Role of charge carriers for ferromagnetism in cobalt-doped rutile TiO2

Electric and magnetic properties of a high temperature ferromagnetic oxide semiconductor, cobalt-doped rutile TiO2, are summarized. The cobalt-doped rutile TiO2 epitaxial thin films with different electron densities and cobalt contents were grown on r-sapphire substrates with laser molecular beam epitaxy. Results of magnetization, magnetic circular dichroism, and anomalous Hall effect measurements were examined for samples with systematically varied electron densities and cobalt contents. The samples with high electron densities and cobalt contents show the high temperature ferromagnetism, suggesting that charge carriers induce the ferromagnetism.Comment: 14 pages, 12 figure

Electrical transport and optical studies of ferromagnetic Cobalt doped ZnO nanoparticles exhibiting a metal-insulator transition

The observed correlation of oxygen vacancies and room temperature ferromagnetic ordering in Co doped ZnO1-o nanoparticles reported earlier (Naeem et al Nanotechnology 17, 2675-2680) has been further explored by transport and optical measurements. In these particles room temperature ferromagnetic ordering had been observed to occur only after annealing in forming gas. In the current work the optical properties have been studied by diffuse reflection spectroscopy in the UV-Vis region and the band gap of the Co doped compositions has been found to decrease with Co addition. Reflections minima are observed at the energies characteristic of Co+2 d-d (tethrahedral symmetry) crystal field transitions, further establishing the presence of Co in substitutional sites. Electrical transport measurements on palletized samples of the nanoparticles show that the effect of a forming gas is to strongly decrease the resistivity with increasing Co concentration. For the air annealed and non-ferromagnetic samples the variation in the resistivity as a function of Co content are opposite to those observed in the particles prepared in forming gas. The ferromagnetic samples exhibit an apparent change from insulator to metal with increasing temperatures for T>380K and this change becomes more pronounced with increasing Co content. The magnetic and resistive behaviors are correlated by considering the model by Calderon et al [M. J. Calderon and S. D. Sarma, Annals of Physics 2007 (Accepted doi: 10.1016/j.aop.2007.01.010] where the ferromagnetism changes from being mediated by polarons in the low temperature insulating region to being mediated by the carriers released from the weakly bound states in the higher temperature metallic region.Comment: 7 pages, 6 figure

Bulk and Surface Magnetization of Co atoms in Rutile Ti_[1-x]Co_xO_[2-delta] Thin Films Revealed by X-Ray Magnetic Circular Dichroism

We have studied magnetism in Ti_[1-x]Co_xO_[2-\delta] thin films with various x and \delta by soft x-ray magnetic circular dichroism (XMCD) measurements at the Co L_[2,3] absorption edges. The estimated ferromagnetic moment by XMCD was 0.15-0.24 \mu\beta/Co in the surface, while in the bulk it was 0.82-2.25 \mu\beta/Co, which is in the same range as the saturation magnetization of 1.0-1.5 \mu\beta/Co. Theseresults suggest that the intrinsic origin of the erromagnetism. The smaller moment of Co atom at surface is an indication of a magnetically dead layer of a few nm thick at the surface of the thin films.Comment: This Paper is accepted in J. of Phys: Conds. Matte

Ab initio study of magnetism at the TiO2/LaAlO3 interface

In this paper we study the possible relation between the electronic and magnetic structure of the TiO2/LaAlO3 interface and the unexpected magnetism found in undoped TiO2 films grown on LaAlO$_3$. We concentrate on the role played by structural relaxation and interfacial oxygen vacancies. LaAlO3 has a layered structure along the (001) direction with alternating LaO and AlO2 planes, with nominal charges of +1 and -1, respectively. As a consequence of that, an oxygen deficient TiO2 film with anatase structure will grow preferently on the AlO2 surface layer. We have therefore performed ab-initio calculations for superlattices with TiO2/AlO2 interfaces with interfacial oxygen vacancies. Our main results are that vacancies lead to a change in the valence state of neighbour Ti atoms but not necessarily to a magnetic solution and that the appearance of magnetism depends also on structural details, such as second neighbor positions. These results are obtained using both the LSDA and LSDA+U approximations.Comment: Accepted for publication in Journal of Materials Scienc

Neuroretinal hypoxic signaling in a new preclinical murine model for proliferative diabetic retinopathy

Diabetic retinopathy (DR) affects approximately one-third of diabetic patients and, if left untreated, progresses to proliferative DR (PDR) with associated vitreous hemorrhage, retinal detachment, iris neovascularization, glaucoma and irreversible blindness. In vitreous samples of human patients with PDR, we found elevated levels of hypoxia inducible factor 1 alpha (HIF1α). HIFs are transcription factors that promote hypoxia adaptation and have important functional roles in a wide range of ischemic and inflammatory diseases. To recreate the human PDR phenotype for a preclinical animal model, we generated a mouse with neuroretinal-specific loss of the von Hippel Lindau tumor suppressor protein, a protein that targets HIF1α for ubiquitination. We found that the neuroretinal cells in these mice overexpressed HIF1α and developed severe, irreversible ischemic retinopathy that has features of human PDR. Rapid progression of retinopathy in these mutant mice should facilitate the evaluation of therapeutic agents for ischemic and inflammatory blinding disorders. In addition, this model system can be used to manipulate the modulation of the hypoxia signaling pathways, for the treatment of non-ocular ischemic and inflammatory disorders

Circulating adrenomedullin estimates survival and reversibility of organ failure in sepsis: the prospective observational multinational Adrenomedullin and Outcome in Sepsis and Septic Shock-1 (AdrenOSS-1) study

Background: Adrenomedullin (ADM) regulates vascular tone and endothelial permeability during sepsis. Levels of circulating biologically active ADM (bio-ADM) show an inverse relationship with blood pressure and a direct relationship with vasopressor requirement. In the present prospective observational multinational Adrenomedullin and Outcome in Sepsis and Septic Shock 1 (, AdrenOSS-1) study, we assessed relationships between circulating bio-ADM during the initial intensive care unit (ICU) stay and short-term outcome in order to eventually design a biomarker-guided randomized controlled trial. Methods: AdrenOSS-1 was a prospective observational multinational study. The primary outcome was 28-day mortality. Secondary outcomes included organ failure as defined by Sequential Organ Failure Assessment (SOFA) score, organ support with focus on vasopressor/inotropic use, and need for renal replacement therapy. AdrenOSS-1 included 583 patients admitted to the ICU with sepsis or septic shock. Results: Circulating bio-ADM levels were measured upon admission and at day 2. Median bio-ADM concentration upon admission was 80.5 pg/ml [IQR 41.5-148.1 pg/ml]. Initial SOFA score was 7 [IQR 5-10], and 28-day mortality was 22%. We found marked associations between bio-ADM upon admission and 28-day mortality (unadjusted standardized HR 2.3 [CI 1.9-2.9]; adjusted HR 1.6 [CI 1.1-2.5]) and between bio-ADM levels and SOFA score (p < 0.0001). Need of vasopressor/inotrope, renal replacement therapy, and positive fluid balance were more prevalent in patients with a bio-ADM > 70 pg/ml upon admission than in those with bio-ADM ≤ 70 pg/ml. In patients with bio-ADM > 70 pg/ml upon admission, decrease in bio-ADM below 70 pg/ml at day 2 was associated with recovery of organ function at day 7 and better 28-day outcome (9.5% mortality). By contrast, persistently elevated bio-ADM at day 2 was associated with prolonged organ dysfunction and high 28-day mortality (38.1% mortality, HR 4.9, 95% CI 2.5-9.8). Conclusions: AdrenOSS-1 shows that early levels and rapid changes in bio-ADM estimate short-term outcome in sepsis and septic shock. These data are the backbone of the design of the biomarker-guided AdrenOSS-2 trial. Trial registration: ClinicalTrials.gov, NCT02393781. Registered on March 19, 2015

Yb- and Er-doped fiber laser Q-switched with an optically uniform, broadband WS2 saturable absorber.

We demonstrate a ytterbium (Yb) and an erbium (Er)-doped fiber laser Q-switched by a solution processed, optically uniform, few-layer tungsten disulfide saturable absorber (WS2-SA). Nonlinear optical absorption of the WS2-SA in the sub-bandgap region, attributed to the edge-induced states, is characterized by 3.1% and 4.9% modulation depths with 1.38 and 3.83 MW/cm(2) saturation intensities at 1030 and 1558 nm, respectively. By integrating the optically uniform WS2-SA in the Yb- and Er-doped laser cavities, we obtain self-starting Q-switched pulses with microsecond duration and kilohertz repetition rates at 1030 and 1558 nm. Our work demonstrates broadband sub-bandgap saturable absorption of a single, solution processed WS2-SA, providing new potential efficacy for WS2 in ultrafast photonic applications.The authors thank E. J. R. Kelleher for valuable discussions. MZ acknowledges support from Beihang University, China, through a Zhuoyue Bairen Program and TH from the Royal Academy of Engineering through a fellowship (Graphlex). This work at Beihang University was supported by 973 Program (2012CB315601), NSFC (61221061/61435002) and the Fundamental Research Funds for the Central Universities.This is the final version of the article. It was first available from NPG via http://dx.doi.org/10.1038/srep1748

Interstellar dust measured in situ by Ulysses: New aspects of the particle size distribution and its modulation by the heliosheath

Interstellar dust (ISD) enters the heliosphere from the direction of its nose. It is first modulated by the heliosheath and then the inner heliosphere before it is measured by the dust detectors on board of spacecraft, for example on Ulysses. Various criteria exist to distinguish ISD from the dust of other sources, and different methods exist to determine the particle masses and impact speeds from the measurements

Surface Roughness and Color Stability of Conventional and Bulk-Fill Resin Composite with S-PRG Fillers After Coffee Exposure: An in-vitro Study

Fabiano Augusto Dos Santos Janisch,1 Milagros Falcon Aguilar,2 Flávio Henrique Baggio Aguiar,2 Fabiana Mantovani Gomes França,1 Roberta Tarkany Basting,1 Waldemir Francisco Vieira-Junior2 1Department of Restorative Dentistry, Faculdade São Leopoldo Mandic, Campinas, SP, Brazil; 2Department of Restorative Dentistry, Faculdade de Odontologia de Piracicaba, Universidade Estadual de Campinas, Piracicaba, SP, BrazilCorrespondence: Waldemir Francisco Vieira-Junior, Faculdade de Odontologia de Piracicaba, Universidade, Estadual de Campinas, Av. Limeira, 901 – Areião, Piracicaba, SP, Brazil, Tel +55 (19) 21065220, Email [email protected]: This study aimed to evaluate the in vitro effects of coffee exposure on the color and roughness of conventional and bulk-fill resin composites, with and without surface pre-reacted glass-ionomer (S-PRG) filler.Methodology: Forty-eight cylindrical samples (Ø 6 mm × 2 mm) were prepared and categorized as follows (n = 12 per group): conventional nano-hybrid (Tetric N-Ceram, Ivoclar); nano-hybrid with S-PRG filler (Beautifil II, Shofu); bulk-fill (Tetric N-Ceram Bulk Fill, Ivoclar); and bulk-fill with S-PRG filler (Beautifil Bulk Restorative, Shofu). The samples were assessed for surface roughness (Ra, μm), color coordinates (CIE Lab), and overall color change (ΔEab, ΔE00). Measurements were taken at baseline and after 7 days of coffee immersion (pH = 4.95). Data were analyzed using generalized linear models, Kruskal–Wallis, Dunn, and paired Wilcoxon tests (α = 0.05).Results: After the coffee exposure, all resin composites exhibited a significant decrease in L&ast; (towards black), an increase in a&ast; (towards red), an increase in b&ast; (towards yellow), and a higher Vita color score (p < 0.05). Tetric N-Ceram demonstrated the lowest roughness values post-exposure; however, a significant increase in roughness over time was observed only for Tetric N-Ceram Bulk Fill (p < 0.05). For ΔEab, Beautifil Bulk Restorative and Tetric N-Ceram showed higher values compared to Beautifil II. For ΔE00, a significant difference was noted between Beautifil Bulk Restorative and Beautifil II (p < 0.05).Conclusion: Resin composites with S-PRG fillers exhibited similar pigmentation dynamics to conventional composite but showed greater surface roughness after exposure to coffee. Considering the S-PRG materials, the bulk-fill version is more susceptible to staining.Keywords: composite resins, coffee, color, surface propertie