Aerodynamic investigations of ventilated brake discs.

The heat dissipation and performance of a ventilated brake disc strongly depends on the aerodynamic characteristics of the flow through the rotor passages. The aim of this investigation was to provide an improved understanding of ventilated brake rotor flow phenomena, with a view to improving heat dissipation, as well as providing a measurement data set for validation of computational fluid dynamics methods. The flow fields at the exit of four different brake rotor geometries, rotated in free air, were measured using a five-hole pressure probe and a hot-wire anemometry system. The principal measurements were taken using two-component hot-wire techniques and were used to determine mean and unsteady flow characteristics at the exit of the brake rotors. Using phase-locked data processing, it was possible to reveal the spatial and temporal flow variation within individual rotor passages. The effects of disc geometry and rotational speed on the mean flow, passage turbulence intensity, and mass flow were determined. The rotor exit jet and wake flow were clearly observed as characterized by the passage geometry as well as definite regions of high and low turbulence. The aerodynamic flow characteristics were found to be reasonably independent of rotational speed but highly dependent upon rotor geometry

Installed performance assessment of a boundary layer ingesting distributed propulsion system at design point

Boundary layer ingesting systems have been proposed as a concept with great potential for reducing the fuel consumption of conventional propulsion systems and the overall drag of an aircraft. These studies have indicated that if the aerodynamic and efficiency losses were minimised, the propulsion system demonstrated substantial power consumption benefits in comparison to equivalent propulsion systems operating in free stream flow. Previously assessed analytical methods for BLI simulation have been from an uninstalled perspective. This research will present the formulation of an rapid analytical method for preliminary design studies which evaluates the installed performance of a boundary layer ingesting system. The method uses boundary layer theory and one dimensional gas dynamics to assess the performance of an integrated system. The method was applied to a case study of the distributed propulsor array of a blended wing body aircraft. There was particular focus on assessment how local flow characteristics influence the performance of individual propulsors and the propulsion system as a whole. The application of the model show that the spanwise flow variation has a significant impact on the performance of the array as a whole. A clear optimum design point is identified which minimises the power consumption for an array with a fixed configuration and net propulsive force requirement. In addition, the sensitivity of the system to distortion related losses is determined and a point is identi ed where a conventional free-stream propulsor is the lower power option. Power saving coefficient for the configurations considered is estimated to lie in the region of 15%

Effective Vortex Pinning in MgB2 thin films

We discuss pinning properties of MgB2 thin films grown by pulsed-laser deposition (PLD) and by electron-beam (EB) evaporation. Two mechanisms are identified that contribute most effectively to the pinning of vortices in randomly oriented films. The EB process produces low defected crystallites with small grain size providing enhanced pinning at grain boundaries without degradation of Tc. The PLD process produces films with structural disorder on a scale less that the coherence length that further improves pinning, but also depresses Tc

From warfare to welfare: veterans, military charities and the blurred spatiality of post-service welfare in the United Kingdom

The military offers a form of welfare-for-work but when personnel leave they lose this safety net, a loss exacerbated by the rollback neoliberalism of the contemporary welfare state. Increasingly the third sector has stepped in to address veterans’ welfare needs through operating within and across military/civilian and state/market/community spaces and cultures. In this paper we use both veterans’ and military charities’ experiences to analyse the complex politics that govern the liminal boundary zone of post-military welfare. Through exploring ‘crossing’ and ‘bridging’ we conceptualise military charities as ‘boundary subjects’, active yet dependent on the continuation of the civilian-military binary, and argue that the latter is better understood as a multidirectional, multiscalar and contextual continuum. Post-military welfare emerges as a competitive, confused and confusing assemblage that needs to be made more navigable in order to better support the ‘heroic poor’

Size-Dependent Photon Emission from Organometal Halide Perovskite Nanocrystals Embedded in an Organic Matrix

10.1021/jz502615eJournal of Physical Chemistry Letters63446-45

Strongly Enhanced Current Densities in Superconducting Coated Conductors of YBa2Cu3O7-x + BaZrO3

There are numerous potential applications for superconducting tapes, based on YBa2Cu3O7-x (YBCO) films coated onto metallic substrates. A long established goal of more than 15 years has been to understand the magnetic flux pinning mechanisms which allow films to maintain high current densities out to high magnetic fields. In fact, films carry 1-2 orders of magnitude higher current densities than any other form of the material. For this reason, the idea of further improving pinning has received little attention. Now that commercialisation of conductors is much closer, for both better performance and lower fabrication costs, an important goal is to achieve enhanced pinning in a practical way. In this work, we demonstrate a simple and industrially scaleable route which yields a 1.5 to 5-fold improvement in the in-field current densities of already-high-quality conductors

Enhancement of Critical Current Density in low level Al-doped MgB2

Two sets of MgB2 samples doped with up to 5 at. % of Al were prepared in different laboratories using different procedures. Decreases in the a and c lattice parameters were observed with Al doping confirming Al substitution onto the Mg site. The critical temperature (Tc) remained largely unchanged with Al doping. For 1 - 2.5 at.% doping, at 20K the in-field critical current densities (Jc's) were enhanced, particularly at lower fields. At 5K, in-field Jc was markedly improved, e.g. at 5T Jc was enhanced by a factor of 20 for a doping level of 1 at.% Al. The improved Jcs correlate with increased sample resistivity indicative of an increase in the upper critical field, Hc2, through alloying.Comment: 17 pages, 4 figures, to be published in Superconductor Science and Technolog

Towards Oxide Electronics:a Roadmap

At the end of a rush lasting over half a century, in which CMOS technology has been experiencing a constant and breathtaking increase of device speed and density, Moore's law is approaching the insurmountable barrier given by the ultimate atomic nature of matter. A major challenge for 21st century scientists is finding novel strategies, concepts and materials for replacing silicon-based CMOS semiconductor technologies and guaranteeing a continued and steady technological progress in next decades. Among the materials classes candidate to contribute to this momentous challenge, oxide films and heterostructures are a particularly appealing hunting ground. The vastity, intended in pure chemical terms, of this class of compounds, the complexity of their correlated behaviour, and the wealth of functional properties they display, has already made these systems the subject of choice, worldwide, of a strongly networked, dynamic and interdisciplinary research community. Oxide science and technology has been the target of a wide four-year project, named Towards Oxide-Based Electronics (TO-BE), that has been recently running in Europe and has involved as participants several hundred scientists from 29 EU countries. In this review and perspective paper, published as a final deliverable of the TO-BE Action, the opportunities of oxides as future electronic materials for Information and Communication Technologies ICT and Energy are discussed. The paper is organized as a set of contributions, all selected and ordered as individual building blocks of a wider general scheme. After a brief preface by the editors and an introductory contribution, two sections follow. The first is mainly devoted to providing a perspective on the latest theoretical and experimental methods that are employed to investigate oxides and to produce oxide-based films, heterostructures and devices. In the second, all contributions are dedicated to different specific fields of applications of oxide thin films and heterostructures, in sectors as data storage and computing, optics and plasmonics, magnonics, energy conversion and harvesting, and power electronics

Decades of urban growth and development on the Asian megadeltas

The current and ongoing expansion of urban areas worldwide represents the largest mass migration in human history. It is well known that the world's coastal zones are associated with large and growing concentrations of population, urban development and economic activity. Among coastal environments, deltas have long been recognized for both benefits and hazards. This is particularly true on the Asian megadeltas, where the majority of the world's deltaic populations reside. Current trends in urban migration, combined with demographic momentum suggest that the already large populations on the Asian megadeltas will continue to grow. In this study, we combine recently released gridded population density (circa 2010) with a newly developed night light change product (1992 to 2012) and a digital elevation model to quantify the spatial distribution of population and development on the nine Asian megadeltas. Bivariate distributions of population as functions of elevation and coastal proximity quantify potential exposure of deltaic populations to flood and coastal hazards. Comparison of these distributions for the Asian megadeltas show very different patterns of habitation with peak population elevations ranging from 2 to 11 m above sea level over a wide range of coastal proximities. Over all nine megadeltas, over 174 million people reside below a peak population elevation of 7 m. Changes in the spatial extent of anthropogenic night light from 1992 to 2012 show widely varying extents and changes of lighted urban development. All of the deltas except the Indus show the greatest increases in night light brightness occurring at elevations < 10 m. At global and continental scales, growth of settlements of all sizes takes the form of evolving spatial networks of development. Spatial networks of lighted urban development in Asia show power law scaling properties consistent with other continents, but much higher rates of growth. The three largest networks of development in China all occur on deltas and adjacent lowlands, and are growing faster than the rest of the urban network in China. Since 2000, the Huanghe Delta + North China Plain urban network has surpassed the Japanese urban network in size and may soon connect with the Changjiang Delta + Yangtze River urban network to form the largest conurbation in Asia