Infrared diagnosis using liquid crystal detectors

The possible uses of pulsed carbon dioxide lasers for analysis of plasmas and flows need appropriate infrared image converters. Emphasis was placed on liquid crystal detectors and their operational modes. Performance characterstics and selection criteria, such as high sensitivity, short reaction time, and high spatial resolution are discussed

High-Intensity and High-Brightness Source of Moderated Positrons Using a Brilliant gamma Beam

Presently large efforts are conducted towards the development of highly brilliant gamma beams via Compton back scattering of photons from a high-brilliance electron beam, either on the basis of a normal-conducting electron linac or a (superconducting) Energy Recovery Linac (ERL). Particularly ERL's provide an extremely brilliant electron beam, thus enabling to generate highest-quality gamma beams. A 2.5 MeV gamma beam with an envisaged intensity of 10^15 s^-1, as ultimately envisaged for an ERL-based gamma-beam facility, narrow band width (10^-3), and extremely low emittance (10^-4 mm^2 mrad^2) offers the possibility to produce a high-intensity bright polarized positron beam. Pair production in a face-on irradiated W converter foil (200 micron thick, 10 mm long) would lead to the emission of 2 x 10^13 (fast) positrons per second, which is four orders of magnitude higher compared to strong radioactive ^22Na sources conventionally used in the laboratory.Using a stack of converter foils and subsequent positron moderation, a high-intensity low-energy beam of moderated positrons can be produced. Two different source setups are presented: a high-brightness positron beam with a diameter as low as 0.2 mm, and a high-intensity beam of 3 x 10^11 moderated positrons per second. Hence, profiting from an improved moderation efficiency, the envisaged positron intensity would exceed that of present high-intensity positron sources by a factor of 100.Comment: 9 pages, 3 figure

Detection of chlorides and moisture in concrete structures with ground penetrating radar

Corrosion of re-bar within reinforced concrete is a major problem in countries where salt is applied to roads for de-icing. Concrete structures are periodically inspected in order to monitor possible damage caused by chloride induced corrosion of the reinforcement. However, bridge decks covered with asphalt pavements are not accessible for visual inspection and probing is limited. As a result, the planning of rehabilitation of bridge decks is usually based on a small number of probes. Consequently, the condition of bridge decks can only be assessed with low certainty. Therefore, a method enabling to study the conditions of concrete bridge decks covered by asphalt pavements is desirable. This paper describes a laboratory experiment aiming at the investigation of the effects of moisture and chloride content on the amplitudes of radar signals. It can be shown that both, moisture and chloride content have a measurable influence on signal amplitudes. This may enable the future use of ground penetrating radar for the planning of probing campaigns or for the extrapolation of results obtained at single probing point

Defect Imaging and Detection of Precipitates Using a New Scanning Positron Microbeam

We report on a newly developed scanning positron microbeam based on threefold moderation of positrons provided by the high intensity positron source NEPOMUC. For brightness enhancement a remoderation unit with a $100\,$nm thin Ni(100) foil and 9.6% efficiency is applied to reduce the area of the beam spot by a factor of 60. In this way, defect spectroscopy is enabled with a lateral resolution of $33\,\mu$m over a large scanning range of $19\times19\,$mm$^{2}$. Moreover, 2D defect imaging using Doppler broadening spectroscopy (DBS) is demonstrated to be performed within exceptional short measurement times of less than two minutes for an area of $1\times1$mm$^{2}$ ($100\times100\,\mu$m$^{2}$) with a resolution of $250\,\mu$m ($50\,\mu$m). We studied the defect structure in laser beam welds of the high-strength agehardened Al alloy (AlCu6Mn, EN AW-2219 T87) by applying (coincident) DBS with unprecedented spatial resolution. The visualization of the defect distribution revealed a sharp transition between the raw material and the welded zone as well as a very small heat affected zone. Vacancy-like defects and Cu rich precipitates are detected in the as-received material and, to a lesser extent, in the transition zone of the weld. Most notably, in the center of the weld vacancies without forming Cu-vacancy complexes, and the dissolution of the Cu atoms in the crystal lattice, i.e. formation of a supersaturated solution, could be clearly identified

Investigation of the chemical vicinity of crystal defects in ion-irradiated Mg and AZ31 with coincident Doppler broadening spectroscopy

Crystal defects in magnesium and magnesium based alloys like AZ31 are of major importance for the understanding of their macroscopic properties. We have investigated defects and their chemical surrounding in Mg and AZ31 on an atomic scale with Doppler broadening spectroscopy of the positron annihilation radiation. In these Doppler spectra the chemical information and the defect contribution have to be thoroughly separated. For this reason samples of annealed Mg were irradiated with Mg-ions in order to create exclusively defects. In addition Al- and Zn-ion irradiation on Mg-samples was performed in order to create samples with defects and impurity atoms. The ion irradiated area on the samples was investigated with laterally and depth resolved positron Doppler broadening spectroscopy (DBS) and compared with preceding SRIM-simulations of the vacancy distribution, which are in excellent agreement. The investigation of the chemical vicinity of crystal defects in AZ31 was performed with coincident Doppler broadening spectroscopy (CDBS) by comparing Mg-ion irradiated AZ31 with Mg-ion irradiated Mg. No formation of solute-vacancy complexes was found due to the ion irradiation, despite the high defect mobility.Comment: Submitted to Physical Review B on March 20 20076. Revised version submitted on September 28 2007. Accepted on October 19 200

Detection and imaging of the oxygen deficiency in single crystalline YBa2_{\text{2}}Cu3_{\text{3}}O7−δ_{\text{7}-\delta} thin films using a positron beam

Single crystalline YBa$_{\text{2}}$Cu$_{\text{3}}$O$_{\text{7}-\delta}$ (YBCO) thin films were grown by pulsed laser deposition (PLD) in order to probe the oxygen deficiency $\delta$ using a mono-energetic positron beam. The sample set covered a large range of $\delta$ (0.191<$\delta$<0.791) yielding a variation of the critical temperature $T_{\text{c}}$ between 25 and 90\,K. We found a linear correlation between the Doppler broadening of the positron electron annihilation line and $\delta$ determined by X-ray diffraction (XRD). Both, the origin of the found correlation and the influence of metallic vacancies, were examined with the aid of ab-initio calculations that allowed us (i) to exclude the presence of Y vacancies and (ii) to ensure that positrons still probe $\delta$ despite the potential presence of Ba or Cu vacancies. In addition, by scanning with the positron beam the spatial variation of $\delta$ could be analyzed. It was found to fluctuate with a standard deviation of up to $0.079(5)$ within a single YBCO film

Quality of Heusler Single Crystals Examined by Depth Dependent Positron Annihilation Techniques

Heusler compounds exhibit a wide range of different electronic ground states and are hence expected to be applicable as functional materials in novel electronic and spintronic devices. Since the growth of large and defect-free Heusler crystals is still challenging, single crystals of Fe2TiSn and Cu2MnAl were grown by the optical floating zone technique. Two positron annihilation techniques -Angular Correlation of Annihilation Radiation (ACAR) and Doppler Broadening Spectroscopy (DBS)- were applied in order to study both, the electronic structure and lattice defects. Recently, we succeeded to observe clearly the anisotropy of the Fermi surface of Cu2MnAl, whereas the spectra of Fe2TiSn were disturbed by foreign phases. In order to estimate the defect concentration in different samples of Heusler compounds the positron diffusion length was determined by DBS using a monoenergetic positron beam