10,969 research outputs found
Recommended from our members
The measurement of very low conductivity and dielectric loss in XLPE cables: A possible method to detect degradation due to thermal aging
The dielectric response of crosslinked polyethylene (XLPE) insulated, miniature power cables, extruded with inner and outer semicons, was measured over the frequency range 10-4 to 104 Hz at temperatures from 20 to 100 °C. A dielectric spectrometer was used for the frequency range 10-4 to 10-2 Hz. A bespoke noise-free power supply was constructed and used to measure the dc conductivity and, using a Fourier transform technique, it was also used to measure the very low dielectric tanδ losses encountered at frequencies of 1 to 100 Hz. Tanδ measurements of <;10-5 were found in this frequency range and attributed to a β-mode dielectric relaxation lying above 100 Hz due to motion of chain segments in the amorphous region and an β-mode relaxation lying below 1 Hz window due to twists of chains in the crystal lamellae. The dc conductivity measurements were consistent with those of the dielectric spectrometer and indicate lower dc conductivities in vacuum degassed cables than have been previously reported for XLPE (less than 10-17 S.m-1). The conduction process is thermally activated with an activation energy of approximately 1.1 eV. Higher conductivities were found for non-degassed cables. A transformer ratio bridge was used for measurements in the range 1 to 10 kHz; loss in this region was shown to be due to the series resistance of the semicon layers. Thermal ageing of the cables at 135 °C for 60 days caused significant increases in the conductivity and tanδ and it is considered that such measurements may be a sensitive way of measuring electrical degradation due to thermal aging
On the chemical composition of L-chondrites
Radiochemical neutron activation analysis of Ag, As, Au, Bi, Co, Cs, Ga, In, Rb, Sb, Te, Tl, and Zn and major element data in 14 L4-6 and 3 LL5 chondrites indicates that the L group is unusually variable and may represent at least 2 subgroups differing in formation history. Chemical trends in the S/Fe rich subgroup support textural evidence indicating late loss of a shock formed Fe-Ni-S melt; the S/Fe poor subgroup seemingly reflects nebular fractionation only. Highly mobile In and Zn apparently reflect shock induced loss from L chondrites. However, contrasting chemical trends in several L chondrite sample sets indicate that these meteorites constitute a more irregular sampling of, or more heterogeneous parent material than do carbonaceous or enstatite chondrites. Data for 15 chondrites suggest higher formation temperatures and/or degrees of shock than for LL5 chondrites
Recommended from our members
Influence of semicon shields on the dielectric loss of XLPE cables
Dielectric response measurement techniques in both time and frequency domains are studied in order to measure the dielectric loss of XLPE cables, which have very low losses. A high sensitivity transformer ratio bridge system, which can measure loss tangents as low as 10-5, has been developed with the ability to measure these cables. A tuned amplifier was designed to help to extend the frequency range from 200Hz to 20kHz. Different model cables from Borealis AB with different semiconducting materials have been measured in the temperature range 15⁰C to 120⁰C. It is found that the semiconducting layers dominate the dielectric loss in the insulation system of the XLPE cables, when the outer semicon is treated as measuring electrode. In this case, steadily increasing dielectric loss has been measured at higher frequencies. The resistivity of the semiconducting materials was measured, which confirmed that the increasing slope is due to the semiconducting layers. After using conductive tapes to wrap the cable samples, monotonically decreasing losses were measured, corresponding to the actual dielectric frequency response of the XLPE cables. It is concluded that the axial resistance of semiconducting shields have a substantial influence on the dielectric loss of XLPE cables, especially for dielectric response in high frequency range. A device on measuring the loss of such cables is presented
How to protect a wind turbine from lightning
Techniques for reducing the chances of lightning damage to wind turbines are discussed. The methods of providing a ground for a lightning strike are discussed. Then details are given on ways to protect electronic systems, generating and power equipment, blades, and mechanical components from direct and nearby lightning strikes
Recommended from our members
Dielectric spectroscopy study of thermally-aged extruded model power cables
“Model” extruded power cables, having a much reduced geometry but using the same extrusion techniques and materials as full-sized cables, have been examined using dielectric spectroscopy techniques to study their thermal ageing effects. Cables insulated with homo-polymer XLPE and co-polymer of XLPE with micron-sized ethylene-butyl-acrylate (EBA) islands were studied by both frequency-domain and time-domain dielectric spectroscopy techniques after accelerated thermal ageing under 135°C for 60 days. In the frequency domain, a frequency response analyzer (FRA) was used to measure the frequency range from 10-4Hz to 1Hz at temperatures from 20°C to 80°C. In the time domain, a special charging/discharging current measurement system was developed to measure the frequencies from 10-1Hz to 102Hz. These techniques were chosen to cope with the extremely low dielectric losses of the model cables. The results are compared with those from new model power cables that were degassed at 80°C for 5 days. Thermal ageing was found to increase the low-frequency conductivity, permittivity and the discharging current. Both homo- and co-polymer cables have substantial increase of dielectric loss after ageing
Recommended from our members
The working practices and clinical experiences of paediatric speech and language therapists: a national UK survey
Background: The majority of speech and language therapists (SLTs) work with children who have speech, language and communication needs. There is limited information about their working practices and clinical experience and their views of how changes to healthcare may impact upon their practice.
Aims: To investigate the working practices and professional experiences of paediatric SLTs working in the UK through an online survey.
Methods & Procedures: The survey was conducted online using Survey Monkey. Therapists were alerted to the survey through the Bulletin of the Royal College of Speech and Language Therapists and by e-mails to national special interest groups.
Outcomes & Results: A total of 516 clinicians completed the survey. A large majority worked in the National Health Service (NHS). A varied pattern of working was revealed. Most worked in several settings and saw a range of clients. A typical clinician spends less than one-quarter of their time giving direct therapy and more than one-quarter training parents and other professionals. Nearly half of respondents felt that their time could be better used. Too little time for direct therapy and the time required for administration emerged as their principal concerns. Most clinicians have specialist knowledge of particular client groups and spend more time with them than do non-specialists. Nevertheless, clients are more likely to be treated by a therapist who does not claim to have specialist knowledge of their condition than by one who does. The only clients for whom this is not the case are those with dysphagia. Eighty per cent of respondents felt that proposed changes to the NHS would not benefit the children they treat and there was widespread concern about cuts and the effects of general practitioner commissioning. Despite this, a large majority expected to remain speech and language therapists 5 years from now.
Conclusions & Implications : This survey provides an overview of the working practices of paediatric speech and language therapists. Its findings have significant implications for training and workforce development in the profession
Slow Quenches Produce Fuzzy, Transient Vortices
We examine the Zurek scenario for the production of vortices in quenches of
liquid in the light of recent experiments. Extending our previous
results to later times, we argue that short wavelength thermal fluctuations
make vortices poorly defined until after the transition has occurred. Further,
if and when vortices appear, it is plausible that that they will decay faster
than anticipated from turbulence experiments, irrespective of quench rates.Comment: 4 pages, Revtex file, no figures Apart from a more appropriate title,
this paper differs from its predecessor by including temperature, as well as
pressure, quenche
- …
