Status of the Super-B factory Design

The SuperB international team continues to optimize the design of an electron-positron collider, which will allow the enhanced study of the origins of flavor physics. The project combines the best features of a linear collider (high single-collision luminosity) and a storage-ring collider (high repetition rate), bringing together all accelerator physics aspects to make a very high luminosity of 10$^{36}$ cm$^{-2}$ sec$^{-1}$. This asymmetric-energy collider with a polarized electron beam will produce hundreds of millions of B-mesons at the $\Upsilon$(4S) resonance. The present design is based on extremely low emittance beams colliding at a large Piwinski angle to allow very low $\beta_y^\star$ without the need for ultra short bunches. Use of crab-waist sextupoles will enhance the luminosity, suppressing dangerous resonances and allowing for a higher beam-beam parameter. The project has flexible beam parameters, improved dynamic aperture, and spin-rotators in the Low Energy Ring for longitudinal polarization of the electron beam at the Interaction Point. Optimized for best colliding-beam performance, the facility may also provide high-brightness photon beams for synchrotron radiation applications

Positron Production and Capture based on Low Energy Electrons for SuperB

TUPEB057International audienceProviding a high quality and sufficient high current positron beam for the ultra high luminosity B-factory SuperB is a major goal. In this paper a proposition for positrons production and capture scheme based on low energy electrons up to1 GeV is presented. For this technique, several types of flux concentrator used to capture the positrons are being studied. The following accelerating section bringing the positrons up to 280 MeV and the total yield for L-band and S-band type accelerators are given. Also the result of the benchmark between ASTRA and a LAL code based on Geant4 toolkit simulation is discussed

The PLASMONX Project for advanced beam physics experiments

The Project PLASMONX is well progressing into its design phase and has entered as well its second phase of procurements for main components. The project foresees the installation at LNF of a Ti:Sa laser system (peak power > 170 TW), synchronized to the high brightness electron beam produced by the SPARC photo-injector. The advancement of the procurement of such a laser system is reported, as well as the construction plans of a new building at LNF to host a dedicated laboratory for high intensity photon beam experiments (High Intensity Laser Laboratory). Several experiments are foreseen using this complex facility, mainly in the high gradient plasma acceleration field and in the field of mono- chromatic ultra-fast X-ray pulse generation via Thomson back-scattering. Detailed numerical simulations have been carried out to study the generation of tightly focused electron bunches to collide with laser pulses in the Thomson source: results on the emitted spectra of X-rays are presented

Commissioning Status of the CTF3 Delay Loop

The CLIC Test Facility CTF3, built at CERN by an international collaboration, aims at demonstrating the linear collider by 2010. In particular, one of the main goals is to study the generation of high-current electron pulses by interleaving bunch trains in delay lines and rings using transverse RF deflectors. This will be done in the 42 m long delay loop, built under the responsibility of INFN/LNF, and the 84 m long combiner ring that will follow it. The delay loop installation was completed and its commissioning started at the end of 2005. In this paper the commissioning results are presented, including the first tests of beam recombination

AGILE detection of delayed gamma-ray emission from GRB 080514B

GRB 080514B is the first gamma ray burst (GRB), since the time of EGRET, for which individual photons of energy above several tens of MeV have been detected with a pair-conversion tracker telescope. This burst was discovered with the Italian AGILE gamma-ray satellite. The GRB was localized with a cooperation by AGILE and the interplanetary network (IPN). The gamma-ray imager (GRID) estimate of the position, obtained before the SuperAGILE-IPN localization, is found to be consistent with the burst position. The hard X-ray emission observed by SuperAGILE lasted about 7 s, while there is evidence that the emission above 30 MeV extends for a longer duration (at least ~13 s). Similar behavior was seen in the past from a few other GRBs observed with EGRET. However, the latter measurements were affected, during the brightest phases, by instrumental dead time effects, resulting in only lower limits to the burst intensity. Thanks to the small dead time of the AGILE/GRID we could assess that in the case of GRB 080514B the gamma-ray to X-ray flux ratio changes significantly between the prompt and extended emission phase.Comment: A&A letters, in pres

AGILE observation of a gamma-ray flare from the blazar 3C 279

Context. We report the detection by the AGILE satellite of an intense gamma-ray flare from the gamma-ray source 3EG J1255-0549, associated to the Flat Spectrum Radio Quasar 3C 279, during the AGILE pointings towards the Virgo Region on 2007 July 9-13. Aims. The simultaneous optical, X-ray and gamma-ray covering allows us to study the spectral energy distribution (SED) and the theoretical models relative to the flaring episode of mid-July. Methods. AGILE observed the source during its Science Performance Verification Phase with its two co-aligned imagers: the Gamma- Ray Imaging Detector (GRID) and the hard X-ray imager (Super-AGILE) sensitive in the 30 MeV - 50 GeV and 18 - 60 keV respectively. During the AGILE observation the source was monitored simultaneously in optical band by the REM telescope and in the X-ray band by the Swift satellite through 4 ToO observations. Results. During 2007 July 9-13 July 2007, AGILE-GRID detected gamma-ray emission from 3C 279, with the source at ~2 deg from the center of the Field of View, with an average flux of (210+-38) 10^-8 ph cm^-2 s^-1 for energy above 100 MeV. No emission was detected by Super-AGILE, with a 3-sigma upper limit of 10 mCrab. During the observation lasted about 4 days no significative gamma-ray flux variation was observed. Conclusions. The Spectral Energy Distribution is modelled with a homogeneous one-zone Synchrotron Self Compton emission plus the contributions by external Compton scattering of direct disk radiation and, to a lesser extent, by external Compton scattering of photons from the Broad Line Region.Comment: Accepted for publication in Astronomy and Astrophysic

Instrumentation for Longitudinal Beam Gymnastics in FEL's and at the CLIC Test Facility 3

Built at CERN by an international collaboration, the CLIC Test Facility 3 (CTF3) aims at demonstrating the feasibility of a high luminosity 3 TeV e+-e- collider by the year 2010. One of the main issues to be demonstrated is the generation of a high average current (30 A) high frequency (12 GHz) bunched beam by means of RF manipulation. At the same time, Free Electron Lasers (FEL) are developed in several places all over the world with the aim of providing high brilliance photon sources. These machines rely on the production of high peak current electron bunches. The required performances put high demands on the diagnostic equipment and innovative longitudinal monitors have been developed during the past years. This paper gives an overview of the longitudinal instrumentation developed at ELETTRA and CTF3, where a special effort was made in order to implement at the same time non-intercepting devices for online monitoring, and destructive diagnostics which have the advantage of providing more detailed information

A study of the prompt and afterglow emission of the Short GRB 061201

Our knowledge of the intrinsic properties of short duration Gamma-Ray Bursts has relied, so far, only upon a few cases for which the estimate of the distance and an extended, multiwavelength monitoring of the afterglow have been obtained. We carried out multiwavelength observations of the short GRB 061201 aimed at estimating its distance and studying its properties. We performed a spectral and timing analysis of the prompt and afterglow emission and discuss the results in the context of the standard fireball model. A clear temporal break was observed in the X-ray light curve about 40 minutes after the burst trigger. We find that the spectral and timing behaviour of the X-ray afterglow is consistent with a jet origin of the observed break, although the optical data can not definitively confirm this and other scenarios are possible. No underlying host galaxy down to R~26 mag was found after fading of the optical afterglow. Thus, no secure redshift could be measured for this burst. The nearest galaxy is at z=0.111 and shows evidence of star formation activity. We discuss the association of GRB 061201 with this galaxy and with the ACO S 995 galaxy cluster, from which the source is at an angular distance of 17'' and 8.5', respectively. We also test the association with a possible undetected, positionally consistent galaxy at z~1. In all these cases, in the jet interpretation, we find a jet opening angle of 1-2 degrees.Comment: 10 pages, 7 figures, accepted for publication in A&

Baseline Design of the SuperB Factory Injection System

TUPPR088International audienceThe injection complex of the SuperB, B-factory project of INFN consists of a polarized electron gun, a positron production system, electron and positron linac sections, a positron damping ring and the transfer lines connecting these systems and the collider main rings. To keep the ultra high luminosity nearly constant, continuous injection of 4 GeV electrons and 7 GeV positrons in both Low Energy Ring (LER) and High Energy Ring (HER) is necessary. In this paper we describe the baseline design and the beam dynamics studies performed to evaluate the system performance