Phase calibration and water vapor radiometry for millimeter-wave arrays

Correcting for the fluctuations in atmospheric path length caused by water vapor is a major challenge facing millimeter- and submillimeter-wave interferometers, and one that must be overcome to obtain routine sub-arcsecond resolution. Using the model for the power spectrum of phase fluctuations developed in Lay (1997), the existing technique of phase referencing to a bright calibrator object is analysed. It is shown that the phase errors after calibration have comparable contributions from both the target and calibrator measurements. The technique of water vapor radiometry, where the amount of emission from water vapor in the beam of each antenna is used to estimate a path correction, is also examined. It is found that there are two levels on which a correction can be made. The simplest corrects just the fluctuations within each on-source period; the calibration requirements for the radiometers are modest, and this partial correction can give a substantial improvement in the resolution and coherence time of an interferometer. The atmospheric fluctuations on longer timescales remain uncorrected, however, and are significant. To remove these, a full correction is required, which measures the change in the path difference that occurs when moving between the calibrator and the target, in addition to the on-source fluctuations. Since there can be a large difference in airmass between the calibrator and the target, measuring this change requires that the radiometers have the same response to a given column of water vapor to within ~0.1 %. Two possible methods of achieving this very stringent limit are outlined. For reasonable observing conditions at 230 GHz, it is predicted that the effective atmospheric "seeing" (the apparent smearing of the sky brightness distribution due to the atmosphere) is improved from 0.6" (phase referencing every 25 minutes) to 0.3" (phase referencing and partial radiometric correction). A full radiometric correction would, in principle, restore perfect seeing

The temporal power spectrum of atmospheric fluctuations due to water vapor

Irregular variations in the refractivity of the atmosphere cause fluctuations in the phase measured by interferometers, limiting the spatial resolution that can be obtained. For frequencies up to the far infrared, water vapor is the dominant cause of the variations. The temporal power spectrum of the phase fluctuations is needed to assess correction schemes such as phase referencing using a nearby calibrator and water vapor radiometry. A model is developed for the temporal power spectrum of phase fluctuations measured by an interferometer through a layer of Kolmogorov turbulence of arbitrary thickness. It is found that both the orientation of the baseline with respect to the wind direction and the elevation of the observations can have a large effect on the temporal power spectrum. Plots of the spectral density distribution, where the area under the curve is proportional to phase power, show that substantial contributions from length scales as long as 100 times the interferometer baseline are possible. The model is generally consistent with data from the 12-GHz phase monitor at the Owens Valley Radio Observatory, and allows the data to be extrapolated to an arbitrary baseline, observing frequency and elevation. There is some evidence that there can be more than one component of turbulence present at a given time for the Owens Valley. The validity of the frozen turbulence assumption and the geometrical optics approximation is discussed and found to be reasonable under most conditions. The models and data presented here form the basis of an analysis of phase calibration and water vapor radiometry (Lay 1997)

Semiquantitative Infrared Analysis of Diketones and Anhydrides in a Reaction Mixture

The ozonolysis of a hydroxymethylene ketone yields a mixture of diketone and anhydride. Treatment of hydroxymethylene camphor with ozone affords, in addition to the expected camphor quinone, a surprisingly large amount of camphoric anhydride (56%) via Baeyer-Villager reaction. Use of infrared absorption to analyze the relative amounts of camphor quinone and camphoric anhydride in a reaction mixture was studied by comparing peak heights of their carbonyl stretching bands

First-principles calculations and bias-dependent STM measurements at the alpha-Sn/Ge(111) surface: a clear indication for the 1U2D configuration

The nature of the alpha-Sn/Ge(111) surface is still a matter of debate. In particular, two possible configurations have been proposed for the 3x3 ground state of this surface: one with two Sn adatoms in a lower position with respect to the third one (1U2D) and the other with opposite configuration (2U1D). By means of first-principles quasiparticle calculations we could simulate STM images as a function of bias voltage and compare them with STM experimental results at 78K, obtaining an unambiguous indication that the stable configuration for the alpha-Sn/Ge(111) surface is the 1U2D. The possible inequivalence of the two down Sn adatoms is also discussed.Comment: Submitted to PR

High-Frequency Measurements Of The Spectrum Of Sagittarius A*

We report near-simultaneous interferometric measurements of the spectrum of Sagittarius A* over the 5-354 GHz range and single-dish observations that have yielded the first detection of Sgr A* at 850 GHz. We confirm that Sgr A*'s spectrum rises more steeply at short millimeter wavelengths than at centimeter wavelengths, leading to a near-millimeter/submillimeter excess that dominates its luminosity. Below 900 GHz, Sgr A*'s observed luminosity is 70 +/- 30 L.. A new upper limit to Sgr A*'s 24.3 mu m flux, together with a compilation of other extant IR data, imply a far-infrared spectral turnover, which can result from either an intrinsic synchrotron cutoff or excess extinction near Sgr A*. If the former applies, Sgr A*'s total synchrotron luminosity is <10(3) L., while in the latter case it is <3 x 10(4) L. if spherical symmetry also applies.NSF AST96-15025, AST96-13717Astronom

Interferometric Observations of the Nuclear Region of Arp220 at Submillimeter Wavelengths

We report the first submillimeter interferometric observations of an ultraluminous infrared galaxy. We observed Arp220 in the CO J=3-2 line and 342GHz continuum with the single baseline CSO-JCMT interferometer consisting of the Caltech Submillimeter Observatory (CSO) and the James Clerk Maxwell Telescope (JCMT). Models were fit to the measured visibilities to constrain the structure of the source. The morphologies of the CO J=3-2 line and 342GHz continuum emission are similar to those seen in published maps at 230 and 110GHz. We clearly detect a binary source separated by about 1 arcsec in the east-west direction in the 342GHz continuum. The CO J=3-2 visibility amplitudes, however, indicate a more complicated structure, with evidence for a compact binary at some velocities and rather more extended structure at others. Less than 30% of the total CO J=3-2 emission is detected by the interferometer, which implies the presence of significant quantities of extended gas. We also obtained single-dish CO J=2-1, CO J=3-2 and HCN J=4-3 spectra. The HCN J=4-3 spectrum, unlike the CO spectra, is dominated by a single redshifted peak. The HCN J=4-3/CO J=3-2, HCN J=4-3/HCN J=1-0 and CO J=3-2/2-1 line ratios are larger in the redshifted (eastern) source, which suggests that the two sources may have different physical conditions. This result might be explained by the presence of an intense starburst that has begun to deplete or disperse the densest gas in the western source, while the eastern source harbors undispersed high density gas.Comment: 17 pages, 9 figures, 4 Tables. accepted by Ap

Nulling interferometry: performance comparison between Antarctica and other ground-based sites

Detecting the presence of circumstellar dust around nearby solar-type main sequence stars is an important pre-requisite for the design of future life-finding space missions such as ESA's Darwin or NASA's Terrestrial Planet Finder (TPF). The high Antarctic plateau may provide appropriate conditions to perform such a survey from the ground. We investigate the performance of a nulling interferometer optimised for the detection of exozodiacal discs at Dome C, on the high Antarctic plateau, and compare it to the expected performance of similar instruments at temperate sites. Based on the currently available measurements of the turbulence characteristics at Dome C, we adapt the GENIEsim software (Absil et al. 2006, A&A 448) to simulate the performance of a nulling interferometer on the high Antarctic plateau. To feed a realistic instrumental configuration into the simulator, we propose a conceptual design for ALADDIN, the Antarctic L-band Astrophysics Discovery Demonstrator for Interferometric Nulling. We assume that this instrument can be placed above the 30-m high boundary layer, where most of the atmospheric turbulence originates. We show that an optimised nulling interferometer operating on a pair of 1-m class telescopes located 30 m above the ground could achieve a better sensitivity than a similar instrument working with two 8-m class telescopes at a temperate site such as Cerro Paranal. The detection of circumstellar discs about 20 times as dense as our local zodiacal cloud seems within reach for typical Darwin/TPF targets in a integration time of a few hours. Moreover, the exceptional turbulence conditions significantly relax the requirements on real-time control loops, which has favourable consequences on the feasibility of the nulling instrument.Comment: 10 pages, accepted for publication in A&