A wideband noise-canceling CMOS LNA exploiting a transformer

A broadband LNA incorporating single-ended to differential conversion, has been successfully implemented using a noise-canceling technique and a single on-chip transformer. The LNA achieves a high voltage gain of 19dB, a wideband input match (2.5-4.0 GHz), and a noise figure of 4-5.4 dB, while consuming only 8mW. The LNA is implemented in a 90nm CMOS process with 6 metal layers

MIDWEST GRAIN PRODUCTS: A CHANGE IN STRATEGY DUE TO TRADE ISSUES

Crop Production/Industries, International Relations/Trade,

Influence of the ice growth rate on the incorporation of gaseous HCl

International audienceIce crystals were grown in the laboratory at -15°C, at different growth rates and in the presence of a partial pressure of HCl of 1.63×10-3 Pa, to test whether the ice growth rate influences the amount of HCl taken up, XHCl, as predicted by the ice growth mechanism of Domine and Thibert (1996). The plot of HCl concentration in ice as a function of growth rate has the aspect predicted by that mechanism: XHCl decreases with increasing growth rate, from a value that depends on thermodynamic equilibrium to a value that depends only on kinetic factors. The height of the growth steps of the ice crystals is determined to be about 1.5 nm from these experiments. We discuss that the application of these laboratory experiments to cloud ice crystals and to snow metamorphism is not quantitatively possible at this stage, because the physical variables that determine crystal growth in nature, and in particular the step height, are not known. Qualitative applications are attempted for HCl and HNO3 incorporation in cloud ice and snowpack crystals

The BLIXER, a Wideband Balun-LNA-I/Q-Mixer Topology

This paper proposes to merge an I/Q current-commutating mixer with a noise-canceling balun-LNA. To realize a high bandwidth, the real part of the impedance of all RF nodes is kept low, and the voltage gain is not created at RF but in baseband where capacitive loading is no problem. Thus a high RF bandwidth is achieved without using inductors for bandwidth extension. By using an I/Q mixer with 25% duty-cycle LO waveform the output IF currents have also 25% duty-cycle, causing 2 times smaller DC-voltage drop after IF filtering. This allows for a 2 times increase in the impedance level of the IF filter, rendering more voltage gain for the same supply headroom. The implemented balun-LNA-I/Q-mixer topology achieves > 18 dB conversion gain, a flat noise figure < 5.5 dB from 500 MHz to 7 GHz, IIP2 = +20 dBm and IIP3 = -3 dBm. The core circuit consumes only 16 mW from a 1.2 V supply voltage and occupies less than 0.01 mm2 in 65 nm CMOS

A 1.2-V 10- µW NPN-Based Temperature Sensor in 65-nm CMOS With an Inaccuracy of 0.2 °C (3σ) From 70 °C to 125 °C

An NPN-based temperature sensor with digital output transistors has been realized in a 65-nm CMOS process. It achieves a batch-calibrated inaccuracy of ±0.5 ◦C (3¾) and a trimmed inaccuracy of ±0.2 ◦C (3¾) over the temperature range from −70 ◦C to 125 ◦C. This performance is obtained by the use of NPN transistors as sensing elements, the use of dynamic techniques, i.e. correlated double sampling and dynamic element matching, and a single room-temperature trim. The sensor draws 8.3 μA from a 1.2-V supply and occupies an area of 0.1 mm2

A 65-nm CMOS Temperature-Compensated Mobility-Based Frequency reference for wireless sensor networks

For the first time, a temperature-compensated CMOS frequency reference based on the electron mobility in a MOS transistor is presented. Over the temperature range from -55°C to 125 °C, its frequency spread is less than ±0.5% after a two-point trim and less than ±2.7% after a one-point trim. These results make it suitable for use in Wireless Sensor Network nodes. Fabricated in a baseline 65-nm CMOS process, the 150 kHz frequency reference occupies 0.2 mm2 and draws 42.6 μA from a 1.2-V supply at room temperature.\ud \u

Behavioral ontogeny in larvae and early juveniles of the giant trevally (Caranx ignobilis) (Pisces: Carangidae)

Behavior of young (8−18 mm SL) giant trevally (Caranx ignobilis), a large coral-reef−associated predator, was observed in the laboratory and the ocean. Size was a better predictor of swimming speed and endurance than was age. Critical speed increased with size from 12 to 40 cm/s at 2.7 cm/s for each mm increase in size. Mean scaled critical speed was 19 body lengths/s and was not size related. Swimming speed in the ocean was 4 to 20 cm/s (about half of critical speed) and varied among areas, but within each area, it increased at 2 cm/s for each mm increase in size. Swimming endurance in the laboratory increased from 5 to 40 km at 5 km for each mm increase in size. Vertical distribution changed ontogenetically: larvae swam shallower, but more variably, and then deeper with growth. Two-thirds of individuals swam directionally with no ontogenetic increase in orientation precision. Larvae swam offshore off open coasts, but not in a bay. In situ observations of C. ignobilis feeding, interacting with pelagic animals, and reacting to reefs are reported. Manus

Measurement of the specific surface area of snow using infrared reflectance in an integrating sphere at 1310 and 1550 nm

International audienceEven though the specific surface area (SSA) and the snow area index (SAI) of snow are crucial variables to determine the chemical and climatic impact of the snow cover, few data are available on the subject. We propose here a novel method to measure snow SSA and SAI. It is based on the measurement of the hemispherical infrared reflectance of snow samples using the DUFISSS instrument (DUal Frequency Integrating Sphere for Snow SSA measurement). DUFISSS uses the 1310 or 1550 nm radiation of laser diodes, an integrating sphere 15 cm in diameter, and InGaAs photodiodes. For SSA60 m2 kg−1, snow is usually of low density (typically 30 to 100 kg m−3), resulting in insufficient optical depth and 1310 nm radiation reaches the bottom of the sample, causing artifacts. The 1550 nm radiation is therefore used for SSA>60 m2 kg−1. Reflectance is then in the range 5 to 12% and the accuracy on SSA is 12%. We propose empirical equations to determine SSA from reflectance at both wavelengths, with that for 1310 nm taking into account the snow density. DUFISSS has been used to measure the SSA of snow and the SAI of snowpacks in polar and Alpine regions