Ground-layer wavefront reconstruction from multiple natural guide stars

Observational tests of ground layer wavefront recovery have been made in open loop using a constellation of four natural guide stars at the 1.55 m Kuiper telescope in Arizona. Such tests explore the effectiveness of wide-field seeing improvement by correction of low-lying atmospheric turbulence with ground-layer adaptive optics (GLAO). The wavefronts from the four stars were measured simultaneously on a Shack-Hartmann wavefront sensor (WFS). The WFS placed a 5 x 5 array of square subapertures across the pupil of the telescope, allowing for wavefront reconstruction up to the fifth radial Zernike order. We find that the wavefront aberration in each star can be roughly halved by subtracting the average of the wavefronts from the other three stars. Wavefront correction on this basis leads to a reduction in width of the seeing-limited stellar image by up to a factor of 3, with image sharpening effective from the visible to near infrared wavelengths over a field of at least 2 arc minutes. We conclude that GLAO correction will be a valuable tool that can increase resolution and spectrographic throughput across a broad range of seeing-limited observations.Comment: 25 pages, 8 figures, to be published in Astrophys.

Characterizing the Adaptive Optics Off-Axis Point-Spread Function - I: A Semi-Empirical Method for Use in Natural-Guide-Star Observations

Even though the technology of adaptive optics (AO) is rapidly maturing, calibration of the resulting images remains a major challenge. The AO point-spread function (PSF) changes quickly both in time and position on the sky. In a typical observation the star used for guiding will be separated from the scientific target by 10" to 30". This is sufficient separation to render images of the guide star by themselves nearly useless in characterizing the PSF at the off-axis target position. A semi-empirical technique is described that improves the determination of the AO off-axis PSF. The method uses calibration images of dense star fields to determine the change in PSF with field position. It then uses this information to correct contemporaneous images of the guide star to produce a PSF that is more accurate for both the target position and the time of a scientific observation. We report on tests of the method using natural-guide-star AO systems on the Canada-France-Hawaii Telescope and Lick Observatory Shane Telescope, augmented by simple atmospheric computer simulations. At 25" off-axis, predicting the PSF full width at half maximum using only information about the guide star results in an error of 60%. Using an image of a dense star field lowers this error to 33%, and our method, which also folds in information about the on-axis PSF, further decreases the error to 19%.Comment: 29 pages, 9 figures, accepted for publication in the PAS

Computational model combined with in vitro experiments to analyse mechanotransduction during mesenchymal stem cell adhesion.

The shape that stem cells reach at the end of adhesion process influences their differentiation. Rearrangement of cytoskeleton and modification of intracellular tension may activate mechanotransduction pathways controlling cell commitment. In the present study, the mechanical signals involved in cell adhesion were computed in in vitro stem cells of different shapes using a single cell model, the so-called Cytoskeleton Divided Medium (CDM) model. In the CDM model, the filamentous cytoskeleton and nucleoskeleton networks were represented as a mechanical system of multiple tensile and compressive interactions between the nodes of a divided medium. The results showed that intracellular tonus, focal adhesion forces as well as nuclear deformation increased with cell spreading. The cell model was also implemented to simulate the adhesion process of a cell that spreads on protein-coated substrate by emitting filopodia and creating new distant focal adhesion points. As a result, the cell model predicted cytoskeleton reorganisation and reinforcement during cell spreading. The present model quantitatively computed the evolution of certain elements of mechanotransduction and may be a powerful tool for understanding cell mechanobiology and designing biomaterials with specific surface properties to control cell adhesion and differentiation

Cluster Multi-spacecraft Determination of AKR Angular Beaming

Simultaneous observations of AKR emission using the four-spacecraft Cluster array were used to make the first direct measurements of the angular beaming patterns of individual bursts. By comparing the spacecraft locations and AKR burst locations, the angular beaming pattern was found to be narrowly confined to a plane containing the magnetic field vector at the source and tangent to a circle of constant latitude. Most rays paths are confined within 15 deg of this tangent plane, consistent with numerical simulations of AKR k-vector orientation at maximum growth rate. The emission is also strongly directed upward in the tangent plane, which we interpret as refraction of the rays as they leave the auroral cavity. The narrow beaming pattern implies that an observer located above the polar cap can detect AKR emission only from a small fraction of the auroral oval at a given location. This has important consequences for interpreting AKR visibility at a given location. It also helps re-interpret previously published Cluster VLBI studies of AKR source locations, which are now seen to be only a subset of all possible source locations. These observations are inconsistent with either filled or hollow cone beaming models.Comment: 5 pages, 4 figures. Geophys. Res. Letters (accepted

ESR, raman and conductivity studies on fractionated poly(2-methoxyaniline-5-sulfonic acid)

Synthesis methods used to produce poly(2-methoxyaniline-5-sulfonic acid) (PMAS), a water soluble, self-doped conducting polymer, have been shown to form two distinctly different polymer fractions with molecular weights of approximately 2 kDa and 8 -10 kDa. The low molecular weight (LMWT) PMAS fraction is redox inactive and non-conducting while the high molecular weight (HMWT) PMAS is electro-active with electrical conductivities of 0.94 0.05 S cm-1. Previous investigations have illustrated the different photochemical and electrochemical properties of these fractions, but have not correlated these properties with the structural and electronic interactions that drive them. Incomplete purification of the PMAS mixture, typically via bag dialysis, has been shown to result in a mixture of approximately 50:50 HMWT:LMWT PMAS with electrical conductivity significantly lower at approximately 0.10 to 0.26 S cm-1. The difference between the electrical conductivities of these fractions has been investigated by the controlled addition of the non-conducting LMWT PMAS fraction into the HMWT PMAS composite film with the subsequent electronic properties investigated by solid-state ESR and Raman spectroscopies. These studies illustrate strong electronic intereactions of the insulating LMWT PMAS with the emeraldine salt HMWT PMAS to substantially alter the population of the electronic charge carriers in the conducting polymer. ESR studies on these mixtures, when compared to HMWT PMAS, exhibited a lower level of electron spin in the presence of LMWT PMAS indicative of the the formation of low spin bipolarons without a change the oxidation state of the conducting HMWT fraction

Finite Element Modelling of Micro-cantilevers Used as Chemical Sensors

Nowadays, silicon micro-cantilevers with different geometrical shapes are widely used as micro-electro-mechanical systems and, more recently, as force sensor probes in atomic force microscopy (AFM). During the last ten years, several applications, which include these AFM micrometer-sized cantilevers as mass probes in microbalances or as chemical sensors in chemical micro-system devices, were developed. In the case of complex shapes of cantilevers, where the cross-section is not constant along the cantilever length (case of “V-shaped” micro-cantilevers), their resonant frequencies can not be analytically calculated. Firstly, in order to validate the accuracy of our FEM approach, we carried out a comparison between analytical, experimental and FEM-computed values of the resonant frequencies for homogenous rectangular shaped micro-cantilevers. Then, we performed a modeling of silicon beams coated with a thin sensitive layer (50 nm of Gold). To precisely calculate the resonant frequencies of these multilayer-cantilevers, the influence of the mesh parameters on the calculated frequencies was strongly investigated. Secondly, the sensitivity of different “V-shaped” silicon cantilevers was estimated, as a function of their geometrical dimensions and of their mechanical parameters (Young modulus, density). The resonant frequencies of uncoated cantilevers were calculated and compared with the values experimentally determined. Then, a similar approach was employed to predict the sensitivities of such cantilevers recovered with a sensitive layer

Simulations of the solar orbiter spacecraft interactions with the solar wind: effects on RPW and SWA/EAS measurements

International audienceWe present numerical simulations of the future Solar Orbiter spacecraft/plasma interactions performed with the Spacecraft Plasma Interaction System (SPIS) software. This spacecraft, to be launched in October 2018, is dedicated to the Sun observation with in-situ and remote sensing instruments, brought as close as 0.28 A.U. from our star. In this hot and dense environment, the entire satellite will be submitted to high radiations and temperatures (up to 10 Solar constants). Material responses to environment constraints (heat, U.V. flux, photoemission, secondary electron emission under electron impact – SEEE – or under proton impact - SEEP) might bias the scientific instrument measurements. Our interest is focused on two instruments: the Radio and Plasma Waves (RPW) and the Electron Analyzer System (EAS)

Electron beam induced radio emission from ultracool dwarfs

We present the numerical simulations for an electron-beam-driven and loss-cone-driven electron-cyclotron maser (ECM) with different plasma parameters and different magnetic field strengths for a relatively small region and short time-scale in an attempt to interpret the recent discovered intense radio emission from ultracool dwarfs. We find that a large amount of electromagnetic field energy can be effectively released from the beam-driven ECM, which rapidly heats the surrounding plasma. A rapidly developed high-energy tail of electrons in velocity space (resulting from the heating process of the ECM) may produce the radio continuum depending on the initial strength of the external magnetic field and the electron beam current. Both significant linear polarization and circular polarization of electromagnetic waves can be obtained from the simulations. The spectral energy distributions of the simulated radio waves show that harmonics may appear from 10 to 70$\nu_{\rm pe}$ ($\nu_{\rm pe}$ is the electron plasma frequency) in the non-relativistic case and from 10 to 600$\nu_{\rm pe}$ in the relativistic case, which makes it difficult to find the fundamental cyclotron frequency in the observed radio frequencies. A wide frequency band should therefore be covered by future radio observations.Comment: 10 pages, 19 figures, accepted for publication in the Astrophysical Journa