Performance in Test Beam of a Large-area and Light-weight GEM detector with 2D Stereo-Angle (U-V) Strip Readout

A large-area and light-weight Gas Electron Multiplier (GEM) detector was built at the University of Virginia as a prototype for the detector R$\&$D program of the future Electron Ion Collider. The prototype has a trapezoidal geometry designed as a generic sector module in a disk layer configuration of a forward tracker in collider detectors. It is based on light-weight material and narrow support frames in order to minimize multiple scattering and dead-to-sensitive area ratio. The chamber has a novel type of two dimensional (2D) stereo-angle readout board with U-V strips that provides (r,$\varphi$) position information in the cylindrical coordinate system of a collider environment. The prototype was tested at the Fermilab Test Beam Facility in October 2013 and the analysis of the test beam data demonstrates an excellent response uniformity of the large area chamber with an efficiency higher than 95%. An angular resolution of 60 $\mu$rad in the azimuthal direction and a position resolution better than 550 $\mu$m in the radial direction were achieved with the U-V strip readout board. The results are discussed in this paper

Effect of nuclear transparency from the (p,2p) measurements on 6Li and 12C at 1 GeV

We studied the production of protons to the backward direction in (p,2p) reactions on 6Li and 12C, accompanied by a proton emitted into the forward hemisphere. The momenta of the final two protons were measured in a wide range with the two-arm time-of-flight spectrometer. For each event we reconstructed the mass of the intermediate off-shell particles. We have discovered a strong narrow dip in the mass spectra of intermediate mesons at the mass of the real pion.Comment: 24 pages,11 figure

A high-finesse Fabry-Perot cavity with a frequency-doubled green laser for precision Compton polarimetry at Jefferson Lab

A high-finesse Fabry-Perot cavity with a frequency-doubled continuous wave green laser (532~nm) has been built and installed in Hall A of Jefferson Lab for high precision Compton polarimetry. The infrared (1064~nm) beam from a ytterbium-doped fiber amplifier seeded by a Nd:YAG nonplanar ring oscillator laser is frequency doubled in a single-pass periodically poled MgO:LiNbO$_{3}$ crystal. The maximum achieved green power at 5 W IR pump power is 1.74 W with a total conversion efficiency of 34.8\%. The green beam is injected into the optical resonant cavity and enhanced up to 3.7~kW with a corresponding enhancement of 3800. The polarization transfer function has been measured in order to determine the intra-cavity circular laser polarization within a measurement uncertainty of 0.7\%. The PREx experiment at Jefferson Lab used this system for the first time and achieved 1.0\% precision in polarization measurements of an electron beam with energy and current of 1.0~GeV and 50~$\mu$A.Comment: 20 pages, 22 figures, revised version of arXiv:1601.00251v1, submitted to NIM

A Pair Polarimeter for Linearly Polarized High Energy Photons

A high quality beam of linearly polarized photons of several GeV will become available with the coherent bremsstrahlung technique at JLab. We have developed a polarimeter which requires about two meters of the beam line, has an analyzing power of 20% and an efficiency of 0.02%. The layout and first results of a polarimeter test on the laser back-scattering photon beam at SPring-8/LEPS are presented

The Polarized H and D Atomic Beam Source for ANKE at COSY-J\"ulich

A polarized atomic beam source was developed for the polarized internal storage-cell gas target at the magnet spectrometer ANKE of COSY-J\"ulich. The intensities of the beams injected into the storage cell, measured with a compression tube, are $7.5\cdot 10^{16}$ hydrogen atoms/s (two hyperfine states) and $3.9\cdot 10^{16}$ deuterium atoms/s (three hyperfine states). For the hydrogen beam the achieved vector polarizations are $p_{\rm z}\approx\pm0.92$. For the deuterium beam, the obtained combinations of vector and tensor ($p_{\rm zz}$) polarizations are $p_{\rm z}\approx\pm 0.90$ (with a constant $p_{\rm zz}\approx +0.86$), and $p_{\rm zz}=+0.90$ or $p_{\rm zz}=-1.71$ (both with vanishing $p_{\rm z}$). The paper includes a detailed technical description of the apparatus and of the investigations performed during the development.Comment: 18 pages, 26 figures, 4 table

Measurement of tensor analyzing powers in deuteron photodisintegration

New accurate measurement of tensor analyzing powers T20, T21 and T22 in deuteron photodisintegration has been performed. Wide-aperture non-magnetic detectors allowed to cover broad kinematic ranges in a single setup: photon energy = 25 to 600 MeV, proton emission angle in CM = 24 to 48 deg. and 70 to 102 deg. New data provide a significant improvement of a few existing measurements. The angular dependency of the tensor asymmetries in deuteron photodisintegration is extracted for the first time.Comment: 4 pages, 5 figures, submitted to Phys. Rev. Let

Precision Electron-Beam Polarimetry using Compton Scattering at 1 GeV

We report on the highest precision yet achieved in the measurement of the polarization of a low energy, $\mathcal{O}$(1 GeV), electron beam, accomplished using a new polarimeter based on electron-photon scattering, in Hall~C at Jefferson Lab. A number of technical innovations were necessary, including a novel method for precise control of the laser polarization in a cavity and a novel diamond micro-strip detector which was able to capture most of the spectrum of scattered electrons. The data analysis technique exploited track finding, the high granularity of the detector and its large acceptance. The polarization of the $180~\mu$A, $1.16$~GeV electron beam was measured with a statistical precision of $<$~1\% per hour and a systematic uncertainty of 0.59\%. This exceeds the level of precision required by the \qweak experiment, a measurement of the vector weak charge of the proton. Proposed future low-energy experiments require polarization uncertainty $<$~0.4\%, and this result represents an important demonstration of that possibility. This measurement is also the first use of diamond detectors for particle tracking in an experiment.Comment: 9 pages, 7 figures, published in PR

24 segment high field permanent sextupole magnets

We report on the design, construction, and magnetic field measurements of a system of high field sextupole magnets made from NdFeB compounds. The magnets are utilized as a focusing system for neutral hydrogen (or deuterium) atoms in a polarized atomic beam source based on Stern-Gerlach spin separation. Each magnet consists of 24 segments of permanently magnetized material differing in remanence and coercivity to reduce demagnetization. According to quadratic extrapolation to the pole tip the magnetic flux density reaches values of up to B-0=1.69 T. Three-dimensional field calculations using the MAFIA code were carried out to optimize the magnet performance and to avoid demagnetization by selecting appropriate materials for the individual segments. Measurements of the radial, azimuthal, and longitudinal magnetic flux density distributions were carried out by means of a small Hall probe (100x200x15 mu m(3)). The measurements with the small probe permitted to extract experimentally higher order multipole components very close (similar to 100 mu m) to the inner surface. Experimental values obtained are compared to predictions based on MAFIA calculations and on the Halbach formalism. (C) 2000 American Institute of Physics. [S0034-6748(00)05309-0]