Dually-mode-locked ND: YAG laser

Mode-locking is stabilized effectively by conventional loss-modulator and phase-modulator, mode-locking elements placed in laser cavity in optical series with one another. Resulting dually-mode-locked system provides pulses with constant phase relative to mode-lock drive signal without presence of relaxation oscillation noise

DEVELOPMENT AND FEDERAL GRAZING POLICY IMPACTS ON TWO COLORADO COUNTIES: A COMPARATIVE STUDY

Ranchers have concern over how federal policies such as the Endangers Species Act, the Clean Water Act, and other laws and regulations will affect the status of their ranching operations. The objectives of this study were to compare impacts of public forage losses on ranches in areas experiencing rapid growth (Routt County) and minimal growth (Moffat County) in Colorado. Thirty-five personal interviews obtained detailed cost-and-return information on public, leased, and private land. Enterprise budgets for seven distinct ranch averages were entered into a linear programming (LP) model to calculate impacts on ranches of public forage reductions of 25%, 50%, and 100%. Changes in net ranch returns and livestock production reflect the economic impact of policy changes. Grazing alternatives to hypothetical reductions in public grazing chosen by the ranchers were applied in the program to mimic rancher decisions. The study found, as would be expected, that larger ranches with more public forage dependency would be the most affected by public forage losses. Those with fewer sources of alternative forage, and ranches with low costs and high returns, experienced more difficulty in coping with the grazing reductions on public land. Routt County, with its higher dependence on public forage and minimal alternative forage sources, would be more affected by federal forage reduction than Moffat County.Agricultural and Food Policy, Community/Rural/Urban Development, Land Economics/Use,

Coherent state triplets and their inner products

It is shown that if H is a Hilbert space for a representation of a group G, then there are triplets of spaces F_H, H, F^H, in which F^H is a space of coherent state or vector coherent state wave functions and F_H is its dual relative to a conveniently defined measure. It is shown also that there is a sequence of maps F_H -> H -> F^H which facilitates the construction of the corresponding inner products. After completion if necessary, the F_H, H, and F^H, become isomorphic Hilbert spaces. It is shown that the inner product for H is often easier to evaluate in F_H than F^H. Thus, we obtain integral expressions for the inner products of coherent state and vector coherent state representations. These expressions are equivalent to the algebraic expressions of K-matrix theory, but they are frequently more efficient to apply. The construction is illustrated by many examples.Comment: 33 pages, RevTex (Latex2.09) This paper is withdrawn because it contained errors that are being correcte

Thermomagnetic analysis of meteorites, 2: C2 chondrites

Samples of all eighteen of the known C2 chondrites were analyzed thermomagnetically. For eleven of these, initial Fe3O4 content is low(generally 1%) and the J sub s-T curves are irreversible. The heating curves show variable and erratic behavior, whereas the cooling curves appear to be that of Fe3O4. The saturation moment after cooling is greater (up to 10 times larger) than it is initially. This behavior is interpreted to be the result of the production of magnetite from a thermally unstable phase--apparently FeS. Four of the remaining 7 C2 chondrites contain Fe3O4 as the only significant magnetic phase: initial magnetite contents range from 4 to 13 percent. The remaining three C2 chondrites contain iron or nickel-iron in addition to Fe3O4. These seven C2 chondrites show little evidence of the breakdown of a thermally unstable phase

Thermomagnetic analysis of meterorites. 4: Ureilites

Samples of all available ureilites have been analyzed thermomagnetically. For three of the six (Dyalpur, Goalpara and Havero) evidence was found for only low-nickel metallic-iron as the magnetic component and the (saturation magnetization vs, temperature) curves were reversible. In the Novo Urei ureilite, magnetite in addition to low-nickel metallic-iron was indicated and again the Js-T curve was reversible. For the two badly weathered ureilites, Dingo Pup Donga and North Haig, indication was also found that both initial magnetite and low-nickel metallic-iron were present. However, the Js-T curves were somewhat irreversible and the final saturation magnetization was 20% and 50% greater than initially for North Haig and Dingo Pup Donga, respectively. This behavior is interpreted to be the result of magnetite production from a secondary iron oxide during the experiment

Erosion/corrosion of turbine airfoil materials in the high-velocity effluent of a pressurized fluidized coal combustor

Four candidate turbine airfoil superalloys were exposed to the effluent of a pressurized fluidized bed with a solids loading of 2 to 4 g/scm for up to 100 hours at two gas velocities, 150 and 270 m/sec, and two temperatures, 730 deg and 795 C. Under these conditions, both erosion and corrosion occurred. The damaged specimens were examined by cross-section measurements, scanning electron and light microscopy, and X-ray analysis to evaluate the effects of temperature, velocity, particle loading, and alloy material. Results indicate that for a given solids loading the extent of erosion is primarily dependent on gas velocity. Corrosion occurred only at the higher temperature. There was little difference in the erosion/corrosion damage to the four alloys tested under these severe conditions

Model Based Definition

In September 2007, the Engineering Directorate at the Marshall Space Flight Center (MSFC) created the Design System Focus Team (DSFT). MSFC was responsible for the in-house design and development of the Ares 1 Upper Stage and the Engineering Directorate was preparing to deploy a new electronic Configuration Management and Data Management System with the Design Data Management System (DDMS) based upon a Commercial Off The Shelf (COTS) Product Data Management (PDM) System. The DSFT was to establish standardized CAD practices and a new data life cycle for design data. Of special interest here, the design teams were to implement Model Based Definition (MBD) in support of the Upper Stage manufacturing contract. It is noted that this MBD does use partially dimensioned drawings for auxiliary information to the model. The design data lifecycle implemented several new release states to be used prior to formal release that allowed the models to move through a flow of progressive maturity. The DSFT identified some 17 Lessons Learned as outcomes of the standards development, pathfinder deployments and initial application to the Upper Stage design completion. Some of the high value examples are reviewed

Frequency multiplication in high-energy electron beams Semiannual progress report, 1 Apr. - 1 Oct. 1967

High energy electron beam studies dealing with nonlinear analysis of beam-plasma interactions, cyclotron harmonic instabilities, and frequency multiplicatio

USSR Space Life Sciences Digest, issue 6

This is the sixth issue of NASA's USSR Space Life Sciences Digest. It contains abstracts of 54 papers recently published in Russian language periodicals and bound collections and of 10 new Soviet monographs. Selected abstracts are illustrated with figures and tables from the original. Additional features include a table of Soviet EVAs and information about English translations of Soviet materials available to readers. The topics covered in this issue have been identified as relevant to 26 areas of aerospace medicine and space biology. These areas are adaptation, biospherics, body fluids, botany, cardiovascular and respiratory systems, developmental biology, endocrinology, enzymology, exobiology, genetics, habitability and environment effects, health and medical treatment, hematology, human performance, immunology, life support systems, mathematical modeling, metabolism., microbiology, morphology and cytology, musculoskeletal system, neurophysiology, nutrition, perception, personnel selection, psychology, radiobiology, reproductive biology, and space medicine

Use of Standardized Assessments and Online Resources in Stroke Rehabilitation

Background: The extent to which movement-related standardized assessments and online resources are used in stroke rehabilitation is unclear in the United States. Method: The researchers used a cross-sectional descriptive survey that examined (a) therapists use of movement-related standardized assessments, (b) factors influencing learning of new assessments, and (c) use of frequency of online resources by occupational therapists and physical therapists in the United States. Results: Of 151 respondents (46.4% occupational therapists, 53.6% physical therapists), the most frequently used movement-related assessments by occupational and physical therapists were the Berg and Fugl-Meyer Assessment, respectively. More physical therapists use motor-related standardized assessments regularly than occupational therapists, and physical therapists showed more consensus among standardized assessments. Both professions cited quality of patient care for motivating them to integrate outcome measures into practice. Most therapists in stroke rehabilitation used online resources to access movement-related standardized assessment content at least 25% of the time. The Rehabilitation Measures Database was the most frequently used website. Conclusion: Both occupational and physical therapists use online resources for movement-related standardized assessments on a regular basis. However, occupational therapists do not use standardized assessments as frequently as physical therapists. A systematic study of factors that impact the integration of standardized assessments is needed to further identify barriers and inform clinical practice change