Implicit large eddy simulations of anisotropic weakly compressible turbulence with application to core-collapse supernovae

(Abridged) In the implicit large eddy simulation (ILES) paradigm, the dissipative nature of high-resolution shock-capturing schemes is exploited to provide an implicit model of turbulence. Recent 3D simulations suggest that turbulence might play a crucial role in core-collapse supernova explosions, however the fidelity with which turbulence is simulated in these studies is unclear. Especially considering that the accuracy of ILES for the regime of interest in CCSN, weakly compressible and strongly anisotropic, has not been systematically assessed before. In this paper we assess the accuracy of ILES using numerical methods most commonly employed in computational astrophysics by means of a number of local simulations of driven, weakly compressible, anisotropic turbulence. We report a detailed analysis of the way in which the turbulent cascade is influenced by the numerics. Our results suggest that anisotropy and compressibility in CCSN turbulence have little effect on the turbulent kinetic energy spectrum and a Kolmogorov $k^{-5/3}$ scaling is obtained in the inertial range. We find that, on the one hand, the kinetic energy dissipation rate at large scales is correctly captured even at relatively low resolutions, suggesting that very high effective Reynolds number can be achieved at the largest scales of the simulation. On the other hand, the dynamics at intermediate scales appears to be completely dominated by the so-called bottleneck effect, \ie the pile up of kinetic energy close to the dissipation range due to the partial suppression of the energy cascade by numerical viscosity. An inertial range is not recovered until the point where relatively high resolution $\sim 512^3$, which would be difficult to realize in global simulations, is reached. We discuss the consequences for CCSN simulations.Comment: 17 pages, 9 figures, matches published versio

The Role of Turbulence in Neutrino-Driven Core-Collapse Supernova Explosions

The neutrino-heated "gain layer" immediately behind the stalled shock in a core-collapse supernova is unstable to high-Reynolds-number turbulent convection. We carry out and analyze a new set of 19 high-resolution three-dimensional (3D) simulations with a three-species neutrino leakage/heating scheme and compare with spherically-symmetric (1D) and axisymmetric (2D) simulations carried out with the same methods. We study the postbounce supernova evolution in a $15$-$M_\odot$ progenitor star and vary the local neutrino heating rate, the magnitude and spatial dependence of asphericity from convective burning in the Si/O shell, and spatial resolution. Our simulations suggest that there is a direct correlation between the strength of turbulence in the gain layer and the susceptability to explosion. 2D and 3D simulations explode at much lower neutrino heating rates than 1D simulations. This is commonly explained by the fact that nonradial dynamics allows accreting material to stay longer in the gain layer. We show that this explanation is incomplete. Our results indicate that the effective turbulent ram pressure exerted on the shock plays a crucial role by allowing multi-D models to explode at a lower postshock thermal pressure and thus with less neutrino heating than 1D models. We connect the turbulent ram pressure with turbulent energy at large scales and in this way explain why 2D simulations are erroneously exploding more easily than 3D simulations.Comment: 13 pages, 8 figures, accepted by Ap

Galaxy threshing and the origin of intracluster stellar objects

We numerically investigate dynamical evolution of non-nucleated dwarf elliptical/spiral galaxies (dE) and nucleated ones (dE,Ns) in clusters of galaxies in order to understand the origin of intracluster stellar objects, such as intracluster stars (ICSs), GCs (ICGCs), and ``ultra-compact dwarf'' (UCDs) recently discovered by all-object spectroscopic survey centred on the Fornax cluster of galaxies. We find that the outer stellar components of a nucleated dwarf are removed by the strong tidal field of the cluster, whereas the nucleus manages to survive as a result of its initially compact nature. The developed naked nucleus is found to have physical properties (e.g., size and mass) similar to those observed for UCDs. We also find that the UCD formation processes does depend on the radial density profile of the dark halo in the sense that UCDs are less likely to be formed from dwarfs embedded in dark matter halos with central `cuspy' density profiles. Our simulations also suggest that very massive and compact stellar systems can be rapidly and efficiently formed in the central regions of dwarfs through the merging of smaller GCs. GCs initially in the outer part of dE and dE,Ns are found to be stripped to form ICGCs.Comment: 6 pages and 3 figures (JPG file for Fig. 1), in the proceedings of IAU 217 ``Recycling intergalactic and interstellar matter'

Exploratory wind tunnel tests of a shock-swallowing air data sensor at a Mach number of approximately 1.83

The test probe was designed to measure free-stream Mach number and could be incorporated into a conventional airspeed nose boom installation. Tests were conducted in the Langley 4-by 4-foot supersonic pressure tunnel with an approximate angle of attack test range of -5 deg to 15 deg and an approximate angle of sideslip test range of + or - 4 deg. The probe incorporated a variable exit area which permitted internal flow. The internal flow caused the bow shock to be swallowed. Mach number was determined with a small axially movable internal total pressure tube and a series of fixed internal static pressure orifices. Mach number error was at a minimum when the total pressure tube was close to the probe tip. For four of the five tips tested, the Mach number error derived by averaging two static pressures measured at horizontally opposed positions near the probe entrance were least sensitive to angle of attack changes. The same orifices were also used to derive parameters that gave indications of flow direction

The Otto-engine-equivalent vehicle concept

A vehicle comparison methodology based on the Otto-Engine Equivalent (OEE) vehicle concept is described. As an illustration of this methodology, the concept is used to make projections of the fuel economy potential of passenger cars using various alternative power systems. Sensitivities of OEE vehicle results to assumptions made in the calculational procedure are discussed. Factors considered include engine torque boundary, rear axle ratio, performance criteria, engine transient response, and transmission shift logic

Revival of the Stalled Core-collapse Supernova Shock Triggered by Precollapse Asphericity in the Progenitor Star

Multi-dimensional simulations of advanced nuclear burning stages of massive stars suggest that the Si/O layers of presupernova stars harbor large deviations from the spherical symmetry typically assumed for presupernova stellar structure. We carry out three-dimensional core-collapse supernova simulations with and without aspherical velocity perturbations to assess their potential impact on the supernova hydrodynamics in the stalled-shock phase. Our results show that realistic perturbations can qualitatively alter the postbounce evolution, triggering an explosion in a model that fails to explode without them. This finding underlines the need for a multi-dimensional treatment of the presupernova stage of stellar evolution

Starcounts in the Hubble Deep Field: Constraining Galactic Structure Models

Stellar sources are identified in the Hubble Deep Field, and accurate colours and magnitudes are presented. The predictions of a Galactic starcounts model are compared with the faint stellar counts in this field. The model reproduces the observations very well in the magnitude range 21.0 < V < 26.4, while it overpredicts the counts by a factor of four in the range 26.4 < V < 30.0. The luminosity function for halo objects must be a factor of two smaller than that predicted by an extrapolation of the solar-neighborhood luminosity function for disc stars (with 95% confidence level). This result, seen before in deep Hubble Space Telescope images of globular clusters, is therefore confirmed for the halo field population. The possible nature of a group of faint-blue objects is also investigated, concluding that they are most likely non-stellar. The possibility that they are QSOs is ruled out. If we insist upon their stellar nature, they would be halo white dwarfs, with either a very steep halo white dwarf luminosity function for Mv > +11.0, or a stellar density 0.4 times that of the disc white dwarfs in the solar-neighborhood.Comment: Tex type, 7 pages, 3 postscript figures. Accepted for publication in Monthly Notices of the Royal Astronomical Society. A few typos corrected. Updated references. Note Added in Proof (including one table), containing a detailed photometric comparison (for point-like sources) between our results and those from other investigations of the HDF

The WINGS Survey: a progress report

A two-band (B and V) wide-field imaging survey of a complete, all-sky X-ray selected sample of 78 clusters in the redshift range z=0.04-0.07 is presented. The aim of this survey is to provide the astronomical community with a complete set of homogeneous, CCD-based surface photometry and morphological data of nearby cluster galaxies located within 1.5 Mpc from the cluster center. The data collection has been completed in seven observing runs at the INT and ESO-2.2m telescopes. For each cluster, photometric data of about 2500 galaxies (down to V~23) and detailed morphological information of about 600 galaxies (down to V~21) are obtained by using specially designed automatic tools. As a natural follow up of the photometric survey, we also illustrate a long term spectroscopic program we are carrying out with the WHT-WYFFOS and AAT-2dF multifiber spectrographs. Star formation rates and histories, as well as metallicity estimates will be derived for about 350 galaxies per cluster from the line indices and equivalent widths measurements, allowing us to explore the link between the spectral properties and the morphological evolution in high- to low-density environments, and across a wide range in cluster X-ray luminosities and optical properties.Comment: 12 pages, 10 eps figures, Proceedings of the SAIt Conference 200

Hot melt adhesive attachment pad

A hot melt adhesive attachment pad for releasably securing distinct elements together is described which is particularly useful in the construction industry or a spatial vacuum environment. The attachment pad consists primarily of a cloth selectively impregnated with a charge of hot melt adhesive, a thermo-foil heater, and a thermo-cooler. These components are securely mounted in a mounting assembly. In operation, the operator activates the heating cycle transforming the hot melt adhesive to a substantially liquid state, positions the pad against the attachment surface, and activates the cooling cycle solidifying the adhesive and forming a strong, releasable bond