A review of the epidemiology of oral and pharyngeal carcinoma: update

Oral and pharyngeal cancers are the sixth most common cancers internationally. In the United States, there are about 30,000 new cases of oral and pharyngeal cancers diagnosed each year. Furthermore, survival rates for oral and pharyngeal cancers have not significantly improved over the last three decades. This review examines the scientific literature surrounding the epidemiology of oral and pharyngeal cancers, including but not limited to risk factors, disparities, preventative factors, and the epidemiology in countries outside the United States. The literature review revealed that much of the research in this field has been focused on alcohol, tobacco, and their combined effects on oral and pharyngeal cancers. The literature on oral and pharyngeal cancer disparities among racial groups also appears to be growing. However, less literature is available on the influence of dietary factors on these cancers. Finally, effective interventions for the reduction of oral and pharyngeal cancers are discussed

WEAR MECHANISM OF CERAMIC TOOLS

Cutting tests were performed using ceramic cutting tools under continuous cutting conditions. The tests were carried out on AISI 1040 steel, with cutting speeds ranging from 5 to 11 m s-1. The wear mechanism was investigated for both crater and flank. Alumina-toughened zirconia of submicron grain size showed the best wear resistance. Alumina with TiC, TiN and ZrO2 inclusions exhibited a wear resistance a little lower than the above-mentioned materials. Low chemical stability seems to be the reason for the poor performances of the silicon carbide whiskers-reinforced alumina, silicon nitride and the tungsten carbide inserts

WEAR PERFORMANCE OF CERAMIC CUTTING-TOOL MATERIALS WHEN CUTTING STEEL

Some test cycles have been carried out in continuous cutting conditions, employing cutting parameters (feed, depth of cut and cutting speed) chosen following experimental planes and suitable test fields. The wear tests have been carried out on AISI 1040 steel with cutting speeds from 5m/sec to 11m/sec. The silicon nitride, sintered carbide, cubic boron nitride and alumina reinforced with SiC whiskers inserts, have shown, at each assigned cutting parameter, poor wear resistance when cutting steel. Alumina and alumina in submicron grain, which has been toughened by ZrO2 phase transformation, and the oxide-based alumina, have been the better wear resistance. The mixed based alumina has shown a wear resistance, a little lower than the previous materials. The low chemical stability seems to be the reason for the poor performances of the silicon nitride and the silicon carbide whiskers reinforced alumina inserts. The high wear rate of the sintered carbide and the cubic boron nitride is essentially due to the pull out of the ceramic particles. From the other hand, the chemical stability, together with their good mechanical properties can explain the appreciable results obtained with the other alumina based materials