Structural heterogeneity and permeability in faulted eolian sandstone: Implications for subsurface modeling of faults

We determined the structure and permeability variations of a 4 km-long normal fault by integrating surface mapping with data from five boreholes drilled through the fault (borehole to tens of meters scale). The Big Hole fault outcrops in the Jurassic Navajo Sandstone, central Utah. A total of 363.2 m of oriented drill core was recovered at two sites where fault displacement is 8 and 3-5 m. The main fault core is a narrow zone of intensely comminuted grains that is a maximum of 30 cm thick and is composed of low-porosity amalgamated deformation bands that have slip surfaces on one or both sides. Probe permeameter measurements showed a permeability decline from greater than 2000 to less than 0.1 md as the fault is approached. Whole-core analyses showed that fault core permeability is less than I md and individual deformation band permeability is about 1 md. Using these data, we calculated the bulk permeability of the fault zone. Calculated transverse permeability over length scales of 5-10 m is 30-40 md, approximately 1-4% the value of the host rock. An inverse power mean calculation (representing a fault array with complex geometry) yielded total fault-zone permeabilities of 7-57 md. The bulk fault-zone permeability is most sensitive to variations in fault core thickness, which exhibits the greatest variability of the fault components

The structure and composition of exhumed faults, and their implications for seismic processes

Field studies of faults exhumed from seismogenic depths provide useful data to constrain seismologic models of fault zone processes and properties. Data collected on the San Andreas Fault in the San Gabriel Mountains has shown that large-displacement faults consist of one to several very narrow slip zones embedded in a cataclastically deformed sheared region several meters thick. However these faults have not been buried to depths greater than 5 km. Fault zones in the Sierra Nevada, California allow us to study the microstructures resulting from the deformation mechanisms active at seismogenic depths. Syn-fault mineralization shows that these left-lateral strike-slip faults formed at 5-12 km depth. Detailed microstructural analyses of the small faults reveal that they evolved from cooling joints filled by chlorite, epidote and quartz. These joints were then reactivated to form shear faults with accompanying brittle fracture and cataclastic deformation, ultimately developing very fined-grained cataclasites and ultracataclasites. The shear-induced microstructures are developed on faults with as little as several mm of slip showing that narrow slip-surfaces develop early in the lifetime of these faults. Subsequent slip has little effect on the microstructures. The inferred similarity of deformation mechanisms in faults 10 m to 10 km long indicates that basic slip processes on the faults are scale invariant, and may be a cause for the inferred constant b-value for small earthquakes. Analysis of map-scale fault linkages and terminations indicate that linkage zones are up to 400 m wide and 1 km long, and consist of altered and fractured rocks with numerous through-going slip surfaces. Terminations are regions of numerous splay faults that have cumulative offsets approaching those of the main faults. The slip distribution and structure of the terminations and linkage zones suggest that seismic slip may propagate into these zones of enhanced toughness, and that through-going slip can occur when a sufficient linkage of faults in the zone allow slip to be transmitted