First experimental demonstration of temporal hypertelescope operation with a laboratory prototype

In this paper, we report the first experimental demonstration of a Temporal HyperTelescope (THT). Our breadboard including 8 telescopes is firstly tested in a manual cophasing configuration on a 1D object. The Point Spread Function (PSF) is measured and exhibits a dynamics in the range of 300. A quantitative analysis of the potential biases demonstrates that this limitation is related to the residual phase fluctuation on each interferometric arm. Secondly, an unbalanced binary star is imaged demonstrating the imaging capability of THT. In addition, 2D PSF is recorded even if the telescope array is not optimized for this purpose.Comment: Accepted for publication in MNRAS. 11 pages, 25 figure

Clues for a standardised thermal-optical protocol for the assessment of organic and elemental carbon within ambient air particulate matter

Along with some research networking programmes, the European Directive 2008/50/CE requires chemical speciation of fine aerosol (PM_2.5), including elemental (EC) and organic carbon (OC), at a few rural sites in European countries. Meanwhile, the thermal-optical technique is considered by the European and US networking agencies and normalisation bodies as a reference method to quantify EC–OC collected on filters. Although commonly used for many years, this technique still suffers from a lack of information on the comparability of the different analytical protocols (temperature protocols, type of optical correction) currently applied in the laboratories. To better evaluate the EC–OC data set quality and related uncertainties, the French National Reference Laboratory for Ambient Air Quality Monitoring (LCSQA) organised an EC–OC comparison exercise for French laboratories using different thermal-optical methods (five laboratories only). While there is good agreement on total carbon (TC) measurements among all participants, some differences can be observed on the EC / TC ratio, even among laboratories using the same thermal protocol. These results led to further tests on the influence of the optical correction: results obtained from different European laboratories confirmed that there were higher differences between OC_TOT and OC_TOR measured with NIOSH 5040 in comparison to EUSAAR-2. Also, striking differences between EC_TOT / EC_TOR ratios can be observed when comparing results obtained for rural and urban samples, with EC_TOT being 50% lower than EC_TOR at rural sites whereas it is only 20% lower at urban sites. The PM chemical composition could explain these differences but the way it influences the EC–OC measurement is not clear and needs further investigation. Meanwhile, some additional tests seem to indicate an influence of oven soiling on the EC–OC measurement data quality. This highlights the necessity to follow the laser signal decrease with time and its impact on measurements. Nevertheless, this should be confirmed by further experiments, involving more samples and various instruments, to enable statistical processing. All these results provide insights to determine the quality of EC–OC analytical methods and may contribute to the work toward establishing method standardisation

Intercomparison Exercise for Heavy Metals in PM10

The Joint Research Centre (JRC) has carried out an Intercomparison Exercise (IE) for the determination of heavy metals in particulate matter (PM10). The IE focussed on Lead (Pb), Arsenic (As), Nickel (Ni) and Cadmium (Cd), the heavy metals regulated by the 1st and 4th Daughter Directives for Air Pollution. Copper (Cu), Chromium (Cr) and Zinc (Zn), the elements included in the EMEP programme together with Aluminium (Al), Cobalt (Co), Iron (Fe), Manganese (Mn) and Vanadium (V) were also tested. Fourteen Laboratories, generally members of the Network of Air Quality Reference Laboratories (AQUILA), participated in the IE. The participants mainly used microwave digestion with nitric acid and hydrogen peroxide and Inductively Coupled Plasma Mass Spectrometry (ICP-MS) or Graphite Furnace Atomic Absorption Spectrometry (GF-AAS) for analysis as recommended in the reference method (EN 14902). However, a few participants used other methods: Energy Dispersive X-ray Fluorescence (EDXRF), Atomic Emission Spectrometry (ICP-AES) and Voltammetry for analysis and vaporisation on hot plate before microwave digestion, Soxhlet extraction, high pressure or cold Hydrogen Fluoride methods for digestion. Each participant received 5 samples to be analysed: a liquid sample prepared by dilution of a Certified Reference Material (CRM), a solution of a dust CRM sample digested by the JRC13F, a sub-sample of a dust CRM that each participating laboratory had to digest and analyse, a solution prepared by JRC after digestion of an exposed filter and a pair of filters (one blank filter and one exposed filter) to be digested and analysed by each participant. For 89 % of all types of samples, the DQOs of the 1st and 4th European Directives (uncertainty of 25 % for Pb and 40 % for As, Cd and Ni) were met. All together, this is a very good score. The best results were obtained for the liquid CRM, dust CRM digested by JRC, dust CRM and filter digested by JRC with 92, 90, 96 and 93 % of DQOs being met, respectively. It was found that the DQOs were not met if the difference of acidity between test samples and participant calibration standards was high. Conversely, only 76 % of DQOs were met for the filter to be digested by each participant with (about 85 % for Cd and Ni, 73/64 % for Pb and As, the most difficult element to determine). The worst results were associated with special events: explosion in microwave oven during digestion for two participants, a wrong dilution factor used by one participant and a huge contamination in the blank filter for another participant. Among the two explosions, one of them was probably the effect of a lack of temperature control in the digestion vessel. For the other explosion, the microwave digestion and the digestion program advised by EN 14902 is to be questioned. Moreover, satisfactory results were obtained using Soxhlet extraction, high pressure method and cold Hydrogen Fluoride digestion methods which are not presented in EN 14902. The DQOs of As and Cd could not be met with EDXRF whose limit of detection was too high for these two elements and for Cd using Voltammetry which suffered a strong interference for this element. Regarding the methods of analysis, apart the points mentioned just before about EDXRF and Voltammetry, good results were observed using ICP-OES for Cd, Ni and Pb. A few discrepancies were also registered for GF-AAS and ICP-MS but they were created by the special events or acidity problem mentioned before. This shows that even though GF-AAS and ICP-MS are found suitable, the implementation by each participant may be responsible for important mistakes.JRC.H.4-Transport and air qualit

Access to finance: an empirical analysis

YesFinancial access is gradually being recognised as an important input to economic development. Using World Bank (2007) database, this study measures the extent of financial access in developed and developing countries. Further, it develops a new Socio-Economic Development Index, which incorporates financial access. It then compares socio-economic development of various countries as shown by Human Development Index (HDI) alone and by the new index incorporating financial access. The results of the study show that Spain ranks highest in terms of financial access followed by Belgium, Malta and South Korea. In addition, the ranking of countries in terms of HDI changes if financial access is taken into accoun

Requirement of CHROMOMETHYLASE3 for somatic inheritance of the spontaneous tomato epimutation Colourless non-ripening

Naturally-occurring epimutants are rare and have mainly been described in plants. However how these mutants maintain their epigenetic marks and how they are inherited remain unknown. Here we report that CHROMOMETHYLASE3 (SlCMT3) and other methyltransferases are required for maintenance of a spontaneous epimutation and its cognate Colourless non-ripening (Cnr) phenotype in tomato. We screened a series of DNA methylation-related genes that could rescue the hypermethylated Cnr mutant. Silencing of the developmentally-regulated SlCMT3 gene results in increased expression of LeSPL-CNR, the gene encodes the SBP-box transcription factor residing at the Cnr locus and triggers Cnr fruits to ripen normally. Expression of other key ripening-genes was also up-regulated. Targeted and whole-genome bisulfite sequencing showed that the induced ripening of Cnr fruits is associated with reduction of methylation at CHG sites in a 286-bp region of the LeSPL-CNR promoter, and a decrease of DNA methylation in differentially-methylated regions associated with the LeMADS-RIN binding sites. Our results indicate that there is likely a concerted effect of different ethyltransferases at the Cnr locus and the plant-specific SlCMT3 is essential for sustaining Cnr epi-allele. Maintenance of DNA methylation dynamics is critical for the somatic stability of Cnr epimutation and for the inheritance of tomato non-ripening phenotype

Behavior and Impact of Zirconium in the Soil–Plant System: Plant Uptake and Phytotoxicity

Because of the large number of sites they pollute, toxic metals that contaminate terrestrial ecosystems are increasingly of environmental and sanitary concern (Uzu et al. 2010, 2011; Shahid et al. 2011a, b, 2012a). Among such metals is zirconium (Zr), which has the atomic number 40 and is a transition metal that resembles titanium in physical and chemical properties (Zaccone et al. 2008). Zr is widely used in many chemical industry processes and in nuclear reactors (Sandoval et al. 2011; Kamal et al. 2011), owing to its useful properties like hardness, corrosion-resistance and permeable to neutrons (Mushtaq 2012). Hence, the recent increased use of Zr by industry, and the occurrence of the Chernobyl and Fukashima catastrophe have enhanced environmental levels in soil and waters (Yirchenko and Agapkina 1993; Mosulishvili et al. 1994 ; Kruglov et al. 1996)

2006 B100 Quality Survey Results: Milestone Report

In 2006, the National Renewable Energy Laboratory conducted a nationwide quality survey of pure biodiesel (B100) intended to be used as a blendstock. The study collected random samples throughout the United States and analyzed them for quality against the current and proposed ASTM D6751 fuel quality specifications

Return of naturally sourced Pb to Atlantic surface waters

Anthropogenic emissions completely overwhelmed natural marine lead (Pb) sources during the past century, predominantly due to leaded petrol usage. Here, based on Pb isotope measurements, we reassess the importance of natural and anthropogenic Pb sources to the tropical North Atlantic following the nearly complete global cessation of leaded petrol use. Significant proportions of up to 30-50% of natural Pb, derived from mineral dust, are observed in Atlantic surface waters, reflecting the success of the global effort to reduce anthropogenic Pb emissions. The observation of mineral dust derived Pb in surface waters is governed by the elevated atmospheric mineral dust concentration of the North African dust plume and the dominance of dry deposition for the atmospheric aerosol flux to surface waters. Given these specific regional conditions, emissions from anthropogenic activities will remain the dominant global marine Pb source, even in the absence of leaded petrol combustion

Genetic differentiation and admixture between sibling allopolyploids in the Dactylorhiza majalis complex

Allopolyploidization often happens recurrently, but the evolutionary significance of its iterative nature is not yet fully understood. Of particular interest are the gene flow dynamics and the mechanisms that allow young sibling polyploids to remain distinct while sharing the same ploidy, heritage and overlapping distribution areas. By using eight highly variable nuclear microsatellites, newly reported here, we investigate the patterns of divergence and gene flow between 386 polyploid and 42 diploid individuals, representing the sibling allopolyploids Dactylorhiza majalis s.s. and D. traunsteineri s.l. and their parents at localities across Europe. We make use in our inference of the distinct distribution ranges of the polyploids, including areas in which they are sympatric (that is, the Alps) or allopatric (for example, Pyrenees with D. majalis only and Britain with D. traunsteineri only). Our results show a phylogeographic signal, but no clear genetic differentiation between the allopolyploids, despite the visible phenotypic divergence between them. The results indicate that gene flow between sibling Dactylorhiza allopolyploids is frequent in sympatry, with potential implications for the genetic patterns across their entire distribution range. Limited interploidal introgression is also evidenced, in particular between D. incarnata and D. traunsteineri. Altogether the allopolyploid genomes appear to be porous for introgression from related diploids and polyploids. We conclude that the observed phenotypic divergence between D. majalis and D. traunsteineri is maintained by strong divergent selection on specific genomic areas with strong penetrance, but which are short enough to remain undetected by genotyping dispersed neutral markers.UE FWF; P22260UE: Y66

Why Does Exercise “Triggerâ€? Adaptive Protective Responses in the Heart?

Numerous epidemiological studies suggest that individuals who exercise have decreased cardiac morbidity and mortality. Pre-clinical studies in animal models also find clear cardioprotective phenotypes in animals that exercise, specifically characterized by lower myocardial infarction and arrhythmia. Despite the clear benefits, the underlying cellular and molecular mechanisms that are responsible for exercise preconditioning are not fully understood. In particular, the adaptive signaling events that occur during exercise to “trigger� cardioprotection represent emerging paradigms. In this review, we discuss recent studies that have identified several different factors that appear to initiate exercise preconditioning. We summarize the evidence for and against specific cellular factors in triggering exercise adaptations and identify areas for future study