Lord of the Mood Rings

Our main objective is to study the mechanisms by which heat transfer taking place in the human finger will affect the color change in the mood ring. This project uses GAMBIT and FIDAP to model the heat transfer from the finger to the ring. Finding the possible range of heat generations, one can estimate the temperature range of the surface and thus the best type of LC to be used in a ring. By determining the temperature in the ring at steady state the blood flow rate can be quantified, which will provide the required heat generation to change the mood ring to any desired color. We obtained several Q?s ranging from 6800 to 7200 W/m^3 appropriate to blood flow rate, and ambient conditions with no forced convection for the model. Further sensitivity analysis was done for selected data input, such as conductivity and source term, to assess their impact on the results. It was concluded that blood flow rate corresponding to the heat generation values used ranged from 0.245 to 0.265 cm^3/min. From the results it is recommended that the color change in the LCD crystal should be most sensitive over the range of 32 to 35 ?C

Ferromagnetic properties of Zn1-xMnxO epitaxial thin films

We report on ferromagnetic characteristics of Zn1-xMnxO (x=0.1 and 0.3) thin films grown on Al2O3(00.1) substrates using laser molecular-beam epitaxy. By increasing the Mn content, the films exhibited increases in both the c-axis lattice constant and fundamental band gap energy. The Curie temperature obtained from temperature-dependent magnetization curves was 45 K for the film with x=0.3, depending on the Mn composition in the films. The remanent magnetization and coercive field of Zn0.9Mn0.1O at 5 K were 0.9 emu/g and 300 Oe, respectively. For Zn0.7Mn0.3O, the remanent magnetization at 5 K increased to 3.4 emu/g. (C) 2002 American Institute of Physics.open11509532sciescopu

Design, analysis, tools and applications for programmable high-speed and power-aware 4G processors

Data rate traffic and communication capacity demand have been increased continuously. Therefore, a highly advanced 4G wireless system is required to meet a high demand for modern mobile terminals. For getting a further improvement for 4G communication systems, new paradigms of design, analysis tools and applications for 4G communication processors are necessary. In this paper, some of these new paradigms are discussed. Furthermore, a single-step discrete cosine transform truncation (DCTT) method is proposed for the modeling-simulation in signal integrity verification for high-speed communication processors. ©2011 IEEE.published_or_final_versio

Plasmonic excitations in noble metals: The case of Ag

The delicate interplay between plasmonic excitations and interband transitions in noble metals is described by means of {\it ab initio} calculations and a simple model in which the conduction electron plasmon is coupled to the continuum of electron-hole pairs. Band structure effects, specially the energy at which the excitation of the $d$-like bands takes place, determine the existence of a subthreshold plasmonic mode, which manifests itself in Ag as a sharp resonance at 3.8 eV. However, such a resonance is not observed in the other noble metals. Here, this different behavior is also analyzed and an explanation is provided.Comment: 9 pages, 8 figure

Measurement of the inclusive and dijet cross-sections of b-jets in pp collisions at sqrt(s) = 7 TeV with the ATLAS detector

The inclusive and dijet production cross-sections have been measured for jets containing b-hadrons (b-jets) in proton-proton collisions at a centre-of-mass energy of sqrt(s) = 7 TeV, using the ATLAS detector at the LHC. The measurements use data corresponding to an integrated luminosity of 34 pb^-1. The b-jets are identified using either a lifetime-based method, where secondary decay vertices of b-hadrons in jets are reconstructed using information from the tracking detectors, or a muon-based method where the presence of a muon is used to identify semileptonic decays of b-hadrons inside jets. The inclusive b-jet cross-section is measured as a function of transverse momentum in the range 20 < pT < 400 GeV and rapidity in the range |y| < 2.1. The bbbar-dijet cross-section is measured as a function of the dijet invariant mass in the range 110 < m_jj < 760 GeV, the azimuthal angle difference between the two jets and the angular variable chi in two dijet mass regions. The results are compared with next-to-leading-order QCD predictions. Good agreement is observed between the measured cross-sections and the predictions obtained using POWHEG + Pythia. MC@NLO + Herwig shows good agreement with the measured bbbar-dijet cross-section. However, it does not reproduce the measured inclusive cross-section well, particularly for central b-jets with large transverse momenta.Comment: 10 pages plus author list (21 pages total), 8 figures, 1 table, final version published in European Physical Journal

Treatment-Resistant Schizophrenia: Treatment Response and Resistance in Psychosis (TRRIP) Working Group Consensus Guidelines on Diagnosis and Terminology

OBJECTIVE: Research and clinical translation in schizophrenia is limited by inconsistent definitions of treatment resistance and response. To address this issue, the authors evaluated current approaches and then developed consensus criteria and guidelines. METHODS: A systematic review of randomized antipsychotic clinical trials in treatment-resistant schizophrenia was performed, and definitions of treatment resistance were extracted. Subsequently, consensus operationalized criteria were developed through 1) a multiphase, mixed methods approach, 2) identification of key criteria via an online survey, and 3) meetings to achieve consensus. RESULTS: Of 2,808 studies identified, 42 met inclusion criteria. Of these, 21 studies (50%) did not provide operationalized criteria. In the remaining studies, criteria varied considerably, particularly regarding symptom severity, prior treatment duration, and antipsychotic dosage thresholds; only two studies (5%) utilized the same criteria. The consensus group identified minimum and optimal criteria, employing the following principles: 1) current symptoms of a minimum duration and severity determined by a standardized rating scale; 2) moderate or worse functional impairment; 3) prior treatment consisting of at least two different antipsychotic trials, each for a minimum duration and dosage; 4) systematic monitoring of adherence and meeting of minimum adherence criteria; 5) ideally at least one prospective treatment trial; and 6) criteria that clearly separate responsive from treatment-resistant patients. CONCLUSIONS: There is considerable variation in current approaches to defining treatment resistance in schizophrenia. The authors present consensus guidelines that operationalize criteria for determining and reporting treatment resistance, adequate treatment, and treatment response, providing a benchmark for research and clinical translation

A Search for Dark Higgs Bosons

Recent astrophysical and terrestrial experiments have motivated the proposal of a dark sector with GeV-scale gauge boson force carriers and new Higgs bosons. We present a search for a dark Higgs boson using 516 fb-1 of data collected with the BABAR detector. We do not observe a significant signal and we set 90% confidence level upper limits on the product of the Standard Model-dark sector mixing angle and the dark sector coupling constant.Comment: 7 pages, 5 postscript figures, published version with improved plots for b/w printin

Aerosols in the Pre-industrial Atmosphere

Purpose of Review: We assess the current understanding of the state and behaviour of aerosols under pre-industrial conditions and the importance for climate. Recent Findings: Studies show that the magnitude of anthropogenic aerosol radiative forcing over the industrial period calculated by climate models is strongly affected by the abundance and properties of aerosols in the pre-industrial atmosphere. The low concentration of aerosol particles under relatively pristine conditions means that global mean cloud albedo may have been twice as sensitive to changes in natural aerosol emissions under pre-industrial conditions compared to present-day conditions. Consequently, the discovery of new aerosol formation processes and revisions to aerosol emissions have large effects on simulated historical aerosol radiative forcing. Summary: We review what is known about the microphysical, chemical, and radiative properties of aerosols in the pre-industrial atmosphere and the processes that control them. Aerosol properties were controlled by a combination of natural emissions, modification of the natural emissions by human activities such as land-use change, and anthropogenic emissions from biofuel combustion and early industrial processes. Although aerosol concentrations were lower in the pre-industrial atmosphere than today, model simulations show that relatively high aerosol concentrations could have been maintained over continental regions due to biogenically controlled new particle formation and wildfires. Despite the importance of pre-industrial aerosols for historical climate change, the relevant processes and emissions are given relatively little consideration in climate models, and there have been very few attempts to evaluate them. Consequently, we have very low confidence in the ability of models to simulate the aerosol conditions that form the baseline for historical climate simulations. Nevertheless, it is clear that the 1850s should be regarded as an early industrial reference period, and the aerosol forcing calculated from this period is smaller than the forcing since 1750. Improvements in historical reconstructions of natural and early anthropogenic emissions, exploitation of new Earth system models, and a deeper understanding and evaluation of the controlling processes are key aspects to reducing uncertainties in future

Systematic review of methods used in meta-analyses where a primary outcome is an adverse or unintended event

addresses: Peninsula College of Medicine and Dentistry, St Luke's Campus, University of Exeter, Exeter, UK. [email protected]: PMCID: PMC3528446types: Journal Article; Research Support, Non-U.S. Gov't© 2012 Warren et al.; licensee BioMed Central Ltd. This is an Open Access article distributed under the terms of the Creative Commons Attribution License ( http://creativecommons.org/licenses/by/2.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.Adverse consequences of medical interventions are a source of concern, but clinical trials may lack power to detect elevated rates of such events, while observational studies have inherent limitations. Meta-analysis allows the combination of individual studies, which can increase power and provide stronger evidence relating to adverse events. However, meta-analysis of adverse events has associated methodological challenges. The aim of this study was to systematically identify and review the methodology used in meta-analyses where a primary outcome is an adverse or unintended event, following a therapeutic intervention