3,015 research outputs found

    Low NO sub x heavy fuel combustor concept program phase 1A gas tests

    Get PDF
    The emissions performance of a rich lean combustor (developed for liquid fuels) for combustion of simulated coal gases ranging in heating value from 167 to 244 Btu/scf were assessed. The 244 Btu/scf gas is typical of the product gas from an oxygen blown gasifier, while the 167 Btu/scf gas is similar to that from an air blown gasifier. Although meeting NOx goals for the 167 Btu/scf gas, NOx performance of the rich lean combustor did not meet program goals with the 244 Btu/scf gas because of high thermal NOx, similar to levels expected from conventional lean burning combustors. The NOx emissions are attributed to inadequate fuel air mixing in the rich stage resulting from the design of the large central fuel nozzle delivering 71% of the total gas flow. NOx generation from NH3 was significant at ammonia concentrations significantly less tha 0.5%. These levels occur depending on fuel gas cleanup system design, However, NOx yield from ammonia injected into the fuel gas decreased rapidly with increasing ammonia level, and is projected to be less than 10% at NH3 levels of 0.5% or higher

    Real-world comparison of probe vehicle emissions and fuel consumption using diesel and 5 % biodiesel (B5) blend.

    Get PDF
    An instrumented EURO I Ford Mondeo was used to perform a real-world comparison of vehicle exhaust (carbon dioxide, carbon monoxide, hydrocarbons and oxides of nitrogen) emissions and fuel consumption for diesel and 5% biodiesel in diesel blend (B5) fuels. Data were collected on multiple replicates of three standardised on-road journeys: (1) A simple urban route; (2) A combined urban/inter-urban route; and, (3) An urban route subject to significant traffic management. At the total journey measurement level, data collected here indicate that replacing diesel with a B5 substitute could result in significant increases in both NOx emissions (8-13%) and fuel consumption (7-8%). However, statistical analysis of probe vehicle data demonstrated the limitations of comparisons based on such total journey measurements, i.e., methods analogous to those used in conventional dynamometer/drive cycle fuel comparison studies. Here, methods based on the comparison of speed/acceleration emissions and fuel consumption maps are presented. Significant variations across the speed/acceleration surface indicated that direct emission and fuel consumption impacts were highly dependent on the journey/drive cycle employed. The emission and fuel consumption maps were used both as descriptive tools to characterise impacts and predictive tools to estimate journey-specific emission and fuel consumption effects

    On a suspected ring external to the visible rings of Saturn

    Get PDF
    The reexamination of a photograph of Saturn taken on 15 November 1966 when the earth was nearly in the ring plane is investigated which indicates that ring material does exist outside the visible rings, extending to more than 6 Saturnian radii. The observed brightness in blue light was estimated per linear arc second, implying a normal optical thickness, for ice-covered particles

    Timing of androgen deprivation therapy use and fracture risk among elderly men with prostate cancer in the United States

    Full text link
    Purpose Fractures are a recognized consequence of androgen deprivation therapy (ADT); however, less is known about the incidence of fracture in relation to the timing of ADT use or the impact of fracture on mortality in men with prostate cancer. Methods Using data from the Surveillance, Epidemiology, and End Results–Medicare linked database, we estimated adjusted hazard ratios (aHRs) using time‐dependent Cox regression for fracture incidence related to the recency of exposure and dose among prostate cancer patients on gonadotropin‐releasing hormone (GnRH) agonists, as well as mortality associated with fractures. Results In our cohort of 80 844 patients, ADT was associated with an increased rate of fracture in both non‐metastatic patients (aHR = 1.34; 95% confidence interval [CI] = 1.29–1.39) and metastatic patients (aHR = 1.51; 95%CI = 1.36–1.67). Fracture rates increased with increasing cumulative GnRH dose but decreased with increasing number of months since last use in each dose category. The mortality rate doubled for men experiencing a fracture after their diagnosis compared with that for men who did not experience a fracture (aHR = 2.05; 95%CI = 1.98–2.12). Conclusions ADT in elderly men with prostate cancer increased the incidence of fractures, and the effect appears to diminish with increasing time since the last dose of a GnRH agonist. Experiencing a fracture after the diagnosis of prostate cancer was associated with decreased survival. Copyright © 2011 John Wiley & Sons, Ltd.Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/90397/1/pds2258.pd

    Efficiency of Energy Conversion in Thermoelectric Nanojunctions

    Full text link
    Using first-principles approaches, this study investigated the efficiency of energy conversion in nanojunctions, described by the thermoelectric figure of merit ZTZT. We obtained the qualitative and quantitative descriptions for the dependence of ZTZT on temperatures and lengths. A characteristic temperature: T0=β/γ(l)T_{0}= \sqrt{\beta/\gamma(l)} was observed. When TT0T\ll T_{0}, ZTT2ZT\propto T^{2}. When TT0T\gg T_{0}, ZTZT tends to a saturation value. The dependence of ZTZT on the wire length for the metallic atomic chains is opposite to that for the insulating molecules: for aluminum atomic (conducting) wires, the saturation value of ZTZT increases as the length increases; while for alkanethiol (insulating) chains, the saturation value of ZTZT decreases as the length increases. ZTZT can also be enhanced by choosing low-elasticity bridging materials or creating poor thermal contacts in nanojunctions. The results of this study may be of interest to research attempting to increase the efficiency of energy conversion in nano thermoelectric devices.Comment: 2 figure

    Transition Between Ground State and Metastable States in Classical 2D Atoms

    Full text link
    Structural and static properties of a classical two-dimensional (2D) system consisting of a finite number of charged particles which are laterally confined by a parabolic potential are investigated by Monte Carlo (MC) simulations and the Newton optimization technique. This system is the classical analog of the well-known quantum dot problem. The energies and configurations of the ground and all metastable states are obtained. In order to investigate the barriers and the transitions between the ground and all metastable states we first locate the saddle points between them, then by walking downhill from the saddle point to the different minima, we find the path in configurational space from the ground state to the metastable states, from which the geometric properties of the energy landscape are obtained. The sensitivity of the ground-state configuration on the functional form of the inter-particle interaction and on the confinement potential is also investigated

    Tracking magnetic bright point motions through the solar atmosphere

    Get PDF
    High-cadence, multiwavelength observations and simulations are employed for the analysis of solar photospheric magnetic bright points (MBPs) in the quiet Sun. The observations were obtained with the Rapid Oscillations in the Solar Atmosphere (ROSA) imager and the Interferometric Bidimensional Spectrometer at the Dunn Solar Telescope. Our analysis reveals that photospheric MBPs have an average transverse velocity of approximately 1 km s−1, whereas their chromospheric counterparts have a slightly higher average velocity of 1.4 km s−1. Additionally, chromospheric MBPs were found to be around 63 per cent larger than the equivalent photospheric MBPs. These velocity values were compared with the output of numerical simulations generated using the MURAM code. The simulated results were similar, but slightly elevated, when compared to the observed data. An average velocity of 1.3 km s−1 was found in the simulated G-band images and an average of 1.8 km s−1 seen in the velocity domain at a height of 500 km above the continuum formation layer. Delays in the change of velocities were also analysed. Average delays of ∼4 s between layers of the simulated data set were established and values of ∼29 s observed between G-band and Ca II K ROSA observations. The delays in the simulations are likely to be the result of oblique granular shock waves, whereas those found in the observations are possibly the result of a semi-rigid flux tube

    Comparative Network Analysis of Preterm vs. Full-Term Infant-Mother Interactions

    Get PDF
    Several studies have reported that interactions of mothers with preterm infants show differential characteristics compared to that of mothers with full-term infants. Interaction of preterm dyads is often reported as less harmonious. However, observations and explanations concerning the underlying mechanisms are inconsistent. In this work 30 preterm and 42 full-term mother-infant dyads were observed at one year of age. Free play interactions were videotaped and coded using a micro-analytic coding system. The video records were coded at one second resolution and studied by a novel approach using network analysis tools. The advantage of our approach is that it reveals the patterns of behavioral transitions in the interactions. We found that the most frequent behavioral transitions are the same in the two groups. However, we have identified several high and lower frequency transitions which occur significantly more often in the preterm or full-term group. Our analysis also suggests that the variability of behavioral transitions is significantly higher in the preterm group. This higher variability is mostly resulted from the diversity of transitions involving non-harmonious behaviors. We have identified a maladaptive pattern in the maternal behavior in the preterm group, involving intrusiveness and disengagement. Application of the approach reported in this paper to longitudinal data could elucidate whether these maladaptive maternal behavioral changes place the infant at risk for later emotional, cognitive and behavioral disturbance

    A Dual TLR Agonist Adjuvant Enhances the Immunogenicity and Protective Efficacy of the Tuberculosis Vaccine Antigen ID93

    Get PDF
    With over eight million cases of tuberculosis each year there is a pressing need for the development of new vaccines against Mycobacterium tuberculosis. Subunit vaccines consisting of recombinant proteins are an attractive vaccine approach due to their inherent safety compared to attenuated live vaccines and the uniformity of manufacture. Addition of properly formulated TLR agonist-containing adjuvants to recombinant protein vaccines enhances the antigen-specific CD4+ T cell response characterized by IFN-γ and TNF, both of which are critical for the control of TB. We have developed a clinical stage vaccine candidate consisting of a recombinant fusion protein ID93 adjuvanted with the TLR4 agonist GLA-SE. Here we examine whether ID93+GLA-SE can be improved by the addition of a second TLR agonist. Addition of CpG containing DNA to ID93+GLA-SE enhanced the magnitude of the multi-functional TH1 response against ID93 characterized by co-production of IFN-γ, TNF, and IL-2. Addition of CpG also improved the protective efficacy of ID93+GLA-SE. Finally we demonstrate that this adjuvant synergy between GLA and CpG is independent of TRIF signaling, whereas TRIF is necessary for the adjuvant activity of GLA-SE in the absence of CpG
    corecore