Membranes fabricated with a deep single corrugation for package stress reduction and residual stress relief

Thin square membranes including a deep circular corrugation are realized and tested for application in a strain-based pressure sensor. Package-induced stresses are reduced and relief of the residual stress is obtained, resulting in a large pressure sensitivity and a reduced temperature sensitivity. Finite element method simulations were carried out, showing that the pressure-deflection behaviour of the structure is close to that of a circular membrane with clamped edge but free radial motion

The mineralization of commercial organic fertilizers at 8°C temperature

In organic production only organic fertilizers and soil conditioners can be used to supply the soil with nitrogen. The mineralization of these products is slow and so there can be problems with the supply of nitrogen, when the demand of the plants is high. The supply of nitrogen from organic products depends on the speed of their mineralization which is primarily influenced by the composition and formulation of their raw material. In apple production in the Alps-region especially during spring problems with nitrogen supply are common. In that period, the weather conditions are sometimes bad, the temperature in the soil is low and mineralization starts slowly - apple trees demand more nitrogen than the soil can deliver. To compensate the demand of the apple tree organic growers can not use mineral fertilizers but only organic fertilizers and soil conditioners whose mineralization rate is often unknown. There is a strong need in organic fruit production to receive more information about the behaviour of fertilizers in the soil especially concerning their N-release under different conditions. To acquire that information, incubation experiments under controlled conditions (temperature, type of soil, humidity of the soil) were carried out in the laboratory to determine the mineralization-rate of different organic fertilizers and soil conditioners which are available in our region

Direct comparison of the performance of CZT detectors contacted with various metals

Cadmium Zinc Telluride (CZT) achieves excellent spatial resolution and good energy resolution over the broad energy range from several keV into the MeV energy range. In this paper we present the results of a systematic study of the performance of CZT detectors manufacturered by Orbotech (before IMARAD) depending on surface preparation, contact materials and contact deposition. The standard Orbotech detectors have the dimension of 2.0 x 2.0 x 0.5 cm. They have a pixellated In anode with 8 x 8 pixels and a monolithic In cathode. Using the same CZT substrates several times, we have made a direct comparison of the performance of different contact materials by replacing the cathode and/or the anode contacts with several high-workfunction metals. We present the performance of the detectors and conclude with an overview over our ongoing detector optimization.Comment: 8 pages, 5 figures, to appear in the proceedings of the conference 5922, "Hard X-Ray and Gamma-Ray Detector Physics VII" on the "Optics & Photonics 2005" SPIE Symposium, July 31- August 4, 2005, San Diego, C

Importance of appropriate selection environments for breeding maize adapted to organic farming systems

Organic farming systems, characterized by special attention to soil fertility, recycling techniques and low external inputs, gained increased significance in recent years. As a consequence, there is a growing demand for varieties adapted to organic and/or low input farming. The objectives of the present study were to (i) compare the testcross performance of segregating maize (Zea mays) populations under established organic (OF) and conventional farming (CF) systems, (ii) determine quantitative genetic parameters decisive for the selection response under OF vs CF conditions, and (iii) draw conclusions for breeding new varieties optimally adapted to OF. Testcross performance of four different material groups of preselected lines (90 lines per group) derived from early European breeding material was assessed under OF and CF in three different geographic regions in Germany in 2008. Grain yields under OF were 3 to 18% lower than under CF in the individual experiments depending on the test region and, to a lesser extent, on the genetic material. On average, grain dry matter yield under OF was 1077 g m-2 compared to 1186 g m-2 under CF. Phenotypic correlations between OF and CF were small or moderate for grain yield in each of the four material groups (0.22 to 0.45), while strong and highly significant correlations were found for dry matter content (0.89 to 0.94). Genotypes with top grain yields under OF often did not show this superiority under CF and vice versa. Despite considerable heterogeneity of the OF test sites, the heritability for grain yield was in the same order of magnitude under OF and CF. It is concluded that test sites managed by OF are indispensable for making maximum progress in developing maize varieties for these conditions

Notes on drift theory

It is shown that there is a simpler way to derive the average guiding center drift of a distribution of particles than via the so-called single particle analysis. Based on this derivation it is shown that the entire drift formalism can be considerably simplified, and that results for low order anisotropies are more generally valid than is usually appreciated. This drift analysis leads to a natural alternative derivation of the drift velocity along a neutral sheet

The South African Phillips Curve: How Applicable is the Gordon Model?

Is there a Phillips curve relationship present in South Africa and if so, what form does it take? Traditionally the way to estimate the Phillips curve is merely to regress the change in the price level on a measure of the output gap (or the deviation of actual unemployment from the NAIRU). However, Gordon (1990:481-5) has argued that estimating the Phillips curve in this manner biases the estimated results. Instead, Gordon (1997; 1989) puts forward his so-called triangular model that controls for inertia effects, output level effects and rates-of-change (in output) effects. He applies the model to several European countries, the US and Japan and finds meaningful results. The question this paper poses is whether or not the triangular model also applies to South Africa. In estimating the Phillips curve for South Africa the paper also experiments with four versions of the output gap, based on four different methods to estimate long run output, including the standard Hodrick-Prescott (HP) filter and the production function approach. There are several variants of the Phillips curve. The first, as estimated by Phillips (1958) himself, measures the relationship between wage inflation and unemployment. However, other versions consider the relationship between price inflation and unemployment or price inflation and output. This paper focuses on the latter, given the absence of quarterly unemployment data in South Africa, as well as the lack of a reliable and sufficiently long unemployment time series. The paper first presents an overview of literature on the Phillips curve and its estimation for South Africa and other countries. This is followed by the second section that considers the model to be estimated, the data as well as the discussion of the alternative measures of the output gap. The third section presents the estimated results followed by section four that contains the conclusion and a discussion of the policy implications.