12,060 research outputs found
Development of polymer network of phenolic and epoxies resins mixed with linseed oil: pilot study
Epoxy resin was mixed with phenolic resins in different percentages by weight. Composite 40/60 means the proportion by weight of epoxy resin is 40 percent. It was found that only composites 50/50 and 40/60 could be cured in ambient conditions. Dynamic mechanical analysis showed that only these two composites form interpenetrating polymer network. The addition of linseed oil to the two resins results also in the formation of interpenetrating network irrespective of proportion by weight of the resins; the mechanical properties will only be better when the percentage by weight of epoxy resin is higher; the aim of reducing cost and at the same time maintaining the mechanical properties cannot be fully achieved because epoxy resin is much more expensive than its counterpart
Pulsed THz radiation due to phonon-polariton effect in [110] ZnTe crystal
Pulsed terahertz (THz) radiation, generated through optical rectification
(OR) by exciting [110] ZnTe crystal with ultrafast optical pulses, typically
consists of only a few cycles of electromagnetic field oscillations with a
duration about a couple of picoseconds. However, it is possible, under
appropriate conditions, to generate a long damped oscillation tail (LDOT)
following the main cycles. The LDOT can last tens of picoseconds and its
Fourier transform shows a higher and narrower frequency peak than that of the
main pulse. We have demonstrated that the generation of the LDOT depends on
both the duration of the optical pulse and its central wavelength. Furthermore,
we have also performed theoretical calculations based upon the OR effect
coupled with the phonon-polariton mode of ZnTe and obtained theoretical THz
waveforms in good agreement with our experimental observation.Comment: 9 pages, 5 figure
Anomalous physical properties of underdoped weak-ferromagnetic superconductor RuSrEuCuO
Similar to the optimal-doped, weak-ferromagnetic (WFM induced by canted
antiferromagnetism, T = 131 K) and superconducting (T = 56 K)
RuSrGdCuO, the underdoped RuSrEuCuO
(T = 133 K, T = 36 K) also exhibited a spontaneous vortex state
(SVS) between 16 K and 36 K. The low field (20 G) superconducting
hysteresis loop indicates a weak and narrow Meissner state region of average
lower critical field B(T) = B(0)[1 -
(T/T)], with B(0) = 7 G and T = 16 K. The
vortex melting transition (T = 21 K) below T obtained from
the broad resistivity drop and the onset of diamagnetic signal indicates a
vortex liquid region due to the coexistence and interplay between
superconductivity and WFM order. No visible jump in specific heat was observed
near T for Eu- and Gd-compound. This is not surprising, since the
electronic specific heat is easily overshadowed by the large phonon and
weak-ferromagnetic contributions. Furthermore, a broad resistivity transition
due to low vortex melting temperature would also lead to a correspondingly
reduced height of any specific heat jump. Finally, with the baseline from the
nonmagnetic Eu-compound, specific heat data analysis confirms the magnetic
entropy associated with antiferromagnetic ordering of Gd (J = S = 7/2)
at 2.5 K to be close to ln8 as expected.Comment: 7 figure
Dynamical Linear Response of TDDFT with LDA+U Functional: strongly hybridized Frenkel excitons in NiO
Within the framework of time-dependent density-functional theory (TDDFT), we
derive the dynamical linear response of LDA+U functional and benchmark it on
NiO, a prototypical Mott insulator. Formulated using real-space Wannier
functions, our computationally inexpensive framework gives detailed insights
into the formation of tightly bound Frenkel excitons with reasonable accuracy.
Specifically, a strong hybridization of multiple excitons is found to
significantly modify the exciton properties. Furthermore, our study exposes a
significant generic limitation of adiabatic approximation in TDDFT with hybrid
functionals and in existing Bethe-Salpeter-equation approaches, advocating the
necessity of strongly energy-dependent kernels in future development.Comment: 5 pages, 2 figure
- …
