer survival (187,104 cases) widened overall (form -5% to -11%) with fluctuating periods of narrowing inequality. CONCLUSIONS: Trends in socioeconomic differences in tumour or patient factors are unlikely explanations of observed changes over time in survival inequalities. The sequential introduction into clinical practice of new treatments of progressively smaller incremental benefit may partly explain the reduction in inequality in breast cancer survival

Local stability analysis and eigenvalue sensitivity of reacting bluff-body wakes

This paper presents an experimental and theoretical investigation of high-Reynolds-number low-density reacting wakes near a hydrodynamic Hopf bifurcation. This configuration is applicable to the wake flows that are commonly used to stabilize flames in high-velocity flows. First, an experimental study is conducted to measure the limit-cycle oscillation of this reacting bluff-body wake. The experiment is repeated while independently varying the bluff-body lip velocity and the density ratio across the flame. In all cases, the wake exhibits a sinuous oscillation. Linear stability analysis is performed on the measured time-averaged velocity and density fields. In the first stage of this analysis, a local spatiotemporal stability analysis is performed on the measured time-averaged velocity and density fields. The stability analysis results are compared to the experimental measurement and demonstrate that the local stability analysis correctly captures the influence of the lip-velocity and density-ratio parameters on the sinuous mode. In the second stage of the analysis, the linear direct and adjoint global modes are estimated by combining the local results. The sensitivity of the eigenvalue to changes in intrinsic feedback mechanisms is found by combining the direct and adjoint global modes. This is referred to as the eigenvalue sensitivity throughout the paper for reasons of brevity. The predicted global mode frequency is consistently within 10 % of the measured value, and the linear global mode shape closely resembles the measured nonlinear oscillations. The adjoint global mode reveals that the oscillation is strongly sensitive to open-loop forcing in the shear layers. The eigenvalue sensitivity identifies a wavemaker in the recirculation zone of the wake. A parametric study shows that these regions change little when the density ratio and lip velocity change. In the third stage of the analysis, the stability analysis is repeated for the varicose hydrodynamic mode. Although not physically observed in this unforced flow, the varicose mode can lock into longitudinal acoustic waves and cause thermoacoustic oscillations to occur. The paper shows that the local stability analysis successfully predicts the global hydrodynamic stability characteristics of this flow and shows that experimental data can be post-processed with this method in order to identify the wavemaker regions and the regions that are most sensitive to external forcing, for example from acoustic waves.Matthew Juniper acknowledges the financial support of the European Research Council under grant 2590620. Tim Lieuwen acknowledges the support of the University Turbine Systems Research (contract #DE-FC21-92MC29061) program under contract monitor Dr. Mark Freeman, and the Air Force Office of Scientific Research (contract #FA9550- 12-1-0107/RC657), under contract monitor Dr. Chiping Lee.This is the author accepted manuscript. The final version is available from Cambridge University Press via http://dx.doi.org/10.1017/jfm.2015.72

Water, oceanic fracture zones and the lubrication of subducting plate boundaries - insights from seismicity

We investigate the relationship between subduction processes and related seismicity for the Lesser Antilles Arc using the Gutenberg-Richter law. This power lawdescribes the earthquakemagnitude distribution, with the gradient of the cumulative magnitude distribution being commonly known as the b-value. The Lesser Antilles Arc was chosen because of its alongstrike variability in sediment subduction and the transition from subduction to strike-slip movement towards its northern and southern ends. The data are derived from the seismicity catalogues from the Seismic Research Centre of The University of the West Indies and the Observatoires Volcanologiques et Sismologiques of the Institut de Physique du Globe de Paris and consist of subcrustal events primarily from the slab interface. The b-value is found using a Kolmogorov-Smirnov test for a maximum-likelihood straight line-fitting routine. We investigate spatial variations in b-values using a grid-search with circular cells as well as an along-arc projection. Tests with different algorithms and the two independent earthquake cataloges provide confidence in the robustness of our results. We observe a strong spatial variability of the b-value that cannot be explained by the uncertainties. Rather than obtaining a simple north-south b-value distribution suggestive of the dominant control on earthquake triggering being water released from the sedimentary cover on the incoming American Plates, or a b-value distribution that correlates with on the obliquity of subduction, we obtain a series of discrete, high b-value 'bull's-eyes' along strike. These bull's-eyes, which indicate stress release through a higher fraction of small earthquakes, coincide with the locations of known incoming oceanic fracture zones on the American Plates. We interpret the results in terms of water being delivered to the Lesser Antilles subduction zone in the vicinity of fracture zones providing lubrication and thus changing the character of the related seismicity. Our results suggest serpentinization around mid-ocean ridge transform faults, which go on to become fracture zones on the incoming plate, plays a significant role in the delivery of water into the mantle at subduction zones

State-space realization of a describing function

The describing function is a powerful tool for characterizing nonlinear dynamical systems in the frequency domain. In some cases, it is the only available description of a nonlinear operator characterizing a certain subcomponent of the system. This paper presents a methodology to provide a state-space realization of one given describing function, in order to allow the study of the system in the time domain as well. The realization is based on Hammerstein models and Fourier–Bessel series. It can be embedded in time domain simulations of complex configurations with many nonlinear elements interacting, accurately describing the nonlinear saturation of the system. The technique is applied to an example application in the field of combustion instability, featuring self-excited thermoacoustic oscillations. We benchmark the performance of the tool comparing the results with a frequency domain analysis of the same system, obtaining good agreement between the two formulations.This work was supported by the European Research Council through project ALORS N.259620 and by the German Research Association for Combustion Engines (Forschungsvereinigung Verbrennungskraftmaschinen e.V. FVV).This is the accepted manuscript of a paper published in Nonlinear Dynamics (Ghirardo G, Ćosić B, Juniper MP, Moeck JP, Nonlinear Dynamics, 2015, doi:10.1007/s11071-015-2134-x). The final version is available at http://dx.doi.org/10.1007/s11071-015-2134-

The structural sensitivity of open shear flows calculated with a local stability analysis

The structural sensitivity shows where an instability of a fluid flow is most sensitive to changes in internal feedback mechanisms. It is formed from the overlap of the flow's direct and adjoint global modes. These global modes are usually calculated with 2D or 3D global stability analyses, which can be very computationally expensive. For weakly non-parallel flows the direct global mode can also be calculated with a local stability analysis, which is orders of magnitude cheaper. In this theoretical paper we show that, if the direct global mode has been calculated with a local analysis, then the adjoint global mode follows at little extra cost. We also show that the maximum of the structural sensitivity is the location at which the local k+ and k- branches have the same imaginary value. Finally, we use the local analysis to derive the structural sensitivity of two flows: a confined co-flow wake at Re = 400, for which it works very well, and the flow behind a cylinder at Re = 50, for which it works reasonably well. As expected, we find that the local analysis becomes less accurate when the flow becomes less parallel.This is the preprint version of the manuscript as submitted to the journal. The final version will be published by Elsevier