60 research outputs found
Imaging material properties of biological samples with a Force Feedback Microscope
Mechanical properties of biological samples have been imaged with a
\textit{Force Feedback Microscope}. Force, force gradient and dissipation are
measured simultaneously and quantitatively, merely knowing the AFM cantilever
spring constant. Our first results demonstrate that this robust method provides
quantitative high resolution force measurements of the interaction The little
oscillation imposed to the cantilever and the small value of its stiffness
result in a vibrational energy much smaller than the thermal energy, reducing
the interaction with the sample to a minimum. We show that the observed
mechanical properties of the sample depend on the force applied by the tip and
consequently on the sample indentation.
Moreover, the frequency of the excitation imposed to the cantilever can be
chosen arbitrarily, opening the way to frequency-dependent studies in
biomechanics, sort of spectroscopic AFM investigations
Spectroscopic investigation of local mechanical impedance of living cells
The mechanical properties of PC12 living cells have been studied at the
nanoscale with a Force Feedback Microscope using two experimental approaches.
Firstly, the local mechanical impedance of the cell membrane has been mapped
simultaneously to the cell morphology at constant force. As the force of the
interaction is gradually increased, we observed the appearance of the
sub-membrane cytoskeleton. We shall compare the results obtained with this
method with the measurement of other existing techniques. Secondly, a
spectroscopic investigation has been performed varying the indentation of the
tip in the cell membrane and consequently the force applied on it. In contrast
with conventional dynamic atomic force microscopy techniques, here the small
oscillation amplitude of the tip is not necessarily imposed at the cantilever
first eigenmode. This allows the user to arbitrarily choose the excitation
frequency in developing spectroscopic AFM techniques. The mechanical response
of the PC12 cell membrane is found to be frequency dependent in the 1 kHz - 10
kHz range. The damping coefficient is reproducibly observed to decrease when
the excitation frequency is increased.Comment: 8 pages, 8 figure
Local detection of X-ray spectroscopies with an in-situ AFM
The in situ combination of Scanning Probe Microscopies (SPM) with X-ray
microbeams adds a variety of new possibilities to the panoply of synchrotron
radiation techniques. In this paper we describe an optics-free AFM/STM that can
be directly installed on synchrotron radiation end stations for such combined
experiments. The instrument can be used just for AFM imaging of the
investigated sample or can be used for detection of photoemitted electrons with
a sharp STM-like tip, thus leading to the local measure of the X-ray absorption
signal. Alternatively one can can measure the flux of photon impinging on the
sharpest part of the tip to locally map the pattern of beams diffracted from
the sample. In this paper we eventually provide some examples of local
detection of XAS and diffraction
Effect of aliskiren on post-discharge outcomes among diabetic and non-diabetic patients hospitalized for heart failure: insights from the ASTRONAUT trial
Aims The objective of the Aliskiren Trial on Acute Heart Failure Outcomes (ASTRONAUT) was to determine whether aliskiren, a direct renin inhibitor, would improve post-discharge outcomes in patients with hospitalization for heart failure (HHF) with reduced ejection fraction. Pre-specified subgroup analyses suggested potential heterogeneity in post-discharge outcomes with aliskiren in patients with and without baseline diabetes mellitus (DM). Methods and results ASTRONAUT included 953 patients without DM (aliskiren 489; placebo 464) and 662 patients with DM (aliskiren 319; placebo 343) (as reported by study investigators). Study endpoints included the first occurrence of cardiovascular death or HHF within 6 and 12 months, all-cause death within 6 and 12 months, and change from baseline in N-terminal pro-B-type natriuretic peptide (NT-proBNP) at 1, 6, and 12 months. Data regarding risk of hyperkalaemia, renal impairment, and hypotension, and changes in additional serum biomarkers were collected. The effect of aliskiren on cardiovascular death or HHF within 6 months (primary endpoint) did not significantly differ by baseline DM status (P = 0.08 for interaction), but reached statistical significance at 12 months (non-DM: HR: 0.80, 95% CI: 0.64-0.99; DM: HR: 1.16, 95% CI: 0.91-1.47; P = 0.03 for interaction). Risk of 12-month all-cause death with aliskiren significantly differed by the presence of baseline DM (non-DM: HR: 0.69, 95% CI: 0.50-0.94; DM: HR: 1.64, 95% CI: 1.15-2.33; P < 0.01 for interaction). Among non-diabetics, aliskiren significantly reduced NT-proBNP through 6 months and plasma troponin I and aldosterone through 12 months, as compared to placebo. Among diabetic patients, aliskiren reduced plasma troponin I and aldosterone relative to placebo through 1 month only. There was a trend towards differing risk of post-baseline potassium ≥6 mmol/L with aliskiren by underlying DM status (non-DM: HR: 1.17, 95% CI: 0.71-1.93; DM: HR: 2.39, 95% CI: 1.30-4.42; P = 0.07 for interaction). Conclusion This pre-specified subgroup analysis from the ASTRONAUT trial generates the hypothesis that the addition of aliskiren to standard HHF therapy in non-diabetic patients is generally well-tolerated and improves post-discharge outcomes and biomarker profiles. In contrast, diabetic patients receiving aliskiren appear to have worse post-discharge outcomes. Future prospective investigations are needed to confirm potential benefits of renin inhibition in a large cohort of HHF patients without D
Design, recruitment and baseline results of the ITALUNG trial for lung cancer screening with low-dose CT.
- …
