Quantitative determination of stratospheric aerosol characteristics

There are no author-identified significant results in this report

Analysis problems of multispectral scanner data

There are no author-identified significant results in this report

Quantitative determination of stratospheric aerosol characteristics

There are no author-identified significant results in this report

Microdensitometer scanning of SL3 S190 imagery and accompanying step wedges

There are no author-identified significant results in this report

Quantitative determination of stratospheric aerosol characteristics

There are no author-identified significant results in this report

Characterization of reflected light from the space power system

Sunlight reflected off large space structures is examined. To assure that this illumination does not exceed the irradiance tolerances of the eye, reflections from these satellites must be controlled by vehicle orientation and surface specifications. The components of various space power system vehicles to determine the reflectances which will significantly contribute to the ground illumination are evaluated. Calculations of reflected solar intensity from various satellite system elements requires description of the elements and of the geometry potential reflectance paths. Surface intensity and the conditions under which it will illuminate a portion of the Earth are also determined

A control design for linear-time-delay systems

One outcome of a PhD project (David Tingey). Industrial systems which involve time delays are difficult to control in general. In addition, the presence of a time-delay may make a control loop unstable. In this work, a new stability criterion and control law is provided to control a class of time delay systems with delay in the state. The result has been applied to a mechanical system and can also be applied to flight and marine control. This work was done as a joint collaboration with Leeds Metropolitan University. This work is supported by the EPSRC case PhD studentship

Population Dynamics and Clonal Comparisons of Cowpea Aphid (Homoptera: Aphididae) on Resistant and Susceptible Cowpea Cultivars

Survivorship, growth, and reproductive performance of cowpea aphid, Aphis craccivora Koch, were studied on whole plants and excised plant tissues of aphid-resistant (‘ICV-12') and aphid-susceptible (‘ICV-1') cultivars of cowpea, Vigna unguiculata (L.) Walp. In a greenhouse study, clonal populations derived from individuals that were originally collected from 5 different locations were studied on plants of the 2 cultivars to assess possible development of aphid biotypes. In the laboratory, performance of 1 clone was studied on excised leaves, flowers, and pods to assess tissue localization and effect of injury on ICV-12 resistance. Aphid life table parameters measured included survivorship, reproductive period, intrinsic rate of increase, net rate of reproduction, number of generations and generation time. Aphid reproductive performance and life table parameters were significantly reduced on seedlings and excised tissues of ICV-12 plants compared with ICV-1. Survivorship, intrinsic rate of increase and net rate of reproduction of populations were most adversely affected. Antibiosis appeared to contribute to aphid resistance in ICV-12. Effects of excised ICV-12 foliage were stronger than those of flowers or pods. Thus, the resistant factor in ICV-12 apparently was based in seedling foliage. However, there were no differences among excised tissues of ICV-1. Trends in the results indicated that there was no variability among the different populations in their demographic statistics on each cultivar. Thus, there did not seem to be biotype development or breakdown of ICV-12 resistance in any of the A. craccivora population

Effects of infestation by cowpea aphid (Homoptera: Aphididae) on different growth stages of resistant and susceptible cowpea cultivars

Field studies were conducted to characterise the effects of infestations by adult and nymphal stages of cowpea aphid, Aphis craccivora Koch, on the growth and yield of cowpea, Vigna unguiculata (L.) Walp. Seedling, flowering, and podding stage plants of aphid-resistant (cv. ICV-12) and aphid-susceptible (cv. ICV-1) cowpea cultivars were used in the studies. Four treatments (consisting of infestations with adult and nymphal aphids, caged controls and uncaged controls) were administered on plants for 22 days post-treatment. Eight parameters of crop success were measured: extended leaf heights (ELH); plant mortality; incidence of sooty mould; incidence and abundance of natural enemy species; crop growth parameters (net assimilation rate, [NAR] in g/ dm2/day, and crop growth rate [CGR] in g/dm2 land surface/day); and plant yields (seeds per pod, weight per seed). Data were analysed using analysis of variance (ANOVA), orthogonal contrasts and 95% confidence intervals (C.I.). There were no significant (P > 0.05) differences between adult and nymphal infestations or between caged and uncaged controls, so the respective sets of data were combined for comparisons of aphid infestations with control treatments. Infestations caused severe plant stunting and other growth deformities, drastic yield reductions, higher plant mortality, greater incidence of natural enemies and abundance of Cheilomenes spp. on cv. ICV-1 than on cv. ICV-12, and on infested and uninfested plants. Aphid infestations did not significantly affect the incidence of sooty mould on plants of cv. ICV-12 or cv. ICV-