Variation of the Diameter of the Sun as Measured by the Solar Disk Sextant (SDS)

The balloon-borne Solar Disk Sextant (SDS) experiment has measured the angular size of the Sun on seven occasions spanning the years 1992 to 2011. The solar half-diameter -- observed in a 100-nm wide passband centred at 615 nm -- is found to vary over that period by up to 200 mas, while the typical estimated uncertainty of each measure is 20 mas. The diameter variation is not in phase with the solar activity cycle; thus, the measured diameter variation cannot be explained as an observational artefact of surface activity. Other possible instrument-related explanations for the observed variation are considered but found unlikely, leading us to conclude that the variation is real. The SDS is described here in detail, as is the complete analysis procedure necessary to calibrate the instrument and allow comparison of diameter measures across decades.Comment: 41 pages; appendix and 2 figures added plus some changes in text based on referee's comments; to appear in MNRA

Material parameters identification: Gradient-based, genetic and hybrid optimization algorithms

This paper presents two procedures for the identification of material parameters, a genetic algorithm and a gradient-based algorithm. These algorithms enable both the yield criterion and the work hardening parameters to be identified. A hybrid algorithm is also used, which is a combination of the former two, in such a way that the result of the genetic algorithm is considered as the initial values for the gradient-based algorithm. The objective of this approach is to improve the performance of the gradient-based algorithm, which is strongly dependent on the initial set of results. The constitutive model used to compare the three different optimization schemes uses the Barlat'91 yield criterion, an isotropic Voce type law and a kinematic Lemaitre and Chaboche law, which is suitable for the case of aluminium alloys. In order to analyse the effectiveness of this optimization procedure, numerical and experimental results for an EN AW-5754 aluminium alloy are compared.http://www.sciencedirect.com/science/article/B6TWM-4SJGWMW-1/1/01e8be60ce61e8fc30473d85439fbe3

The influence of ambipolarity on plasma confinement and the performace of ECRIS

International audienceCharge diffusion in an ECRIS discharge is usually characterized by non ambipolar behavior. While the ions are transported to the radial walls, electrons are lost axially from the magnetic trap. Global neutrality is maintained via compensating currents in the conducting walls of the vacuum chamber. It is assumed that this behavior reduces the ion breeding times compared to a truly ambipolar plasma. We have carried out a series of dedicated experiments in which the ambipolarity of the ECRIS plasma was influenced by inserting special metal-dielectric structures (MD layers) into the plasma chamber of the Frankfurt 14GHz ECRIS. The measurements demonstrate the positive influence on the source performance when the ECR plasma is changed towards more ambipolar behavior

The acceleration and storage of radioactive ions for a neutrino factory

The term beta-beam has been coined for the production of a pure beam of electron neutrinos or their antiparticles through the decay of radioactive ions circulating in a storage ring. This concept requires radioactive ions to be accelerated to a Lorentz gamma of 150 for 6He and 60 for 18Ne. The neutrino source itself consists of a storage ring for this energy range, with long straight sections in line with the experiment(s). Such a decay ring does not exist at CERN today, nor does a high-intensity proton source for the production of the radioactive ions. Nevertheless, the existing CERN accelerator infrastructure could be used as this would still represent an important saving for a beta-beam facility. This paper outlines the first study, while some of the more speculative ideas will need further investigations.Comment: Accepted for publication in proceedings of Nufact02, London, 200

Seismic and dynamical solar models i-the impact of the solar rotation history on neutrinos and seismic indicators

Solar activity and helioseismology show the limitation of the standard solar model and call for the inclusion of dynamical processes in both convective and radiative zones. We concentrate here on the radiative zone and first show the sensitivity of boron neutrinos to the microscopic physics included in solar models. We confront the neutrino predictions of the seismic model to all the detected neutrino fluxes. Then we compute new models of the Sun including a detailed transport of angular momentum and chemicals due to internal rotation that includes meridional circulation and shear induced turbulence. We use two stellar evolution codes: CESAM and STAREVOL to estimate the different terms. We follow three temporal evolutions of the internal rotation differing by their initial conditions: very slow, moderate and fast rotation, with magnetic braking at the arrival on the main sequence for the last two. We find that the meridional velocity in the present solar radiative zone is extremely small in comparison with those of the convective zone, smaller than 10^-6 cm/s instead of m/s. All models lead to a radial differential rotation profile but with a significantly different contrast. We compare these profiles to the presumed solar internal rotation and show that if meridional circulation and shear turbulence were the only mechanisms transporting angular momentum within the Sun, a rather slow rotation in the young Sun is favored. The transport by rotation slightly influence the sound speed profile but its potential impact on the chemicals in the transition region between radiation and convective zones. This work pushes us to pursue the inclusion of the other dynamical processes to better reproduce the present observable and to describe the young active Sun. We also need to get a better knowledge of solar gravity mode splittings to use their constraints.Comment: 39 pages, 9 figures, accepted in Astrophysical Journa

Stellar jitter from variable gravitational redshift: implications for RV confirmation of habitable exoplanets

A variation of gravitational redshift, arising from stellar radius fluctuations, will introduce astrophysical noise into radial velocity measurements by shifting the centroid of the observed spectral lines. Shifting the centroid does not necessarily introduce line asymmetries. This is fundamentally different from other types of stellar jitter so far identified, which do result from line asymmetries. Furthermore, only a very small change in stellar radius, ~0.01%, is necessary to generate a gravitational redshift variation large enough to mask or mimic an Earth-twin. We explore possible mechanisms for stellar radius fluctuations in low-mass stars. Convective inhibition due to varying magnetic field strengths and the Wilson depression of starspots are both found to induce substantial gravitational redshift variations. Finally, we investigate a possible method for monitoring/correcting this newly identified potential source of jitter and comment on its impact for future exoplanet searches.Comment: 6 pages, 1 figure, 1 tabl

A Class of Topological Actions

We review definitions of generalized parallel transports in terms of Cheeger-Simons differential characters. Integration formulae are given in terms of Deligne-Beilinson cohomology classes. These representations of parallel transport can be extended to situations involving distributions as is appropriate in the context of quantized fields.Comment: 41 pages, no figure

Gated communities: Definitions, causes and consequences

Gated communities became an 'object of study' in the 1990s as social scientists observed their growth in several cities; they are now a feature of the urban landscape in most cities around the world. The expansion of gated communities has led to prolific research, examining different aspects of this type of residential development and providing evidence from case studies worldwide. This paper reviews how gated communities are conceptualised according to the literature and identifies the main factors influencing their development. It also considers spatial, economic, political and social consequences of the development of gated communities. These elements should be taken into account by planners and policymakers to minimise their negative impacts and maximise the positive consequences of a residential option that is likely to be part of the urban landscape for a long time

High intensity neutrino oscillation facilities in Europe

The EUROnu project has studied three possible options for future, high intensity neutrino oscillation facilities in Europe. The first is a Super Beam, in which the neutrinos come from the decay of pions created by bombarding targets with a 4 MW proton beam from the CERN High Power Superconducting Proton Linac. The far detector for this facility is the 500 kt MEMPHYS water Cherenkov, located in the Fréjus tunnel. The second facility is the Neutrino Factory, in which the neutrinos come from the decay of μ+ and μ− beams in a storage ring. The far detector in this case is a 100 kt magnetized iron neutrino detector at a baseline of 2000 km. The third option is a Beta Beam, in which the neutrinos come from the decay of beta emitting isotopes, in particular He6 and Ne18, also stored in a ring. The far detector is also the MEMPHYS detector in the Fréjus tunnel. EUROnu has undertaken conceptual designs of these facilities and studied the performance of the detectors. Based on this, it has determined the physics reach of each facility, in particular for the measurement of CP violation in the lepton sector, and estimated the cost of construction. These have demonstrated that the best facility to build is the Neutrino Factory. However, if a powerful proton driver is constructed for another purpose or if the MEMPHYS detector is built for astroparticle physics, the Super Beam also becomes very attractive

Solar irradiance variability: a six-year comparison between SORCE observations and the SATIRE model

Aims: We investigate how well modeled solar irradiances agree with measurements from the SORCE satellite, both for total solar irradiance and broken down into spectral regions on timescales of several years. Methods: We use the SATIRE model and compare modeled total solar irradiance (TSI) with TSI measurements between 2003 and 2009. Spectral solar irradiance over 200-1630nm is compared with the SIM instrument on SORCE between 2004 and 2009 during a period of decline from moderate activity to the recent solar minimum in 10 nm bands and for three spectral regions of significant interest: the UV integrated over 200-300nm, the visible over 400-691nm and the IR between 972-1630 nm. Results: The model captures 97% of observed TSI variation. In the spectral comparison, rotational variability is well reproduced, especially between 400 and 1200 nm. The magnitude of change in the long-term trends is many times larger in SIM at almost all wavelengths while trends in SIM oppose SATIRE in the visible between 500 and 700nm and between 1000 and 1200nm. We discuss the remaining issues with both SIM data and the identified limits of the model, particularly with the way facular contributions are dealt with, the limit of flux identification in MDI magnetograms during solar minimum and the model atmospheres in the IR employed by SATIRE. It is unlikely that improvements in these areas will significantly enhance the agreement in the long-term trends. This disagreement implies that some mechanism other than surface magnetism is causing SSI variations, in particular between 2004 and 2006, if the SIM data are correct. Since SATIRE was able to reproduce UV irradiance between 1991 and 2002 from UARS, either the solar mechanism for SSI variation fundamentally changed around the peak of cycle 23, or there is an inconsistency between UARS and SORCE UV measurements. We favour the second explanation.Comment: 14 pages, 13 figure