Lasing from a single quantum wire

A laser with an active volume consisting of only a single quantum wire in the 1-dimensional (1-D) ground state is demonstrated. The single wire is formed quantum-mechanically at the T-intersection of a 14 nm Al_{0.07}Ga_{0.93}As quantum well and a 6 nm GaAs quantum well, and is embedded in a 1-D single-mode optical waveguide. We observe single-mode lasing from the quantum wire ground state by optical pumping. The laser operates from 5 to 60 K, and has a low threshold pumping power of 5 mW at 5 K.Comment: 4 pages including 4 figure

Canonical Formalism for a 2n-Dimensional Model with Topological Mass Generation

The four-dimensional model with topological mass generation that was found by Dvali, Jackiw and Pi has recently been generalized to any even number of dimensions (2n-dimensions) in a nontrivial manner in which a Stueckelberg-type mass term is introduced [S. Deguchi and S. Hayakawa, Phys. Rev. D 77, 045003 (2008), arXiv:0711.1446]. The present paper deals with a self-contained model, called here a modified hybrid model, proposed in this 2n-dimensional generalization and considers the canonical formalism for this model. For the sake of convenience, the canonical formalism itself is studied for a model equivalent to the modified hybrid model by following the recipe for treating constrained Hamiltonian systems. This formalism is applied to the canonical quantization of the equivalent model in order to clarify observable and unobservable particles in the model. The equivalent model (with a gauge-fixing term) is converted to the modified hybrid model (with a corresponding gauge-fixing term) in a Becchi-Rouet-Stora-Tyutin (BRST)-invariant manner. Thereby it is shown that the Chern-Pontryagin density behaves as an observable massive particle (or field). The topological mass generation is thus verified at the quantum-theoretical level.Comment: 29 pages, no figures, minor corrections, published versio

Imaging of emission patterns in a T-shaped quantum wire laser

Spatially and spectrally resolved microscopic images of spontaneous and stimulated emissions are imaged at the mirror facets of a GaAs T-shaped quantum wire laser with high uniformity. Laser emission from the one-dimensional ground state reveals a circular image located at the core of a T-shaped optical waveguide but significantly smaller in area than the low power spontaneous emission from the same waveguide. These images unambiguously allow assignment of all spontaneous and laser emissions to the wire ground state and respective intersecting wells in the structure.Comment: 4 pages, 3 figure

Superconductivity of the Sr2Ca12Cu24O41Sr_2 Ca_{12} Cu_{24} O_{41} spin ladder system: Are the superconducting pairing and the spin-gap formation of the same origin?

Pressure-induced superconductivity in a spin-ladder cuprate Sr$_2$Ca$_{12}$Cu$_{24}$O$_{41}$ has not been studied on a microscopic level so far although the superconductivity was already discovered in 1996. We have improved high-pressure technique with using a large high-quality crystal, and succeeded in studying the superconductivity using $^{63}$Cu nuclear magnetic resonance (NMR). We found that anomalous metallic state reflecting the spin-ladder structure is realized and the superconductivity possesses a s-wavelike character in the meaning that a finite gap exists in the quasi-particle excitation: At pressure of 3.5GPa we observed two excitation modes in the normal state from the relaxation rate $T_1^{-1}$. One gives rise to an activation-type component in $T_1^{-1}$, and the other $T$-linear component linking directly with the superconductivity. This gapless mode likely arises from free motion of holon-spinon bound states appearing by hole doping, and the pairing of them likely causes the superconductivity.Comment: to be published in Phys. Rev. Let

Survey of Period Variations of Superhumps in SU UMa-Type Dwarf Novae. VI: The Sixth Year (2013-2014)

Continuing the project described by Kato et al. (2009, PASJ, 61, S395, arXiv:0905.1757), we collected times of superhump maxima for 56 SU UMa-type dwarf novae mainly observed during the 2013-2014 season and characterized these objects. We detected negative superhumps in VW Hyi and indicated that the low number of normal outbursts in some supercycle can be interpreted as a result of the disk tilt. This finding, combined with the Kepler observation of V1504 Cyg and V344 Lyr, suggests that the disk tilt is responsible for modulating the outburst pattern in SU UMa-type dwarf novae. We also studied the deeply eclipsing WZ Sge-type dwarf nova MASTER OT J005740.99+443101.5 and found evidence of a sharp eclipse during the phase of early superhumps. The profile can be reproduced by a combination of the eclipse of the axisymmetric disk and the uneclipsed light source of early superhumps. This finding confirms the lack of evince of a greatly enhanced hot spot during the early stage of WZ Sge-type outburst. We detected growing (stage A) superhumps in MN Dra and give a suggestion that some of SU UMa-type dwarf novae situated near the critical condition of tidal instability may show long-lasting stage A superhumps. The large negative period derivatives reported in such systems can be understood a result of the combination of stage A and B superhumps. The WZ Sge-type dwarf novae AL Com and ASASSN-13ck showed a long-lasting (plateau-type) rebrightening. In the early phase of the rebrightening, both objects showed a precursor-like outburst, suggesting that the long-lasting rebrightening is triggered by a precursor outburst.Comment: 73 pages, 88 figures, accepted for publication in PAS

Forgeability of AZ Series Magnesium Alloy produced by Twin Roll Casting

Plastic forming of magnesium alloy is hardly reported because of its low forgeability. The productions of magnesium alloy are mainly produced by casting. Typical wrought magnesium alloy is AZ31. Magnesium-aluminum alloy indicates maximum elongation when the composition includes 3% aluminum. When the magnesium alloy includes over 3% aluminum, its elongation slightly decreases. Therefore, AZ31 that include 3% aluminum and 1% zinc is generally used for plastic forming. The more increasing aluminum composition, the larger 0.2% proof stress becomes. However its forgeability is decreasing because of precipitation of β phase such as Mg17Al12. It is supposed that the β phase is refined by rapid cooling casting process such as twin roll casting. In this paper, the magnesium alloy thick sheet of AZ91, AZ121 and AZ131 for hot forging, that include 9%, 12% and 13% aluminum composition respectively, was produced by twin roll strip casting process. And the forgeability of high aluminum containing magnesium alloy was investigated by die forging. As a result, it was possible to forge their magnesium alloys

Passerine Birds Breeding under Chronic Noise Experience Reduced Fitness

Background Fitness in birds has been shown to be negatively associated with anthropogenic noise, but the underlying mechanisms remain obscure. It is however crucial to understand the mechanisms of how urban noise impinges on fitness to obtain a better understanding of the role of chronic noise in urban ecology. Here, we examine three hypotheses on how noise might reduce reproductive output in passerine birds: (H1) by impairing mate choice, (H2) by reducing territory quality and (H3) by impeding chick development. Methodology/Principal Findings We used long-term data from an island population of house sparrows, Passer domesticus, in which we can precisely estimate fitness. We found that nests in an area affected by the noise from large generators produced fewer young, of lower body mass, and fewer recruits, even when we corrected statistically for parental genetic quality using a cross-fostering set-up, supporting H3. Also, individual females provided their young with food less often when they bred in the noisy area compared to breeding attempts by the same females elsewhere. Furthermore, we show that females reacted flexibly to increased noise levels by adjusting their provisioning rate in the short term, which suggests that noise may be a causal factor that reduces reproductive output. We rejected H1 and H2 because nestbox occupancy, parental body mass, age and reproductive investment did not differ significantly between noisy and quiet areas. Conclusions/Significance Our results suggest a previously undescribed mechanism to explain how environmental noise can reduce fitness in passerine birds: by acoustically masking parent–offspring communication. More importantly, using a cross-fostering set-up, our results demonstrate that birds breeding in a noisy environment experience significant fitness costs. Chronic noise is omnipresent around human habitation and may produces similar fitness consequences in a wide range of urban bird species