745 research outputs found
Cu(In,Ga)Se2 absorber thinning and the homo-interface model: Influence of Mo back contact and 3-stage process on device characteristics
Thinning the absorber layer is one of the possibilities envisaged to further decrease the production costs of Cu(In,Ga)Se2 (CIGSe) thin films solar cell technology. In the present study, the electronic transport in submicron CIGSe-based devices has been investigated and compared to that of standard devices. It is observed that when the absorber is around 0.5 μm-thick, tunnelling enhanced interface recombination dominates, which harms cells energy conversion efficiency. It is also shown that by varying either the properties of the Mo back contact or the characteristics of 3-stage growth processing, one can shift the dominating recombination mechanism from interface to space charge region and thereby improve the cells efficiency. Discussions on these experimental facts led to the conclusions that 3-stage process implies the formation of a CIGSe/CIGSe homo-interface, whose location as well as properties rule the device operation; its influence is enhanced in submicron CIGSe based solar cells
Exclusive Measurements of : the Effect Revisited
Exclusive measurements of the reactions and
have been carried out at GeV at the
CELSIUS storage ring using the WASA detector. The channel
evidences a pronounced enhancement at low invariant masses - as
anticipated from previous inclusive measurements of the ABC effect. This
enhancement is seen to be even much larger in the isoscalar
channel. The differential distributions prove this enhancement to be of
scalar-isoscalar nature. calculations give a good description of
the data, if a boundstate condition is imposed for the intermediate
system.Comment: extended version, 8 pages, 7 figures, theoretical model calculations
adde
KASCADE: Astrophysical results and tests of hadronic interaction models
KASCADE is a multi-detector setup to get redundant information on single air
shower basis. The information is used to perform multiparameter analyses to
solve the threefold problem of the reconstruction of (i)the unknown primary
energy, (ii) the primary mass, and (iii) to quantify the characteristics of the
hadronic interactions in the air-shower development. In this talk recent
results of the KASCADE data analyses are summarized concerning cosmic ray
anisotropy studies, determination of flux spectra for different primary mass
groups, and approaches to test hadronic interaction models. Neither large scale
anisotropies nor point sources were found in the KASCADE data set. The energy
spectra of the light element groups result in a knee-like bending and a
steepening above the knee. The topology of the individual knee positions shows
a dependency on the primary particle. Though no hadronic interaction model is
fully able to describe the multi-parameter data of KASCADE consistently, the
more recent models or improved versions of older models reproduce the data
better than few years ago.Comment: to appear in Nucl. Phys. B (Proc. Suppl.), Proc. of the XIII
ISVHECRI, Pylos 2004 - with a better quality of the figure
The pp -> pp pi pi pi reaction channels in the threshold region
The cross section for prompt neutral and charged three pion production in pp
interactions was measured at excess energies in the range 160 - 217 MeV. That
comprises the first measurement of the pp->pp pi0pi0pi0 reaction and the
comparison with the pp->pp pi+pi-pi0 reaction, in a very direct way. The
experiment was performed above the eta meson production threshold and the cross
section normalization was obtained from a concurrent measurement of the
reaction pp->pp eta with the eta decaying into 3 pions. Since the same final
states are selected, the measurement has a low systematical error. The measured
cross section ratio sigma(pp->pp pi+pi-pi0)/sigma(pp->pp pi0\pi0\pi0) is
compared to predictions of dominance of different isobars in the intermediate
state.Comment: 12 pages, 4 figures New discussion on the pp->pp3pi reaction
mechanis
Anisotropy in the pion angular distribution of the reaction pp -> pp pi0 at 400 MeV
The reaction pp -> pp pi0 was studied with the WASA detector at the CELSIUS
storage ring. The center of mass angular distribution of the pi0 was obtained
by detection of the gamma decay products together with the two outgoing
protons, and found to be anisotropic with a negative second derivative slope,
in agreement with the theoretical predictions from a microscopic calculation.Comment: Revtex 4 style, 5 pages 7 figures, PACS numbers:13.60.Le, 13.75.Cs,
21.45.+v, 25.10.+
Two-Pion Production in Proton-Proton Collisions -- Experimental Total Cross Sections and their Isospin Decomposition
The two-pion production in pp-collisions has been investigated at CELSIUS in
exclusive measurements from threshold up to = 1.36 GeV. Total and
differential cross sections have been obtained for the channels ,
, and also . For intermediate
incident energies 1 GeV, i.e. in the region which is beyond the Roper
excitation but at the onset of excitation, the total
cross section falls behind theoretical predictions by as much as
an order of magnitude near 1.2 GeV, whereas the cross section is
a factor of five larger than predicted. An isospin decompostion of the total
cross sections exhibits a s-channel-like energy dependence in the region of the
Roper excitation as well as a significant contribution of an isospin 3/2
resonance other than the . As possible candidates the
and the are discussed
Double-Pionic Fusion of Nuclear Systems and the ABCEffect -- Aproaching a Puzzle by Exclusive and Kinematically Complete Measurements
The ABC effect - a puzzling low-mass enhancement in the invariant
mass spectrum - is well-known from inclusive measurements of two-pion
production in nuclear fusion reactions. Here we report on first exclusive and
kinematically complete measurements of the most basic double pionic fusion
reaction at 1.03 and 1.35 GeV. The measurements, which
have been carried out at CELSIUS-WASA, reveal the ABC effect to be a
channel phenomenon associated with both a resonance-like
energy dependence in the integral cross section and the formation of a
system in the intermediate state. A corresponding simple
s-channel resonance ansatz provides a surprisingly good description of the
data
Measurement of the Slope Parameter for the eta->3pi0 Decay in the pp->pp eta Reaction
The CELSIUS/WASA setup is used to measure the 3pi0 decay of eta mesons
produced in pp interactions with beam kinetic energies of 1.36 and 1.45 GeV.
The efficiency-corrected Dalitz plot and density distributions for this decay
are shown, together with a fit of the quadratic slope parameter alpha yielding
alpha = -0.026 +/- 0.010(stat) +/- 0.010(syst). This value is compared to
recent experimental results and theoretical predictions.Comment: 4 pages, 7 Postscript figures, uses revtex4.st
- …
