Cirrus parameterization from the FIRE ER-2 observations

Primary goals for the FIRE field experiments were validation of satellite cloud retrievals and study of cloud radiation parameters. The radiometers and lidar observations which were acquired from the NASA ER-2 high altitude aircraft during the FIRE cirrus field study may be applied to derive quantities which would be applicable for comparison to satellite retrievals and to define the cirrus radiative characteristics. The analysis involves parameterization of the vertical cloud distribution and relative radiance effects. An initial case study from the 28 Oct. 1986 cirrus experiment has been carried out, and results from additional experiment days are to be reported. The observations reported are for 1 day. Analysis of the many other cirrus observation cases from the FIRE study show variability of results

Lidar and radiometer results from the ER-2 for the FIRE field experiments

The airborne lidar and radiometers which were flown during the FIRE cirrus and marine stratus field experiments had multiple objectives. Cloud parameters of direct interest, such as cirrus infrared emittance or convective scales for marine stratus, may be derived from the observations and analyzed along with the available cloud physics and meteorological observations. Additionally however a stated goal of the FIRE studies was to validate satellite cloud retrievals. To this end a number of derived products are to be available from the basic lidar and radiometer observations. The characteristics of the derived products are described, and in addition analysis results for cloud radiometric and structure parameters are presented. This extended abstract will be used to describe the available data products and the associated presentation will emphasize case study analysis results

Cloud top entrainment instability and cloud top distributions

Classical cloud-top entrainment instability condition formulation is discussed. A saturation point diagram is used to investigate the details of mixing in cases where the cloud-top entrainment instability criterion is satisfied

Sensitivity and fatigue of LiTaO3 for holographic recording

The sensitivity of crystals of LiTaO3 to hologram formation was observed to vary with impurity concentration from a value comparable to the most sensitive doped LiNbO3 for an impure crystal to a value more than five orders of magnitude smaller for a purer crystal. Fatigue effects were observed upon write-erase cycling. These effects were dependent upon writing and erasure polarization and power and could be virtually eliminated by proper choice of optical parameters

The October 27-28, 1986, FIRE cirrus case study: Cloud microstructure

Using aircraft in-situ measurements, the microphysics of cirrus clouds observed on 28 Oct. 1986 during FIRE were examined. Results are presented as one component of a coordinated study of the cirrus on the day. The study contributes to the understanding of cold clouds by: (1) providing microphysical data to supplement satellite and aircraft data for investigating cirrus cloud radiative effects; (2) providing more complete information on ice particle evolution and cloud forcing mechanisms than has been available through the use of instrumentation with higher resolution and more accurate calibration; (3) expanding the knowledge of the particle characteristics in cold liquid water clouds, through improved instrumentation and by making use of sensors on other platforms, such as lidar; and (4) by estimating the ice nucleus concentrations active at low temperatures in the upper troposphere from the concentrations of ice particles in colloidally stable liquid water clouds

Lidar cloud studies for FIRE and ECLIPS

Optical remote sensing measurements of cirrus cloud properties were collected by one airborne and four ground-based lidar systems over a 32 h period during this case study from the First ISCCP (International Satellite Cloud Climatology Program) Regional Experiment (FIRE) Intensive Field Observation (IFO) program. The lidar systems were variously equipped to collect linear depolarization, intrinsically calibrated backscatter, and Doppler velocity information. Data presented describe the temporal evolution and spatial distribution of cirrus clouds over an area encompassing southern and central Wisconsin. The cirrus cloud types include: dissipating subvisual and thin fibrous cirrus cloud bands, an isolated mesoscale uncinus complex (MUC), a large-scale deep cloud that developed into an organized cirrus structure within the lidar array, and a series of intensifying mesoscale cirrus cloud masses. Although the cirrus frequently developed in the vertical from particle fall-streaks emanating from generating regions at or near cloud tops, glaciating supercooled (-30 to -35 C) altocumulus clouds contributed to the production of ice mass at the base of the deep cirrus cloud, apparently even through riming, and other mechanisms involving evaporation, wave motions, and radiative effects are indicated. The generating regions ranged in scale from approximately 1.0 km cirrus uncinus cells, to organized MUC structures up to approximately 120 km across

Visible and near infrared observation on the Global Aerosol Backscatter Experiment (GLOBE)

The Global Aerosol Backscatter Experiment (GLOBE) was intended to provide data on prevailing values of atmospheric backscatter cross-section. The primary intent was predicting the performance of spaceborne lidar systems, most notably the Laser Atmospheric Wind Sounder (LAWS) for the Earth Observing System (EOS). The second and related goal was to understand the source and characteristics of atmospheric aerosol particles. From the GLOBE flights, extensive data was obtained on the structure of clouds and the marine planetary boundary layer. A notable result for all observations is the consistency of the large increases in the aerosol scattering ratio for the marine boundary layer. Other results are noted

Lidar study of storm tops

Satellite thermal and visible observations are routinely used for storm tracking and diagnostics. In recent years attempts have also been made to apply satellite measurements to the study of evolutional factors for storms such as divergence and subsidence mechanisms. These studies involve analysis of the thermal height structure of the storm tops as obtained from the satellite observations. An outstanding problem is the importance of emissivity effects for the interpretation of the storm top thermal radiance measurements. In part to understand the correct interpretation of satellite observations, a storm top observation experiment involving advanced instrumentation on board a high altitude NASA aircraft has been in progress. A downlooking lidar system is an important part of the instrument complement. A combined analysis of the lidar return data and thermal radiance measurements was developed to study cloud top emissivity effects and their relation to satellite observations. Some preliminary conclusions are given

Cirrus microphysics and radiative transfer: Cloud field study on October 28, 1986

The radiative properties of cirrus clouds present one of the unresolved problems in weather and climate research. Uncertainties in ice particle amount and size and, also, the general inability to model the single scattering properties of their usually complex particle shapes, prevent accurate model predictions. For an improved understanding of cirrus radiative effects, field experiments, as those of the Cirrus IFO of FIRE, are necessary. Simultaneous measurements of radiative fluxes and cirrus microphysics at multiple cirrus cloud altitudes allows the pitting of calculated versus measured vertical flux profiles; with the potential to judge current cirrus cloud modeling. Most of the problems in this study are linked to the inhomogeneity of the cloud field. Thus, only studies on more homogeneous cirrus cloud cases promises a possibility to improve current cirrus parameterizations. Still, the current inability to detect small ice particles will remain as a considerable handicap

Observations of Antarctic Polar Stratospheric Clouds by Geoscience Laser Altimeter System (GLAS)

Polar Stratospheric Clouds (PSCs) frequently occur in the polar regions during winter and are important because they play a role in the destruction of stratospheric ozone. During late September and early October 2003, GLAS frequently observed PSCs over western Antarctica. At the peak of this activity on September 29 and 30 we investigate the vertical structure and extent, horizontal coverage and backscatter characteristics of the PSCs using the GLAS data. The PSCs were found to cover an area approximately 10 to 15 % of the size of Antarctica in a region where enhanced PSC frequency has been noted by previous PSC climatology studies. The area of PSC formation was found to coincide with the coldest temperatures in the lower stratosphere. In addition, extensive cloudiness was seen within the troposphere below the PSCs indicating that tropospheric disturbances might have played a role in their formation