1,730 research outputs found
Bosonization in d=2 from finite chiral determinants with a Gauss decomposition
We show how to bosonize two-dimensional non-abelian models using finite
chiral determinants calculated from a Gauss decomposition. The calculation is
quite straightforward and hardly more involved than for the abelian case. In
particular, the counterterm , which is normally motivated from gauge
invariance and then added by hand, appears naturally in this approach.Comment: 4 pages, Revte
Patterns of Striped order in the Classical Lattice Coulomb Gas
We obtain via Monte Carlo simulations the low temperature charge
configurations in the lattice Coulomb gas on square lattices for charge filling
ratio in the range . We find a simple regularity in the low
temperature charge configurations which consist of a suitable periodic
combination of a few basic striped patterns characterized by the existence of
partially filled diagonal channels. In general there exist two separate
transitions where the lower temperature transition () corresponds to the
freezing of charges within the partially filled channels. is found to be
sensitively dependent on through the charge number density within the channels.Comment: 4 pages, 8 figure
Magnetoinductance of Josephson junction array with frozen vortex diffusion
The dependence of sheet impedance of a Josephson junction array on the
applied magnetic field is investigated in the regime when vortex diffusion
between array plaquettes is effectively frozen due to low enough temperature.
The field dependent contribution to sheet inductance is found to be
proportional to f*ln(1/f), where f<<1 is the magnitude of the field expressed
in terms of flux quanta per plaquette.Comment: 5 pages, no figure
Dynamic Impedance of Two-Dimensional Superconducting Films Near the Superconducting Transition
The sheet impedances, Z(w,T), of several superconducting a-Mo77Ge23 films and
one In/InOx film have been measured in zero field using a two-coil mutual
inductance technique at frequencies from 100 Hz to 100 kHz. Z(w,T) is found to
have three contributions: the inductive superfluid, renormalized by nonvortex
phase fluctuations; conventional vortex-antivortex pairs, whose contribution
turns on very rapidly just below the usual Kosterlitz-Thouless-Berezinskii
unbinding temperature; and an anomalous contribution. The latter is
predominantly resistive, persists well below the KTB temperature, and is weakly
dependent on frequency down to remarkably low frequencies, at least 100 Hz. It
increases with T as e-U'(T)/kT, where the activation energy, U'(T), is about
half the energy to create a vortex-antivortex pair, indicating that the
frequency dependence is that of individual excitations, rather than critical
behavior.Comment: 10 pages, 10 figs; subm PR
Revival of the magnetar PSR J1622-4950: observations with MeerKAT, Parkes, XMM-Newton, Swift, Chandra, and NuSTAR
New radio (MeerKAT and Parkes) and X-ray (XMM-Newton, Swift, Chandra, and
NuSTAR) observations of PSR J1622-4950 indicate that the magnetar, in a
quiescent state since at least early 2015, reactivated between 2017 March 19
and April 5. The radio flux density, while variable, is approximately 100x
larger than during its dormant state. The X-ray flux one month after
reactivation was at least 800x larger than during quiescence, and has been
decaying exponentially on a 111+/-19 day timescale. This high-flux state,
together with a radio-derived rotational ephemeris, enabled for the first time
the detection of X-ray pulsations for this magnetar. At 5%, the 0.3-6 keV
pulsed fraction is comparable to the smallest observed for magnetars. The
overall pulsar geometry inferred from polarized radio emission appears to be
broadly consistent with that determined 6-8 years earlier. However, rotating
vector model fits suggest that we are now seeing radio emission from a
different location in the magnetosphere than previously. This indicates a novel
way in which radio emission from magnetars can differ from that of ordinary
pulsars. The torque on the neutron star is varying rapidly and unsteadily, as
is common for magnetars following outburst, having changed by a factor of 7
within six months of reactivation.Comment: Published in ApJ (2018 April 5); 13 pages, 4 figure
Tuberculosis diagnostics and biomarkers: needs, challenges, recent advances, and opportunities
Tuberculosis is unique among the major infectious diseases in that it lacks accurate rapid point-of-care diagnostic tests. Failure to control the spread of tuberculosis is largely due to our inability to detect and treat all infectious cases of pulmonary tuberculosis in a timely fashion, allowing continued Mycobacterium tuberculosis transmission within communities. Currently recommended gold-standard diagnostic tests for tuberculosis are laboratory based, and multiple investigations may be necessary over a period of weeks or months before a diagnosis is made. Several new diagnostic tests have recently become available for detecting active tuberculosis disease, screening for latent M. tuberculosis infection, and identifying drug-resistant strains of M. tuberculosis. However, progress toward a robust point-of-care test has been limited, and novel biomarker discovery remains challenging. In the absence of effective prevention strategies, high rates of early case detection and subsequent cure are required for global tuberculosis control. Early case detection is dependent on test accuracy, accessibility, cost, and complexity, but also depends on the political will and funder investment to deliver optimal, sustainable care to those worst affected by the tuberculosis and human immunodeficiency virus epidemics. This review highlights unanswered questions, challenges, recent advances, unresolved operational and technical issues, needs, and opportunities related to tuberculosis diagnostics
Vortex Lattice Melting in 2D Superconducting Networks and Films
We carry out MC studies of 2D superconducting networks, in an applied
magnetic field, for square and honeycomb geometries. We consider both dilute
systems (f=1/q) and systems near full frustration (f=1/2-1/q). For the dilute
case (which models a film as q->infinity), we find two transitions: at
T_c(f)~1/q there is a depinning transition from a pinned to a floating vortex
lattice; at T_m(f)~constant the floating vortex lattice melts into an isotropic
liquid. We analyze this melting according to the Kosterlitz- Thouless theory of
dislocation mediated melting, and find that the melting is weakly first order.
For the case near full frustration, the system can be described in terms of the
density of defects in an otherwise fully frustrated vortex pattern. We find
pinned solid, floating solid, and liquid defect phases, as well as a higher
sharp transition corresponding to the disordering of the fully frustrated
background.Comment: 55 pages, RevTex3.0, 25 figures (available by mail by contacting
[email protected]
Inertial Mass of a Vortex in Cuprate Superconductors
We present here a calculation of the inertial mass of a moving vortex in
cuprate superconductors. This is a poorly known basic quantity of obvious
interest in vortex dynamics. The motion of a vortex causes a dipolar density
distortion and an associated electric field which is screened. The energy cost
of the density distortion as well as the related screened electric field
contribute to the vortex mass, which is small because of efficient screening.
As a preliminary, we present a discussion and calculation of the vortex mass
using a microscopically derivable phase-only action functional for the far
region which shows that the contribution from the far region is negligible, and
that most of it arises from the (small) core region of the vortex. A
calculation based on a phenomenological Ginzburg-Landau functional is performed
in the core region. Unfortunately such a calculation is unreliable, the reasons
for it are discussed. A credible calculation of the vortex mass thus requires a
fully microscopic, non-coarse grained theory. This is developed, and results
are presented for a s-wave BCS like gap, with parameters appropriate to the
cuprates. The mass, about 0.5 per layer, for magnetic field along the
axis, arises from deformation of quasiparticle states bound in the core, and
screening effects mentioned above. We discuss earlier results, possible
extensions to d-wave symmetry, and observability of effects dependent on the
inertial mass.Comment: 27 pages, Latex, 3 figures available on request, to appear in
Physical Review
- …
