The remote sensing of aquatic macrophytes Part 1: Color-infrared aerial photography as a tool for identification and mapping of littoral vegetation. Part 2: Aerial photography as a quantitative tool for the investigation of aquatic ecosystems

Research was initiated to use aerial photography as an investigative tool in studies that are part of an intensive aquatic ecosystem research effort at Lake Wingra, Madison, Wisconsin. It is anticipated that photographic techniques would supply information about the growth and distribution of littoral macrophytes with efficiency and accuracy greater than conventional methods

Station-keeping guidance

The station-keeping guidance system is described, which is designed to automatically keep one orbiting vehicle within a prescribed zone fixed with respect to another orbiting vehicle. The active vehicle, i.e. the one performing the station-keeping maneuvers, is referred to as the shuttle. The other passive orbiting vehicle is denoted as the workshop. The passive vehicle is assumed to be in a low-eccentricity near-earth orbit. The primary navigation sensor considered is a gimballed tracking radar located on board the shuttle. It provides data on relative range and range rate between the two vehicles. Also measured are the shaft and trunnion axes gimbal angles. An inertial measurement unit (IMU) is provided on board the orbiter. The IMU is used at all times to provide an attitude reference for the vehicle. The IMU accelerometers are used periodically to monitor the velocity-correction burns applied to the shuttle during the station-keeping mode. The guidance system is capable of station-keeping the shuttle in any arbitrary position with respect to the workshop by periodically applying velocity-correction pulses to the shuttle

New shield for gamma-ray spectrometry

Gamma-ray shield that can be evacuated, refilled with a clean gas, and pressurized for exclusion of airborne radioactive contaminants effectively lowers background noise. Under working conditions, repeated evacuation and filling procedures have not adversely affected the sensitivity and resolution of the crystal detector

Design, fabrication, and test of a composite material wind turbine rotor blade

The aerodynamic design, structural design, fabrication, and structural testing is described for a 60 foot long filament wound, fiberglass/epoxy resin matrix wind turbine rotor blade for a 125 foot diameter, 100 kW wind energy conversion system. One blade was fabricated which met all aerodynamic shape requirements and was structurally capable of operating under all specified design conditions. The feasibility of filament winding large rotor blades was demonstrated

Net solar generation potential from urban rooftops in Los Angeles

Rooftops provide accessible locations for solar energy installations. While rooftop solar arrays can offset in-building electricity needs, they may also stress electric grid operations. Here we present an analysis of net electricity generation potential from distributed rooftop solar in Los Angeles. We integrate spatial and temporal data for property-level electricity demands, rooftop solar generation potential, and grid capacity constraints to estimate the potential for solar to meet on-site demands and supply net exports to the electric grid. In the study area with 1.2 million parcels, rooftop solar could meet 7200 Gigawatt Hours (GWh) of on-site building demands (~29% of demand). Overall potential net generation is negative, meaning buildings use more electricity than they can produce. Yet, cumulative net export potential from solar to grid circuits is 16,400 GWh. Current policies that regulate solar array interconnection to the grid result in unutilized solar power output of 1700 MW. Lower-income and at-risk communities in LA have greater potential for exporting net solar generation to the grid. This potential should be recognized through investments and policy innovations. The method demonstrates the need for considering time-dependent calculations of net solar potential and offers a template for distributed renewable energy planning in cities

Credit Guarantee Programs in International Grain Markets: Background and Issues

Marketing,

Regional similarities in the distributions of well yield from crystalline rocks in Fennoscandia

Well yields from Precambrian and Palaeozoic bedrock in Norway, Sweden and Finland exhibit very similar and approximately log-normal distributions: all three data sets exhibit a median yield of 600–700 L hr-1, despite the differences in climate and lithology. This similarity is tentatively reflected on a larger geographical scale by a meta-analysis of the international data sets on crystalline rock aquifers from other recently glaciated areas (i.e., without a thick regolith of weathered rock). An heuristic treatment of the Fennoscandian data sets suggests that this median yield is consistent with the following bulk properties of shallow (to c. 70–80 m depth) crystalline bedrock: transmissivity of 0.56 ± 0.30 m2 d-1 (6.4 ± 3.4 x 10-6 m2 s-1) and hydraulic conductivity of around 1.1 (± 0.6) x 10-7 m s-1