Performance enhancement of multiuser MIMO wireless communication systems

This paper describes a new approach to the problem of enhancing the performance of a multiuser multiple-input-multiple-output (MIMO) system for communication from one base station to many mobile stations in both frequency-flat and frequency-selective fading channels. This problem arises in space-division multiplexing systems with multiple users where many independent signal streams can be transmitted in the same frequency and time slot through the exploitation of multiple antennas at both the base and mobile stations, Our new approach is based on maximizing a lower bound for the product of signal-to-interference plus noise ratio (SINR) of a multiuser MIMO system. This provides a closed-form (noniterative) solution for the antenna weights for all the users, under the constraint of fixed transmit power. Our solution is shown by simulation to have better performance than previously proposed iterative or noniterative solutions. In addition, our solution requires significantly reduced complexity over a gradient search-based method that directly optimizes the product SINgs while still maintaining similar performance. Our solution assumes channel state information is present at the base station or transmitter

Transmit Power Minimization for Wireless Networks with Energy Harvesting Relays

Energy harvesting (EH) has recently emerged as a key technology for green communications as it can power wireless networks with renewable energy sources. However, directly replacing the conventional non-EH transmitters by EH nodes will be a challenge. In this paper, we propose to deploy extra EH nodes as relays over an existing non-EH network. Specifically, the considered non-EH network consists of multiple source-destination (S-D) pairs. The deployed EH relays will take turns to assist each S-D pair, and energy diversity can be achieved to combat the low EH rate of each EH relay. To make the best of these EH relays, with the source transmit power minimization as the design objective, we formulate a joint power assignment and relay selection problem, which, however, is NP-hard. We thus propose a general framework to develop efficient sub-optimal algorithms, which is mainly based on a sufficient condition for the feasibility of the optimization problem. This condition yields useful design insights and also reveals an energy hardening effect, which provides the possibility to exempt the requirement of non-causal EH information. Simulation results will show that the proposed cooperation strategy can achieve near-optimal performance and provide significant power savings. Compared to the greedy cooperation method that only optimizes the performance of the current transmission block, the proposed strategy can achieve the same performance with much fewer relays, and the performance gap increases with the number of S-D pairs.Comment: 14 pages, 5 figures, accepted by IEEE Transactions on Communication

High Speed Railway Wireless Communications: Efficiency v.s. Fairness

High speed railways (HSRs) have been deployed widely all over the world in recent years. Different from traditional cellular communication, its high mobility makes it essential to implement power allocation along the time. In the HSR case, the transmission rate depends greatly on the distance between the base station (BS) and the train. As a result, the train receives a time varying data rate service when passing by a BS. It is clear that the most efficient power allocation will spend all the power when the train is nearest from the BS, which will cause great unfairness along the time. On the other hand, the channel inversion allocation achieves the best fairness in terms of constant rate transmission. However, its power efficiency is much lower. Therefore, the power efficiency and the fairness along time are two incompatible objects. For the HSR cellular system considered in this paper, a trade-off between the two is achieved by proposing a temporal proportional fair power allocation scheme. Besides, near optimal closed form solution and one algorithm finding the $\epsilon$-optimal allocation are presented.Comment: 16 pages, 6 figure

Training Optimization for Energy Harvesting Communication Systems

Energy harvesting (EH) has recently emerged as an effective way to solve the lifetime challenge of wireless sensor networks, as it can continuously harvest energy from the environment. Unfortunately, it is challenging to guarantee a satisfactory short-term performance in EH communication systems because the harvested energy is sporadic. In this paper, we consider the channel training optimization problem in EH communication systems, i.e., how to obtain accurate channel state information to improve the communication performance. In contrast to conventional communication systems, the optimization of the training power and training period in EH communication systems is a coupled problem, which makes such optimization very challenging. We shall formulate the optimal training design problem for EH communication systems, and propose two solutions that adaptively adjust the training period and power based on either the instantaneous energy profile or the average energy harvesting rate. Numerical and simulation results will show that training optimization is important in EH communication systems. In particular, it will be shown that for short block lengths, training optimization is critical. In contrast, for long block lengths, the optimal training period is not too sensitive to the value of the block length nor to the energy profile. Therefore, a properly selected fixed training period value can be used.Comment: 6 pages, 5 figures, Globecom 201

Scalable Coordinated Beamforming for Dense Wireless Cooperative Networks

To meet the ever growing demand for both high throughput and uniform coverage in future wireless networks, dense network deployment will be ubiquitous, for which co- operation among the access points is critical. Considering the computational complexity of designing coordinated beamformers for dense networks, low-complexity and suboptimal precoding strategies are often adopted. However, it is not clear how much performance loss will be caused. To enable optimal coordinated beamforming, in this paper, we propose a framework to design a scalable beamforming algorithm based on the alternative direction method of multipliers (ADMM) method. Specifically, we first propose to apply the matrix stuffing technique to transform the original optimization problem to an equivalent ADMM-compliant problem, which is much more efficient than the widely-used modeling framework CVX. We will then propose to use the ADMM algorithm, a.k.a. the operator splitting method, to solve the transformed ADMM-compliant problem efficiently. In particular, the subproblems of the ADMM algorithm at each iteration can be solved with closed-forms and in parallel. Simulation results show that the proposed techniques can result in significant computational efficiency compared to the state- of-the-art interior-point solvers. Furthermore, the simulation results demonstrate that the optimal coordinated beamforming can significantly improve the system performance compared to sub-optimal zero forcing beamforming

Dynamic Computation Offloading for Mobile-Edge Computing with Energy Harvesting Devices

Mobile-edge computing (MEC) is an emerging paradigm to meet the ever-increasing computation demands from mobile applications. By offloading the computationally intensive workloads to the MEC server, the quality of computation experience, e.g., the execution latency, could be greatly improved. Nevertheless, as the on-device battery capacities are limited, computation would be interrupted when the battery energy runs out. To provide satisfactory computation performance as well as achieving green computing, it is of significant importance to seek renewable energy sources to power mobile devices via energy harvesting (EH) technologies. In this paper, we will investigate a green MEC system with EH devices and develop an effective computation offloading strategy. The execution cost, which addresses both the execution latency and task failure, is adopted as the performance metric. A low-complexity online algorithm, namely, the Lyapunov optimization-based dynamic computation offloading (LODCO) algorithm is proposed, which jointly decides the offloading decision, the CPU-cycle frequencies for mobile execution, and the transmit power for computation offloading. A unique advantage of this algorithm is that the decisions depend only on the instantaneous side information without requiring distribution information of the computation task request, the wireless channel, and EH processes. The implementation of the algorithm only requires to solve a deterministic problem in each time slot, for which the optimal solution can be obtained either in closed form or by bisection search. Moreover, the proposed algorithm is shown to be asymptotically optimal via rigorous analysis. Sample simulation results shall be presented to verify the theoretical analysis as well as validate the effectiveness of the proposed algorithm.Comment: 33 pages, 11 figures, submitted to IEEE Journal on Selected Areas in Communication