The Molecularly Imprinted Polymers. Influence of Monomers on The Properties of Polymers - A Review

The synthesis of MIPs for two types of templates (herbicides, and flavonoids) and their application in analytical chemistry are discussed. Particular attention has been paid the issue of bonding the template and selection of appropriate monomer in different types of compounds. This short review aims at presenting the molecular imprinting technology (MIT) which is considered as an attractive method to produce impressive receptors for application in analytical chemistry. The challenge of designing and synthesizing a molecularly imprinted polymer (MIP) can be a daunting prospect to the uninitiated practitioner, simply because of the number of experimental variables involved, e.g. the nature and levels of template, functional monomers, cross-linkers, solvents, initiators and even the method of initiation and the duration of polymerization. Indubitably, the most important place of the polymer is its quotheartquot or the cavity corresponding to the template and the waynbs

Influence of Zn excess on compositional, structural and vibrational properties of Cu2ZnSn0.5Ge0.5Se4 thin films and their effect on solar cell efficiency

This Accepted Manuscript will be available for reuse under a CC BY-NC-ND licence after 24 months of embargo periodThe effect of Zn content on compositional, structural and vibrational properties of Cu2ZnSn1-xGexSe4 (CZTGSe, x ~ 0.5) thin films is studied. Kesterite layer is deposited by co-evaporation onto 5 × 5 cm2 Mo/SLG substrate followed by a thermal treatment at maximum temperature of 480 °C, obtaining areas with different composition and morphology which are due to the sample position in the co-evaporation system and to the non-uniform temperature distribution across the substrate. Kesterite layers with higher Zn amounts are characterized by lower Cu and Ge contents; however, a uniform Ge distribution through the absorber layer is detected in all cases. The excess Zn concentration leads to the formation of ZnSe secondary phase on the surface and in the bulk of the absorber as determined by Raman spectroscopy. When higher Ge content and no ZnSe are present in the absorber layer, a compact structure is formed with larger grain size of kesterite. This effect could explain the higher Voc of the solar cell. The Zn content does not affect the bandgap energy significantly (Eg near 1.3 eV), although the observed effect of Zn excess in CZTGSe results in a decreased device performance from 6.4 to 4.2%. This investigation reveals the importance of the control of the off-stoichiometric CZTGSe composition during the deposition process to enhance solar cells propertiesThis work was supported by Spanish Ministry of Science, Innovation and Universities Project WINCOST (ENE2016-80788-C5-2-R) and European Project INFINITE CELL (H2020-MSCA-RISE-2017-777968). ARP also acknowledges financial support from Community of Madrid within Youth Employment Program (PEJD-2017-PRE/IND-4062). MG acknowledges the financial support from ACCIÓ-Generalitat de Catalunya within the TECNIOspring Plus fellowship (TECSPR18-1-0048

Dysfunctional telomeres in primary cells from Fanconi anemia FANCD2 patients

© 2012 Joksic et al. This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/2.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.This article has been made available through the Brunel Open Access Publishing Fund.Background: Fanconi anemia (FA) is characterized by sensitivity to DNA cross-linking agents, mild cellular, and marked clinical radio sensitivity. In this study we investigated telomeric abnormalities of non-immortalized primary cells (lymphocytes and fibroblasts) derived from FA patients of the FA-D2 complementation group, which provides a more accurate physiological assessment than is possible with transformed cells or animal models. Results: We analyzed telomere length, telomere dysfunction-induced foci (TIFs), sister chromatid exchanges (SCE), telomere sister chromatid exchanges (T-SCE), apoptosis and expression of shelterin components TRF1 and TRF2. FANCD2 lymphocytes exhibited multiple types of telomeric abnormalities, including premature telomere shortening, increase in telomeric recombination and aberrant telomeric structures ranging from fragile to long-string extended telomeres. The baseline incidence of SCE in FANCD2 lymphocytes was reduced when compared to control, but in response to diepoxybutane (DEB) the 2-fold higher rate of SCE was observed. In contrast, control lymphocytes showed decreased SCE incidence in response to DEB treatment. FANCD2 fibroblasts revealed a high percentage of TIFs, decreased expression of TRF1 and invariable expression of TRF2. The percentage of TIFs inversely correlated with telomere length, emphasizing that telomere shortening is the major reason for the loss of telomere capping function. Upon irradiation, a significant decrease of TIFs was observed at all recovery times. Surprisingly, a considerable percentage of TIF positive cells disappeared at the same time when incidence of γ-H2AX foci was maximal. Both FANCD2 leucocytes and fibroblasts appeared to die spontaneously at higher rate than control. This trend was more evident upon irradiation; the percentage of leucocytes underwent apoptosis was 2.59- fold higher than that in control, while fibroblasts exhibited a 2- h delay before entering apoptosis. Conclusion: The results of our study showed that primary cells originating from FA-D2 patients display shorten telomeres, elevated incidence of T-SCEs and high frequency of TIFs. Disappearance of TIFs in early response to irradiation represent distinctive feature of FANCD2 cells that should be examined further.This article is made available through the Brunel Open Access Publishing Fund. This work was supported by the Ministry of Education and Science of the Republic of Serbia (Project No.173046)

Spectroscopic ellipsometry study of Cu2ZnSnS4 bulk poly-crystals

The linear optical properties of Cu2ZnSnS4 bulk poly-crystals have been investigated using spectroscopic ellipsometry in the range of 1.2-4.6 eV at room temperature. The characteristic features identified in the optical spectra are explained by using the Adachi analytical model for the interband transitions at the corresponding critical points in the Brillouin zone. The experimental data have been modeled over the entire spectral range taking into account the lowest E0 transition near the fundamental absorption edge and E1A and E1B higher energy interband transitions. In addition, the spectral dependences of the refractive index, extinction coefficient, absorption coefficient, and normal-incidence reflectivity values have been accurately determined and are provided since they are essential data for the design of Cu2ZnSnS4 based optoelectronic devicesThe research leading to the presented results was partially supported by the European Project INFINITE-CELL (Ref. H2020-MSCA-RISE-2017-777968, 2017–2021, www.infinitecell.eu) and the Spanish MINECO Projects “WINCOST” (ENE2016-80788-C5-2-R) and PHOTOMANA (TEC2015- 69916-C2-1-R). The authors from the Institute of Applied Physics appreciate the financial support from STCU 6224 and from the Institutional Project No. CSSDT 15.817.02.04

Kesterite thin films of Cu2ZnSnS4 obtained by spray pyrolysis

Thin films of Cu2ZnSnS4 CZTS were deposited using the spray pyrolysis method as relatively fast and vacuum free method. Obtained samples were analyzed using the X Ray Fluorescence, grazing incidence X Ray Diffraction and Raman Spectroscopy techniques. Analysis showed close to stoichiometry composition of the films with kesterite type structure but poor crystalline quality and possible existence of secondary phases. To improve the quality of the films, the as prepared layers were annealed in the presence of elemental Sn and S. Comparison of the results before and after annealing showed a strong improvement of the crystalline quality and a significant reduction of concentration of secondary phases of the films without significant change of composition. The measured optical band gap is equal to 1.52 and 1.55 eV in the as prepared and annealed films, respectively. The optical absorption coefficient is found to be gt; 10 4 cm

Genetics of decayed sexual traits in a parasitoid wasp with endosymbiont-induced asexuality.

Trait decay may occur when selective pressures shift, owing to changes in environment or life style, rendering formerly adaptive traits non-functional or even maladaptive. It remains largely unknown if such decay would stem from multiple mutations with small effects or rather involve few loci with major phenotypic effects. Here, we investigate the decay of female sexual traits, and the genetic causes thereof, in a transition from haplodiploid sexual reproduction to endosymbiont-induced asexual reproduction in the parasitoid wasp Asobara japonica. We take advantage of the fact that asexual females cured of their endosymbionts produce sons instead of daughters, and that these sons can be crossed with sexual females. By combining behavioral experiments with crosses designed to introgress alleles from the asexual into the sexual genome, we found that sexual attractiveness, mating, egg fertilization and plastic adjustment of offspring sex ratio (in response to variation in local mate competition) are decayed in asexual A. japonica females. Furthermore, introgression experiments revealed that the propensity for cured asexual females to produce only sons (because of decayed sexual attractiveness, mating behavior and/or egg fertilization) is likely caused by recessive genetic effects at a single locus. Recessive effects were also found to cause decay of plastic sex-ratio adjustment under variable levels of local mate competition. Our results suggest that few recessive mutations drive decay of female sexual traits, at least in asexual species deriving from haplodiploid sexual ancestors

Cholesterol efflux promoting function of high-density lipoproteins in calcific aortic valve stenosis

Background and aims: Cholesterol efflux capacity is a functional property of high-density lipoproteins (HDL) reflecting the efficiency of the atheroprotective reverse cholesterol transport process in humans. Its relationship with calcific aortic valve stenosis (CAVS) has not been fully assessed yet. Methods: We evaluated HDL-CEC in a patient population with varying degrees of aortic valvular calcific disease, assessed using echocardiography and cardiac computed tomography. Measurement of biomarkers that reflect osteogenic and tissue remodeling, along with dietary and gut microbiota-derived metabolites were performed. Results: Patients with moderate-severe CAVS had significantly lower HDL-CEC compared to both control and aortic sclerosis subjects (mean: 6.09%, 7.32% and 7.26%, respectively). HDL-CEC displayed negative correlations with peak aortic jet velocity and aortic valve calcium score, indexes of CAVS severity (ρ = -0.298, p = 0.002 and ρ = -0.358, p = 0.005, respectively). In multivariable regression model, HDL-CEC had independent association with aortic valve calcium score (B: -0.053, SE: 0.014, p < 0.001), GFR (B: -0.034, SE: 0.012, p = 0.007), as well as with levels of total cholesterol (B: 0.018, SE: 0.005, p = 0.002). Conclusion: These results indicate an impairment of HDL-CEC in moderate-severe CAVS and may contribute to identify potential novel targets for CAVS management

Combinatorial Analysis Methodologies for Accelerated Research: The Case of Chalcogenide Thin-Film Photovoltaic Technologies

One of the fastest ways for the discovery, understanding, development, and further optimization of new complex materials is the application of combinatorial analysis methodologies, which have already shown impressive results for different organic and inorganic materials, leading to the fast development of different scientific fields and industrial applications. However, in the case of thin-film materials for optoelectronic devices and, in particular, for second-generation photovoltaic (PV) devices, the application of combinatorial analysis is still quite uncommon with a desultory rather than systematic application. The present review discusses the main constraints for the application of combinatorial analysis to thin-film materials with a focus on chalcogenide compounds and different strategies to overcome them. Special attention is paid to the requirements for the preparation of graded thin films, characterization, and analysis of the results, providing different hints for the implementation of high-quality combinatorial analysis. Finally, an overview of the currently published results in the field of chalcogenide thin-film PV technologies is presented, showing the relevance of the combinatorial approach for boosting the development not only of this promising PV technology, but also of other optoelectronic devices based on complex materials and multilayered structures

Challenges and improvement pathways to develop quasi-1D (Sb1-xBix)2Se3-based materials for optically tuneable photovoltaic applications. Towards chalcogenide narrow-bandgap devices

Quasi-1D chalcogenides have shown great promises in the development of emerging photovoltaic technologies. However, most quasi-1D semiconductors other than Sb2Se3 and Sb2S3 have been seldom investigated for energy generation applications. Indeed, cationic or anionic alloying strategies allow changing the bandgap of these materials, opening the door to the development of an extended range of chalcogenides with tuneable optical and electrical properties. In this work, Bi incorporation into the Sb2Se3 structure has been proved as an effective approach to modulate the bandgap between <1.0 eV and 1.3 eV, demonstrating conversion efficiencies between 3 and 5% for 0.01 < x ≤ 0.10. However, there is a noticeable deterioration in optoelectronic parameters for x > 0.1. In order to better understand the underlying mechanisms leading to the formation of (Sb1-xBix)2Se3, and thus design specific strategies to enhance its properties, thin films with different annealing time and temperature have been synthesized and characterized. Interestingly, it has been observed that Sb2Se3 and Bi2Se3 are formed first, with Bi melting at 300 °C and diffusing rapidly towards the surface of the film. At higher temperature, the binary compounds combine to form the solid solution, however as the dwell time increases, (Sb1-xBix)2Se3 decomposes again into Bi2Se3 and Sb. This study has shown that the material is essentially limited by compositional disorder and recombination via defects. Likewise, routes have been proposed to improve morphology and uniformity of the layer, achieving efficiencies higher than 1% for x > 0.2

Optical properties of Cu2ZnGeSe4

Sursa: Conferința –"Materials Science and Condensed Matter Physics", Chișinău, Moldova, 11-14 septembrie 2012.→ https://ibn.idsi.md/collection_view/483Cu2ZnGeSe4 (CZGSe) is interesting and promising p-type semiconductor materials for optoelectronics applications and solar cells. In this paper we present reflectivity spectra measured at 300 K in the photon energy range of 1.5 - 6 eV. CZGSe crystals were grown by one-temperature method